We present light yield and uniformity measurements of square and hexagonal tiles read out with silicon photomultipliers via a Y11 wavelength-shifting fiber or directly from the side or from the ...center at the top face. All tiles are 3 mm thick and have an area of 9cm2. The sides are wrapped with two layers of Teflon tape while top and bottom faces are covered with two layers of Tyvec paper. We further show the first light yield and uniformity measurements of ATLAS Tile Calorimeter (TileCal) tiles with MPPC readout. This study has been motivated by looking into a possible phase 3 upgrade for the ATLAS hadron calorimeter and for hadron calorimeters at future hadron colliders.
The gain of silicon photomultipliers (SiPMs) increases with bias voltage and decreases with temperature. To operate SiPMs at stable gain, the bias voltage can be readjusted to compensate for ...temperature changes. We have tested this concept with 30 SiPMs from three manufacturers (Hamamatsu, KETEK and CPTA) operating in a climate chamber at CERN by varying temperatures between 1ˆC and 48ˆC. We built an adaptive power supply that uses a linear dependence of the bias voltage on temperature. We stabilized four SiPMs simultaneously with only one compensation parameter for the readjustment of the bias voltage of four SiPMs. For all tested Hamamatsu and CPTA SiPMs we achieved our goal of limiting gain changes to less than ±0.5% in the 20–30ˆC temperature range.
A highly granular electromagnetic calorimeter with scintillator strip readout is being developed for future linear collider experiments. A prototype of 21.5 X0 depth and 180×180mm2 transverse ...dimensions was constructed, consisting of 2160 individually read out 10×45×3mm3 scintillator strips. This prototype was tested using electrons of 2–32 GeV at the Fermilab Test Beam Facility in 2009. Deviations from linear energy response were less than 1.1%, and the intrinsic energy resolution was determined to be (12.5±0.1(stat.)±0.4(syst.))%∕EGeV⊕(1.2±0.1(stat.)−0.7+0.6(syst.))%, where the uncertainties correspond to statistical and systematic sources, respectively.
Full text
Available for:
GEOZS, IJS, IMTLJ, KILJ, KISLJ, NUK, OILJ, PNG, SAZU, SBCE, SBJE, UL, UM, UPCLJ, UPUK
A LYSO calorimeter for the SuperB factory Eigen, G.; Zhou, Z.; Chao, D. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
08/2013, Volume:
718
Journal Article
Peer reviewed
Open access
The SuperB project is an asymmetric e+e− accelerator of 1036cm−2s−1 design luminosity, capable of collecting a data sample of 50–75ab−1 in five years running. The SuperB electromagnetic calorimeter ...(EMC) provides energy and direction measurement of photons and electrons, and is used for identification of electrons versus other charged particles. In particular we present its design, geometry study and related simulations, as well as R&D on LYSO crystals and developments on readout electronics. A matrix of 25 crystals has been tested at the Beam Test Facility of Frascati (BTF) in May 2011 at energies between 200MeV and 500MeV. Results from this test are presented.
Full text
Available for:
GEOZS, IJS, IMTLJ, KILJ, KISLJ, NUK, OILJ, PNG, SAZU, SBCE, SBJE, UL, UM, UPCLJ, UPUK
We present an update on total and partial branching fractions and on CP asymmetries in the semi-inclusive decay B→Xsℓ+ℓ−. Further, we summarize our results on branching fractions and CP asymmetries ...for semi-inclusive and fully-inclusive B→Xsγ decays. We present the first result on the CP asymmetry difference of charged and neutral B→Xsγ decays yielding the first constraint on the ratio of Wilson coefficients Im(C8eff/C7eff).
Full text
Available for:
GEOZS, IJS, IMTLJ, KILJ, KISLJ, NLZOH, NUK, OILJ, PNG, SAZU, SBCE, SBJE, UILJ, UL, UM, UPCLJ, UPUK, ZAGLJ, ZRSKP
The standard model of particle physics
describes the known fundamental particles and forces that make up our Universe, with the exception of gravity. One of the central features of the standard model ...is a field that permeates all of space and interacts with fundamental particles
. The quantum excitation of this field, known as the Higgs field, manifests itself as the Higgs boson, the only fundamental particle with no spin. In 2012, a particle with properties consistent with the Higgs boson of the standard model was observed by the ATLAS and CMS experiments at the Large Hadron Collider at CERN
. Since then, more than 30 times as many Higgs bosons have been recorded by the ATLAS experiment, enabling much more precise measurements and new tests of the theory. Here, on the basis of this larger dataset, we combine an unprecedented number of production and decay processes of the Higgs boson to scrutinize its interactions with elementary particles. Interactions with gluons, photons, and W and Z bosons-the carriers of the strong, electromagnetic and weak forces-are studied in detail. Interactions with three third-generation matter particles (bottom (b) and top (t) quarks, and tau leptons (τ)) are well measured and indications of interactions with a second-generation particle (muons, μ) are emerging. These tests reveal that the Higgs boson discovered ten years ago is remarkably consistent with the predictions of the theory and provide stringent constraints on many models of new phenomena beyond the standard model.
Full text
Available for:
EMUNI, FIS, FZAB, GEOZS, GIS, IJS, IMTLJ, KILJ, KISLJ, MFDPS, NLZOH, NUK, OILJ, PNG, SAZU, SBCE, SBJE, SBMB, SBNM, UKNU, UL, UM, UPUK, VKSCE, ZAGLJ
7.
Performance of the ATLAS trigger system in 2015 Akerstedt, H.; Alexa, C.; Alexander, G. ...
The European physical journal. C, Particles and fields,
2017, Volume:
77, Issue:
5
Journal Article
Peer reviewed
Open access
During 2015 the ATLAS experiment recorded
3.8
fb
-
1
of proton–proton collision data at a centre-of-mass energy of
13
TeV
. The ATLAS trigger system is a crucial component of the experiment, ...responsible for selecting events of interest at a recording rate of approximately 1 kHz from up to 40 MHz of collisions. This paper presents a short overview of the changes to the trigger and data acquisition systems during the first long shutdown of the LHC and shows the performance of the trigger system and its components based on the 2015 proton–proton collision data.
Full text
Available for:
DOBA, IZUM, KILJ, NUK, PILJ, PNG, SAZU, SIK, UILJ, UKNU, UL, UM, UPUK
The reconstruction of the signal from hadrons and jets emerging from the proton–proton collisions at the Large Hadron Collider (LHC) and entering the ATLAS calorimeters is based on a ...three-dimensional topological clustering of individual calorimeter cell signals. The cluster formation follows cell signal-significance patterns generated by electromagnetic and hadronic showers. In this, the clustering algorithm implicitly performs a topological noise suppression by removing cells with insignificant signals which are not in close proximity to cells with significant signals. The resulting
topological cell clusters
have shape and location information, which is exploited to apply a local energy calibration and corrections depending on the nature of the cluster. Topological cell clustering is established as a well-performing calorimeter signal definition for jet and missing transverse momentum reconstruction in ATLAS.
Full text
Available for:
DOBA, IZUM, KILJ, NUK, PILJ, PNG, SAZU, SIK, UILJ, UKNU, UL, UM, UPUK
The performance of the ATLAS muon trigger system is evaluated with proton-proton (pp) and heavy-ion (HI) collision data collected in Run 2 during 2015–2018 at the Large Hadron Collider. It is ...primarily evaluated using events containing a pair of muons from the decay of Z bosons to cover the intermediate momentum range between 26 GeV and 100 GeV. Overall, the efficiency of the single-muon triggers is about 68% in the barrel region and 85% in the endcap region. The pT range for efficiency determination is extended by using muons from decays of Jψ mesons, W bosons, and top quarks. The performance in HI collision data is measured and shows good agreement with the results obtained in pp collisions. The muon trigger shows uniform and stable performance in good agreement with the prediction of a detailed simulation. Dedicated multi-muon triggers with kinematic selections provide the backbone to beauty, quarkonia, and low-mass physics studies. The design, evolution and performance of these triggers are discussed in detail.
We report on the design, construction and performance of a prototype for a high-granularity tile hadronic calorimeter for a future international linear collider detector. Scintillating tiles are read ...out via wavelength-shifting fibers that guide the scintillation light to a novel photodetector, the silicon photomultiplier. A prototype has been tested using a positron test beam at DESY. The results are compared with a reference prototype calorimeter equipped with multichannel vacuum photomultipliers. Detector calibration, noise, linearity and stability are discussed, and the energy response in a 1–6
GeV positron beam is compared with simulations. The present results demonstrate that the silicon photomultiplier is well-suited as photodetectors in calorimeters and thus has been selected for the construction of a
1
m
3
calorimeter prototype to operate in hadron beams.
Full text
Available for:
GEOZS, IJS, IMTLJ, KILJ, KISLJ, NUK, OILJ, PNG, SAZU, SBCE, SBJE, UL, UM, UPCLJ, UPUK
PDF
