The correlation of molecular neuroimaging and behavior studies in preclinical PET imaging is of major interest to unlock progress in the understanding of brain processes and assess the validity of ...preclinical studies in drug development. However, fully achieving this ambition requires performing molecular images of awake and freely moving animals, whereas most of the preclinical imaging procedures are currently performed under anesthesia. To overcome this issue, the MAPSSIC project aims to develop a pixelated intracerebral probe to be implanted into awake and freely moving rats. The aforementioned probe relies on IMIC (Imageur Moléculaire Intra Cérébral), a Monolithic Active Pixel Sensor (MAPS) prototype set to directly detect positrons. The IMIC sensors were produced in 5 different configurations. Measurements using a 204Tl source showed that the sensor parameters can be optimized to boost its performance allowing to increase the sensitivity and reduce the average cluster size. In addition, comparisons between sensor configurations show a clear gain provided by the introduction of CMOS process modifications. Finally, the choice of the optimal sensor configuration will depend on the expected in vivo conditions.
Full text
Available for:
GEOZS, IJS, IMTLJ, KILJ, KISLJ, NUK, OILJ, PNG, SAZU, SBCE, SBJE, UL, UM, UPCLJ, UPUK
The ultra-thin and highly granular CMOS Monolithic Active Pixel Sensors (MAPS) are typically optimized for high rate high precision tracking, which implies the use of a very thin active medium and ...digital readout. Both features hamper using the devices for identifying low momentum particles by means of dE/dx. Still, MAPS feature charge sharing and typically clusters of more than one fired pixel per impinging particles are formed. It was previously shown that the number of fired pixels per cluster scales with the dE/dx, which allowed identifying highly ionizing nuclear fragments 1. Assuming a sufficiently strong response to different dE/dx, this approach could also be considered for distinguishing minimum ionizing particles (MIP) from light fragments like alpha particles in tracking detectors. In this work, we study this response with particle beams with a dE/dx of up to four times the ones of MIPs, for non-irradiated and irradiated chips, with different sensing nodes as implemented in the MIMOSIS-1 prototype used for the vertex detector of the CBM experiment.
Full text
Available for:
GEOZS, IJS, IMTLJ, KILJ, KISLJ, NLZOH, NUK, OILJ, PNG, SAZU, SBCE, SBJE, UILJ, UL, UM, UPCLJ, UPUK, ZAGLJ, ZRSKP
3.
The DMAPS upgrade of the Belle II vertex detector Babeluk, M.; Barbero, M.; Baudot, J. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
07/2024, Volume:
1064
Journal Article
Peer reviewed
The Belle II experiment at KEK in Japan considers an upgrade for the vertex detector system in line with the accelerator upgrade for higher luminosity at long shutdown 2 planned for 2028.
One ...proposal for the upgrade of the vertex detector called VTX aims to improve background robustness and reduce occupancy using small and fast pixels. VTX accommodates the OBELIX depleted monolithic active CMOS pixel sensor (DMAPS) on all five proposed layers. OBELIX is specifically developed for the VTX application and based on the TJ-Monopix2 chip initially developed to meet the requirements of the outer layers of the ATLAS inner tracker (ITk).
This paper will review recent tests of the TJ-Monopix2 chip as well as various design aspects of the OBELIX-1 chip currently under development.
Full text
Available for:
GEOZS, IJS, IMTLJ, KILJ, KISLJ, NLZOH, NUK, OILJ, PNG, SAZU, SBCE, SBJE, UILJ, UL, UM, UPCLJ, UPUK, ZAGLJ, ZRSKP
Abstract
The Belle II experiment at KEK in Japan considers upgrading its vertex detector system to
address the challenges posed by high background levels caused by the increased luminosity of the
...SuperKEKB collider. One proposal for upgrading the vertex detector aims to install a 5-layer all
monolithic pixel vertex detector based on fully depleted CMOS sensors in 2027. The new system will
use the OBELIX MAPS chips to improve background robustness and reduce occupancy levels through
small and fast pixels. This causes better track finding, especially for low transverse momenta
tracks. This text will focus on the predecessor of the OBELIX sensor, the TJ-Monopix2, presenting
laboratory and test beam results on pixel response, efficiency, and spatial resolution.
Depletion of the sensitive volume for semiconductor based detectors is a key to achieve high performance. It is for instance required for charged particle detection in highly radiative environment ...and for X-ray spectroscopy.PIPPER-2 is a CMOS pixel sensor featuring an architecture that allows the application of the reverse bias of the pn junction from the frontside (cathode), on the electronic side, without process modification. Biasing voltages up to 45 V have been applied to sensor prototypes fabricated on two different high resistivity substrates: a thin epitaxial layer (1 kΩ cm) and a 40 μm thick bulk substrate (600 Ω cm).Calculations from a simplified analytical model and 3D-TCAD simulations were conducted to predict the evolution of the depletion depth with the bias voltage. These expectations were compared to measurements of PIPPER-2 illuminated with two X-ray energies.We conclude that the frontside biasing method allows the full-depletion of the thin epitaxial layer. In contrast, depletion of the bulk substrate reaches about half-depth but X-rays are still detected over the full depth.
The apparatus of the ALICE experiment at CERN will be upgraded in 2017/18 during the second long shutdown of the LHC (LS2). A major motivation for this upgrade is to extend the physics reach for ...charmed and beauty particles down to low transverse momenta. This requires a substantial improvement of the spatial resolution and the data rate capability of the ALICE Inner Tracking System (ITS). To achieve this goal, the new ITS will be equipped with 50μm thin CMOS Pixel Sensors (CPS) covering either the three innermost layers or all the 7 layers of the detector. The CPS being developed for the ITS upgrade at IPHC (Strasbourg) is derived from the MIMOSA 28 sensor realised for the STAR-PXL at RHIC in a 0.35μm CMOS process. In order to satisfy the ITS upgrade requirements in terms of readout speed and radiation tolerance, a CMOS process with a reduced feature size and a high resistivity epitaxial layer should be exploited. In this respect, the charged particle detection performance and radiation hardness of the TowerJazz0.18μm CMOS process were studied with the help of the first prototype chip MIMOSA 32. The beam tests performed with negative pions of 120GeV/c at the CERN-SPS allowed to measure a signal-to-noise ratio (SNR) for the non-irradiated chip in the range between 22 and 32 depending on the pixel design. The chip irradiated with the combined dose of 1MRad and 1013neq/cm2 was observed to yield an SNR ranging between 11 and 23 for coolant temperatures varying from 15°C to 30°C. These SNR values were measured to result in particle detection efficiencies above 99.5% and 98% before and after irradiation, respectively. These satisfactory results allow to validate the TowerJazz0.18μm CMOS process for the ALICE ITS upgrade.
Full text
Available for:
GEOZS, IJS, IMTLJ, KILJ, KISLJ, NUK, OILJ, PNG, SAZU, SBCE, SBJE, UL, UM, UPCLJ, UPUK
Abstract Early measurements on monolithic pixel sensor prototypes in the TPSCo 65 nm technology indicate a different response and radiation tolerance (up to 5×10 15 1 MeV n eq cm) for different ...sensor layout and process variants, illustrating the importance of layout and process in the path towards increased sensor radiation tolerance. Using these measurement results, TCAD simulations provide more insight to link the macroscopic behaviour of specific sensor variants to the details of its structure. With this insight we can propose a new variant combining the advantages of several measured variants as a path to even better radiation tolerance for the next iteration.
From vertex detectors to inner trackers with CMOS pixel sensors Besson, A.; Pérez, A. Pérez; Spiriti, E. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
02/2017, Volume:
845
Journal Article
Peer reviewed
Open access
The use of CMOS Pixel Sensors (CPS) for high resolution and low material vertex detectors has been validated with the 2014 and 2015 physics runs of the STAR-PXL detector at RHIC/BNL. This opens the ...door to the use of CPS for inner tracking devices, with 10-100 times larger sensitive area, which require therefore a sensor design privileging power saving, response uniformity and robustness. The 350nm CMOS technology used for the STAR-PXL sensors was considered as too poorly suited to upcoming applications like the upgraded ALICE Inner Tracking System (ITS), which requires sensors with one order of magnitude improvement on readout speed and improved radiation tolerance. This triggered the exploration of a deeper sub-micron CMOS technology, Tower-Jazz 180nm, for the design of a CPS well adapted for the new ALICE-ITS running conditions. This paper reports the R & D results for the conception of a CPS well adapted for the ALICE-ITS.
Full text
Available for:
GEOZS, IJS, IMTLJ, KILJ, KISLJ, NUK, OILJ, PNG, SAZU, SBCE, SBJE, UL, UM, UPCLJ, UPUK
Abstract The SuperKEKB collider will undergo a major upgrade to reach the target luminosity of 6 × 10 35 cm -2 s -1 during the long shutdown (LS2) foreseen to start around year 2027. We are ...developing a new vertex detector (VTX) to replace the current one (VXD). This new pixel silicon tracker aims to be both more robust against the higher level of machine background and more performant in terms of precision on the decay vertices and standalone track finding efficiency. The baseline layout consists of two layers composing the inner part (iVTX) and three outer layers (oVTX), all arranged in a barrel-shaped geometry, with minimal material budget. All layers will be equipped with dedicated depleted monolithic active CMOS pixel sensors (DMAPS) named OBELIX, designed in the TowerJazz 180 nm technology. This paper will review all the aspects of the project: the detector specifications and the baseline design, the expected improved performance, the OBELIX features and its design status, including the tests of the forerunner chip TJ-Monopix2, and the fabrication and tests for the iVTX and oVTX ladder prototypes.
Ion beam therapy enables a highly accurate dose conformation delivery to the tumor due to the finite range of charged ions in matter (i.e. Bragg peak (BP)). Consequently, the dose profile is very ...sensitive to patients anatomical changes as well as minor mispositioning, and so it requires improved dose control techniques. Proton interaction vertex imaging (IVI) could offer an online range control in carbon ion therapy. In this paper, a statistical method was used to study the sensitivity of the IVI technique on experimental data obtained from the Heidelberg Ion-Beam Therapy Center. The vertices of secondary protons were reconstructed with pixelized silicon detectors. The statistical study used the χ2 test of the reconstructed vertex distributions for a given displacement of the BP position as a function of the impinging carbon ions. Different phantom configurations were used with or without bone equivalent tissue and air inserts. The inflection points in the fall-off region of the longitudinal vertex distribution were computed using different methods, while the relation with the BP position was established. In the present setup, the resolution of the BP position was about 4-5 mm in the homogeneous phantom under clinical conditions (106 incident carbon ions). Our results show that the IVI method could therefore monitor the BP position with a promising resolution in clinical conditions.
PDF
