The effect of particulate matter (PM) on health increases with exposure duration but the change from short to longer term is not well studied. We examined the exposure to PM smaller 10 μm (PM
10
) ...from short to longer duration and their associations with levels of inflammatory markers in the population-based CoLaus cohort in Lausanne, Switzerland. Baseline and follow-up CoLaus data were used to study the associations between PM
10
exposure and inflammatory markers, including the high-sensitivity C-reactive protein (CRP), as well as interleukin 1-beta (IL-1β), interleukin 6 (IL-6), and tumor-necrosis-factor alpha (TNF-α) using mixed models. Exposure was determined for each participant’s home address from hourly air quality simulations at a 5-m resolution. Short-term exposure intervals were 1 day, 1 week, and 1 month prior to the hospital visit (blood withdrawal); long-term exposure intervals were 3 and 6 months prior to the visit. In most time windows, IL-6, IL-1β, and TNF-α were positively associated with PM
10
. No significant associations were identified for CRP. Adjusted associations with long-term exposures were stronger and more significant than those for short-term exposures. In stratified models, gender, age, smoking status, and hypertension only led to small modifications in effect estimates, though a few of the estimates for IL-6 and TNF-α became non-significant. In this general adult cohort exposed to relatively low average PM
10
levels, clear associations with markers of systemic inflammation were observed. Longer duration of elevated exposure was associated with an exacerbated inflammatory response. This may partially explain the elevated disease risk observed with chronic PM
10
exposure. It also suggests that reducing prolonged episodes of high PM exposure may be a strategy to reduce inflammatory risk.
Aiming for increased nickel and lower cobalt content in layered transition metal oxide cathodes (NCM) is a feasible strategy for achieving increased energy density and cost competitiveness in ...commercial lithium‐ion batteries. However, the practical long‐term cycling of NCM cathodes suffers from severe capacity degradation due to irreversible interface phase transformation and unavoidable crack formation. Herein, an in situ modification strategy is used to form a uniform and conformal Li1.8Sc0.8Ti1.2(PO4)3 (LSTP) protective layer by interconnecting the single‐crystal‐layered LiNi0.6Co0.1Mn0.3O2 (SC‐NCM) particles. LSTP surface modification helps to construct a robust cathode‐electrolyte interphase thin film between the cathode and the electrolyte, which can prevent SC‐NCM corrosion by electrolyte, and the stability of the mechanics can improve the intergranular cracks caused by long cycles under harsh conditions. Moreover, the LSTP conductive modification layer facilitates the lithium‐ion transport among cathode particles, effectively enhancing the rate capability. Impressively, the LSTP modified SC‐NCM exhibits a high reversible capacity of 144.3 mAh g−1 at the high discharge rate of 5 C and maintains a capacity retention of 90.27% even at the ultrahigh charge voltage of 4.6 V operation after 500 cycles. Moreover, in a pouch‐type full battery, the graphite/LSTP modified SC‐NCM maintains a capacity retention of 89.6% after 1700 cycles.
An innovative surface modification is developed to improve the long‐term cyclability and rate capability of a single‐crystalline Ni‐rich cathode. The surface modification strategy improves the mechanical stability and lithium‐ion transport, which creates a strong CEI interface to prevent electrolyte corrosion and improve the intergranular cracks caused by long cycles under harsh conditions.
Full text
Available for:
BFBNIB, FZAB, GIS, IJS, KILJ, NLZOH, NUK, OILJ, SAZU, SBCE, SBMB, UL, UM, UPUK
Individuals with asymptomatic or mild coronavirus disease 2019 (COVID-19) have been reported to frequently transmit the disease even without direct contact. The severe acute respiratory syndrome ...coronavirus 2 has been found at very high concentrations in swab and sputum samples from such individuals.
To estimate the virus levels released from individuals with asymptomatic to moderate COVID-19 into different aerosol sizes by normal breathing and coughing, and to determine what exposure could result from this in a room shared with such individuals.
This mathematical modeling study combined the size-distribution of exhaled breath microdroplets for coughing and normal breathing with viral swab and sputum concentrations as approximation for lung lining liquid to obtain an estimate of emitted virus levels. Viral data were obtained from studies published as of May 20, 2020. The resulting emission data fed a single-compartment model of airborne concentrations in a room of 50 m3, the size of a small office or medical examination room.
Modeling was used to estimate the viral load emitted by individuals breathing normally or coughing, and the concentrations expected in the simulated room at different ventilation rates.
The mean estimated viral load in microdroplets emitted by simulated individuals while breathing regularly was 0.0000049 copies/cm3, with a range of 0.0000000049 to 0.637 copies/cm3. The corresponding estimates for simulated coughing individuals were a mean of 0.277 copies/cm3 per cough, with a range of 0.000277 to 36 030 copies/cm3 per cough. The estimated concentrations in a room with an individual who was coughing frequently were very high, with a maximum of 7.44 million copies/m3 from an individual who was a high emitter. However, regular breathing from an individual who was a high emitter was modeled to result in lower room concentrations of up to 1248 copies/m3.
In this modeling study, breathing and coughing were estimated to release large numbers of viruses, ranging from thousands to millions of virus copies per cubic meter in a room with an individual with COVID-19 with a high viral load, depending on ventilation and microdroplet formation process. The estimated infectious risk posed by a person with typical viral load who breathes normally was low. The results suggest that only few people with very high viral load pose an infection risk in poorly ventilated closed environments. These findings suggest that strict respiratory protection may be needed when there is a chance to be in the same small room with an individual, whether symptomatic or not, especially for a prolonged period.
Silver nanowire (AgNW) networks have attracted considerable attention as transparent electrodes for emerging flexible optoelectronics. However, the transference of such networks onto diverse ...arbitrary substrates with high conductivity remains a challenge because of the possibility of detaching and sliding occurring at the interface. Therefore, we developed a water-assisted transfer printing method for the fabrication and transfer of an AgNW-polydimethylsiloxane (PDMS) electrode. This innovative approach exhibits a robust ability for thin film transfer onto arbitrary substrates and has highly controlled and nondestructive characteristics. The obtained electrodes exhibited a high ratio of DC conductivity to optical conductivity of 200, a low sheet resistance of 9 Ω sq-1 at 82%, tensile strain (0% to 50%), and flexibility (bending radius of less than 2 mm) without significant loss of conductivity compared with devices fabricated through conventional methods. Furthermore, we demonstrated a novel textile-based flexible light-emitting electrochemical cell (PLEC) based on the stretchable AgNW-PDMS electrode and buckling concept, thereby realizing highly stretchable PLECs with excellent performance and mechanical robustness. The luminance intensity of the strained device was optimized to 58 cd m-2 at 7 V under 10% linear strain without damaging the electroluminescence properties. Notably, this effective and practical transfer method provides a way to develop electronic nanowire devices with unique configurations and high performances.
Airborne transmission of SARS-CoV-2 is an important route of infection. For the wildtype (WT) only a small proportion of those infected emitted large quantities of the virus. The currently prevalent ...variants of concern, Delta (B1.617.2) and Omicron (B.1.1.529), are characterized by higher viral loads and a lower minimal infective dose compared to the WT. We aimed to describe the resulting distribution of airborne viral emissions and to reassess the risk estimates for public settings given the higher viral load and infectivity.
We reran the Monte Carlo modelling to estimate viral emissions in the fine aerosol size range using available viral load data. We also updated our tool to simulate indoor airborne transmission of SARS-CoV-2 by including a CO2 calculator and recirculating air cleaning devices. We also assessed the consequences of the lower critical dose on the infection risk in public settings with different protection strategies.
Our modelling suggests that a much larger proportion of individuals infected with the new variants are high, very high or super-emitters of airborne viruses: for the WT, one in 1,000 infected was a super-emitter; for Delta one in 30; and for Omicron one in 20 or one in 10, depending on the viral load estimate used. Testing of the effectiveness of protective strategies in view of the lower critical dose suggests that surgical masks are no longer sufficient in most public settings, while correctly fitted FFP2 respirators still provide sufficient protection, except in high aerosol producing situations such as singing or shouting.
From an aerosol transmission perspective, the shift towards a larger proportion of very high emitting individuals, together with the strongly reduced critical dose, seem to be two important drivers of the aerosol risk, and are likely contributing to the observed rapid spread of the Delta and Omicron variants of concern. Reducing contacts, always wearing well-fitted FFP2 respirators when indoors, using ventilation and other methods to reduce airborne virus concentrations, and avoiding situations with loud voices seem critical to limiting these latest waves of the COVID-19 pandemic.
The existing Bouc–Wen models for piezoelectric ceramic actuators (PCAs) possess the symmetrical characteristic of the hysteretic component and can be categorized as symmetrical Bouc–Wen models. When ...modeling PCAs with non-symmetrical hysteresis by a symmetrical Bouc–Wen model, large modeling errors will occur. In this paper, a non-symmetrical Bouc–Wen hysteresis operator for modeling the non-symmetrical hysteresis of PCAs is established by introducing a non-symmetrical formula into the Bouc–Wen hysteresis operator. Accordingly, a non-symmetrical Bouc–Wen model for PCAs is proposed and established by modeling the non-symmetrical hysteresis component of PCAs with the non-symmetrical Bouc–Wen hysteresis operator. A corresponding parameter identification method, which can identify the parameters by obtaining analytical solutions with a set of input–output experimental data to and from a PCA with an applied periodic voltage under the zero initial condition, is established. In the parameter identification, the least-squares method is used to reduce external random disturbances. The performance of the non-symmetrical Bouc–Wen model with the corresponding parameter identification method is experimentally verified by the established experimental setup. The research results show that the non-symmetrical Bouc–Wen model can simulate the PCA with the non-symmetrical hysteresis more accurately than the symmetrical Bouc–Wen models, and the modeling errors are decreased by about 30%. In addition, the established parameter identification method can be used to identify the parameters of the non-symmetrical and symmetrical Bouc–Wen models effectively and quickly.
Full text
Available for:
GEOZS, IJS, IMTLJ, KILJ, KISLJ, NUK, OILJ, PNG, SAZU, SBCE, SBJE, UL, UM, UPCLJ, UPUK
Cardiovascular diseases (CVD) mortality has been shown to follow a seasonal pattern. Several studies suggested several possible determinants of this pattern, including misclassification of causes of ...deaths. We aimed at assessing seasonality in overall, CVD, cancer and non-CVD/non-cancer mortality using data from 19 countries from different latitudes.
Monthly mortality data were compiled from 19 countries, amounting to over 54 million deaths. We calculated ratios of the observed to the expected numbers of deaths in the absence of a seasonal pattern. Seasonal variation (peak to nadir difference) for overall and cause-specific (CVD, cancer or non-CVD/non-cancer) mortality was analyzed using the cosinor function model. Mortality from overall, CVD and non-CVD/non-cancer showed a consistent seasonal pattern. In both hemispheres, the number of deaths was higher than expected in winter. In countries close to the Equator the seasonal pattern was considerably lower for mortality from any cause. For CVD mortality, the peak to nadir differences ranged from 0.185 to 0.466 in the Northern Hemisphere, from 0.087 to 0.108 near the Equator, and from 0.219 to 0.409 in the Southern Hemisphere. For cancer mortality, the seasonal variation was nonexistent in most countries.
In countries with seasonal variation, mortality from overall, CVD and non-CVD/non-cancer show a seasonal pattern with mortality being higher in winter than in summer. Conversely, cancer mortality shows no substantial seasonality.
Full text
Available for:
DOBA, IZUM, KILJ, NUK, PILJ, PNG, SAZU, SIK, UILJ, UKNU, UL, UM, UPUK
As a huge threat to the public health, China's air pollution has attracted extensive attention and continues to grow in tandem with the economy. Although the real-time air quality report can be ...utilized to update our knowledge on air quality, questions about how pollutants evolve across time and how pollutants are spatially correlated still remain a puzzle. In view of this point, we adopt the PMFG network method to analyze the six pollutants' hourly data in 350 Chinese cities in an attempt to find out how these pollutants are correlated temporally and spatially. In terms of time dimension, the results indicate that, except for O3, the pollutants have a common feature of the strong intraday patterns of which the daily variations are composed of two contraction periods and two expansion periods. Besides, all the time series of the six pollutants possess strong long-term correlations, and this temporal memory effect helps to explain why smoggy days are always followed by one after another. In terms of space dimension, the correlation structure shows that O3 is characterized by the highest spatial connections. The PMFGs reveal the relationship between this spatial correlation and provincial administrative divisions by filtering the hierarchical structure in the correlation matrix and refining the cliques as the tinny spatial clusters. Finally, we check the stability of the correlation structure and conclude that, except for PM10 and O3, the other pollutants have an overall stable correlation, and all pollutants have a slight trend to become more divergent in space. These results not only enhance our understanding of the air pollutants' evolutionary process, but also shed lights on the application of complex network methods into geographic issues.
Full text
Available for:
DOBA, IZUM, KILJ, NUK, PILJ, PNG, SAZU, SIK, UILJ, UKNU, UL, UM, UPUK
The appearance of generative adversarial networks (GAN) provides a new approach and framework for computer vision. Compared with traditional machine learning algorithms, GAN works via adversarial ...training concept and is more powerful in both feature learning and representation. GAN also exhibits some problems, such as non-convergence, model collapse, and uncontrollability due to high degree of freedom. How to improve the theory of GAN and apply it to computer-vision-related tasks have now attracted much research efforts. In this paper, recently proposed GAN models and their applications in computer vision are systematically reviewed. In particular, we firstly survey the history and development of generative algorithms, the mechanism of GAN, its fundamental network structures, and theoretical analysis of the original GAN. Classical GAN algorithms are then compared comprehensively in terms of the mechanism, visual results of generated samples, and Frechet Inception Distance. These networks are further evaluated from network construction, performance, and applicability aspects by extensive experiments conducted over public datasets. After that, several typical applications of GAN in computer vision, including high-quality samples generation, style transfer, and image translation, are examined. Finally, some existing problems of GAN are summarized and discussed and potential future research topics are forecasted.
PDF
