-
Investigation of the titanium alloy turning process with prime a tools under high-pressure cooling conditionsStruzikiewicz, GrzegorzWhen turning titanium alloys, it is difficult to ensure the required quality with maximum machining efficiency. A typical problem in the turning process of titanium alloys is to achieve effective ... breaking and removal of chips from the machining zone. The combination of the new construction of cutting tools and machining methods in the machining of titanium alloys increases the efficiency of the machining. For this reason, the use of tools typical for the Prime Turning method in combination with the high-pressure cooling (HPC) method was analysed. The longitudinal turning of the Ti6Al4V ELI titanium alloy was performed using Sandvik Coromant grade 1115 carbide tools. An increase in the pressure of the cutting fluid to p = 70 bar was used. Measurements of the components of the total cutting force for finishing machining with variable cutting parameters in the range of: feed rates f = <0.1;0.4> mm/rev, cutting depth ap = <0.25;1.0> mm and cutting speed vc = <40;80> m/min were performed. It has been shown that the values of cutting force are mainly dependent on the feed and the depth of cut. An analysis of the forms of chips obtained is presented. The dependence of the applied cutting parameters on the value of the chip breakage coefficient Cch was determined. The method of searching for the maximum efficiency of the turning process was determined, taking into account the desired value of the chip breakage coefficient.Source: Strojniški vestnik = Journal of mechanical engineering. - ISSN 0039-2480 (Vol. 70, no. 1/2, Jan.-Feb. 2024, str. 70-79)Type of material - article, component part ; adult, seriousPublish date - 2024Language - englishCOBISS.SI-ID - 187345923
Author
Struzikiewicz, Grzegorz
Topics
turning |
titanium alloys |
cutting forces |
chip form |
chip breakage index |
struženje |
orodja Prime A |
titanove zlitine |
Ti6Al4V |
rezalne sile |
oblika odrezka |
indeks lomljenja odrezkov
![loading ... loading ...](themes/default/img/ajax-loading.gif)
source: Strojniški vestnik = Journal of mechanical engineering. - ISSN 0039-2480 (Vol. 70, no. 1/2, Jan.-Feb. 2024, str. 70-79)
![loading ... loading ...](themes/default/img/ajax-loading.gif)
![loading ... loading ...](themes/default/img/ajax-loading.gif)
![loading ... loading ...](themes/default/img/ajax-loading.gif)
Shelf entry
Permalink
- URL:
Impact factor
Access to the JCR database is permitted only to users from Slovenia. Your current IP address is not on the list of IP addresses with access permission, and authentication with the relevant AAI accout is required.
Year | Impact factor | Edition | Category | Classification | ||||
---|---|---|---|---|---|---|---|---|
JCR | SNIP | JCR | SNIP | JCR | SNIP | JCR | SNIP |
Select the library membership card:
DRS, in which the journal is indexed
Database name | Field | Year |
---|
Links to authors' personal bibliographies | Links to information on researchers in the SICRIS system |
---|---|
Struzikiewicz, Grzegorz | ![]() |
Select pickup location:
Material pickup by post
Notification
Subject headings in COBISS General List of Subject Headings
Select pickup location
Pickup location | Material status | Reservation |
---|
Please wait a moment.