Despite the widespread usage of phthalates and parabens in personal care products (PCPs), little is known about concentrations and profiles as well as human exposure to these compounds through the ...use of PCPs. In this study, nine phthalates and six parabens were determined in 170 PCPs (41 rinse-off and 109 leave-on), including 20 baby care products collected from Albany, New York. Phthalates were less frequently found in rinse-off PCPs but were more frequently found in perfumes (detection frequency of 100% for diethyl phthalate DEP, 67% for dibutyl phthalate DBP), skin toners (90% for DEP), and nail polishes (90% for DBP). Parabens were found in ∼40% of rinse-off products and ∼60% of leave-on products. The highest concentrations of DEP, DBP, methyl- (MeP), ethyl- (EtP), propyl- (PrP), and butyl parabens (BuP) were on the order of 1000 μg per gram of the product. On the basis of amount and frequency of use of PCPs and the measured median concentrations of target analytes, the total dermal intake doses (sum of all phthalates or parabens) were calculated to be 0.37 and 31.0 μg/kg-bw/day for phthalates and parabens, respectively, for adult females. The calculated dermal intake of phthalates from PCPs was lower for infants and toddlers than for adult females. In contrast, dermal intake of parabens from PCPs by infants and toddlers was higher than that for adult females. The calculated maximum daily exposure dose of MeP, EtP, and PrP from PCPs ranged between 58.6 and 766 μg/kg-bw/day for infants and toddlers, which was 3 times higher than that calculated for adult females. PCPs are an important source of human exposure to parabens; the contribution of PCPs to phthalate exposure is low, except for DEP.
Full text
Available for:
IJS, KILJ, NUK, PNG, UL, UM
Taurine, a nonprotein amino acid, is widely distributed in almost all animal tissues. Ingestion of taurine helps to improve obesity and its related metabolic disorders. However, the molecular ...mechanism underlying the protective role of taurine against obesity is not completely understood. In this study, it was found that intraperitoneal treatment of mice with taurine alleviated high-fat diet (HFD)-induced obesity, improved insulin sensitivity, and increased energy expenditure and adaptive thermogenesis of the mice. Meanwhile, administration of the mice with taurine markedly induced the browning of inguinal white adipose tissue (iWAT) with significantly elevated expression of PGC1α, UCP1, and other thermogenic genes in iWAT. In vitro studies indicated that taurine also induced the development of brown-like adipocytes in C3H10T1/2 white adipocytes. Knockdown of PGC1α blunted the role of taurine in promoting the brown-like adipocyte phenotypes in C3H10T1/2 cells. Moreover, taurine treatment enhanced AMPK phosphorylation in vitro and in vivo, and knockdown of AMPKα1 prevented taurine-mediated induction of PGC1α in C3H10T1/2 cells. Consistently, specific knockdown of PGC1α in iWAT of the HFD-fed mice inhibited taurine-induced browning of iWAT, with the role of taurine in the enhancement of adaptive thermogenesis, the prevention of obesity, and the improvement of insulin sensitivity being partially impaired. These results reveal a functional role of taurine in facilitating the browning of white adipose tissue, which depends on the induction of PGC1α. Our studies also suggest a potential mechanism for the protective role of taurine against obesity, which involves taurine-mediated browning of white adipose tissue.
Full text
Available for:
GEOZS, IJS, IMTLJ, KILJ, KISLJ, NLZOH, NUK, OILJ, PNG, SAZU, SBCE, SBJE, UILJ, UL, UM, UPCLJ, UPUK, ZAGLJ, ZRSKP
The abundant use of antibiotics leads to antibiotic residues in frequently consumed foods. Residual antibiotics in food may have adverse effects on humans by directly causing disease via low-dose ...exposure and indirect harm via antibiotic resistance. However, the current methods for antibiotic extraction and analysis in food have not yet formed a uniform standard, and only a few data exist regarding the residual antibiotic condition in various types of foods. Hence, we review the literature since 2008 to summarize analytical methods and residue status of antibiotics in food. Then, we discuss the causes of antibiotic residues in food and the possible hazards to human health. We hope that the joint efforts of the scientific community and political circles will lead to the formation of a unified standard for the extraction and analysis of antibiotics in food, to allow for comprehensive monitoring of residual antibiotics and ensure human health.
Full text
Available for:
IJS, KILJ, NUK, PNG, UL, UM, UPUK
Mixed Pb–In perovskite solar cells are fabricated by using lead(II) chloride and indium(III) chloride with methylammonium iodide. A maximum power conversion efficiency as high as 17.55% is achieved ...owing to the high quality of perovskites with multiple ordered crystal orientations.
Full text
Available for:
BFBNIB, FZAB, GIS, IJS, KILJ, NLZOH, NUK, OILJ, SAZU, SBCE, SBMB, UL, UM, UPUK
3D bioprinting technology provides programmable and customizable platforms to engineer cell‐laden constructs mimicking human tissues for a wide range of biomedical applications. However, the ...encapsulated cells are often restricted in spreading and proliferation by dense biomaterial networks from gelation of bioinks. Herein, a cell‐benign approach is reported to directly bioprint porous‐structured hydrogel constructs by using an aqueous two‐phase emulsion bioink. The bioink, which contains two immiscible aqueous phases of cell/gelatin methacryloyl (GelMA) mixture and poly(ethylene oxide) (PEO), is photocrosslinked to fabricate predesigned cell‐laden hydrogel constructs by extrusion bioprinting or digital micromirror device‐based stereolithographic bioprinting. The porous structure of the 3D‐bioprinted hydrogel construct is formed by subsequently removing the PEO phase from the photocrosslinked GelMA hydrogel. Three different cell types (human hepatocellular carcinoma cells, human umbilical vein endothelial cells, and NIH/3T3 mouse embryonic fibroblasts) within the 3D‐bioprinted porous hydrogel patterns show enhanced cell viability, spreading, and proliferation compared to the standard (i.e., nonporous) hydrogel constructs. The 3D bioprinting strategy is believed to provide a robust and versatile platform to engineer porous‐structured tissue constructs and their models for a variety of applications in tissue engineering, regenerative medicine, drug development, and personalized therapeutics.
An aqueous two‐phase emulsion bioink is developed to create bioprinted porous‐structured hydrogel constructs. Interconnected micropores within the bioprinted hydrogel constructs enhance the growth, spreading, and proliferation of encapsulated living cells.
Full text
Available for:
BFBNIB, FZAB, GIS, IJS, KILJ, NLZOH, NUK, OILJ, SAZU, SBCE, SBMB, UL, UM, UPUK
Soft dielectric elastomer actuators (DEAs) exhibit interesting muscle-like behavior for the development of soft robots. However, it is challenging to model these soft actuators due to their material ...nonlinearity, nonlinear electromechanical coupling, and time-dependent viscoelastic behavior. Most recent studies on DEAs focus on issues of mechanics, physics, and material science, while much less importance is given to quantitative characterization of DEAs. In this paper, we present a detailed experimental investigation probing the voltage-induced electromechanical response of a soft DEA that is subjected to cyclic loading and propose a general constitutive modeling approach to characterize the time-dependent response, based on the principles of nonequilibrium thermodynamics. In this paper, some of the key observations are found as follows: 1) Creep exhibits the drift phenomenon, and is dominant during the first three cycles. The creep decreases over time and becomes less dominant after the first few cycles; 2) a significant amount of hysteresis is observed during all cycles and it becomes repeatable after the first few cycles; 3) the peak of the displacement is shifted from the peak of the voltage signal and occurs after it. To account for these viscoelastic phenomena, a constitutive model is developed by employing several dissipative nonequilibrium mechanisms. The quantitative comparisons of the experimental and simulation results demonstrate the effectiveness of the developed model. This modeling approach can be useful for control of a viscoelastic DEA and paves the way to emerging applications of soft robots.
A gallium arsenide (GaAs)-based millimeter-wave broadband bandpass filter (BPF) is proposed based on slotted half-mode substrate integrated waveguide (HMSIW) spoof surface plasmon polaritons (SSPPs). ...The center frequency and bandwidth of this SSPP-based on-chip BPF can be easily controlled by tuning the geometry dimensions of the SSPP unit cell, which is attributed to its unique dispersion characteristics. For demonstration, a prototype of the proposed BPF is fabricated and experimentally characterized, with good agreement between the simulated and measured results. Due to the ability of the strong electric field confinement, the proposed on-chip SSPP structure has lower coupling feature with closely-spaced transmission line circuits than its counterpart traditional HMSIW structure.
Our previous studies showed that populations in China are widely exposed to phthalates and parabens. Nevertheless, sources of Chinese exposure to phthalates and parabens are not well understood. In ...this study, we measured concentrations of nine phthalates and six parabens in five categories of personal care products (PCPs, N = 52) collected from Tianjin, China, and estimated human exposure doses to these compounds. The most frequently detected phthalates and parabens in PCPs were diethyl phthalate (DEP) (detection frequency 54 %), methyl paraben (MeP), and n-propyl paraben (PrP) (~75 %). The concentrations of DEP in PCPs ranged from not detected (ND; <0.1 μg/g) to 937 μg/g. The highest concentrations of MeP and PrP were 2,826 and 1,564 μg/g, respectively. Median exposure dose to parabens through dermal application of PCPs in China was estimated at 18,700 μg/d, which was two orders of magnitude greater than that calculated for phthalates (45.5 μg/d). Hand and body lotions were the major contributors to exposures, and the daily exposure doses for DEP, MeP, and PrP from these products were 38.4, 10,200 and 4,890 μg, respectively.
Antibiotic resistance is a global health crisis linked to increased, and often unrestricted, antibiotic use in humans and animals. As one of the world's largest producers and consumers of ...antibiotics, China is witness to some of the most acute symptoms of this crisis. Antibiotics and antibiotic resistance genes (ARGs) are widely distributed in surface water, sewage treatment plant effluent, soils and animal wastes. The emergence and increased prevalence of ARGs in the clinic/hospitals, especially carbapenem-resistant gram negative bacteria, has raised the concern of public health officials. It is important to understand the current state of antibiotic use in China and its relationship to ARG prevalence and diversity in the environment. Here we review these relationships and their relevance to antimicrobial resistance (AMR) trends witnessed in the clinical setting. This review highlights the issues of enrichment and dissemination of ARGs in the environment, and also future needs in mitigating the spread of antibiotic resistance in the environment, particularly under the ‘planetary health’ perspective, i.e., the systems that sustain or threaten human health.
Display omitted
•Antibiotics and ARGs are widely distributed in environment media in China.•Antibiotic resistance varies geographically in China.•Strategies to mitigate the spread of antibiotic resistance are suggested.
Full text
Available for:
GEOZS, IJS, IMTLJ, KILJ, KISLJ, NLZOH, NUK, OILJ, PNG, SAZU, SBCE, SBJE, UL, UM, UPCLJ, UPUK, ZRSKP
Because of volatilization and leaching from their application in consumer and personal care products, phthalate esters are ubiquitous contaminants in the indoor environment. In this study, we ...measured concentrations and profiles of 9 phthalate esters in indoor dust samples collected from six cities in China (n = 75). For comparison, we also analyzed samples collected from Albany, New York, USA (n = 33). The results indicated that concentrations, except for dicyclohexyl phthalate (DCHP) and bis(2-ethylhexyl) phthalate (DEHP), and profiles of phthalate esters varied significantly between the two countries. Concentrations of diethyl phthalate (DEP), di-n-hexyl phthalate (DNHP), and benzyl butyl phthalate (BzBP) were 5 to 10 times higher in dust samples collected from Albany than those from the Chinese cities. In contrast, concentrations of di-iso-butyl phthalate (DIBP) in dust samples from Albany were 5 times lower than those from the Chinese cities. We estimated the daily intake (DI) of phthalate esters through the routes of dust ingestion and dermal dust absorption. The extent of contribution of indoor dust to human exposures varied, depending on the type of phthalate esters. The contribution of dust to DEHP exposure was 2−5% and 10−58% of the estimated total DIs in China and the USA, respectively. On the basis of the estimates of total DIs of phthalates, extrapolated from urinary metabolite concentrations, the contributions of inhalation, dermal absorption, and dietary intake to total DIs were estimated. The results indicated that dietary intake is the main source of exposure to DEHP (especially in China), whereas dermal exposure was a major source for DEP. This is the first study to elucidate sources of human exposure to phthalates among the general population in China.
Full text
Available for:
IJS, KILJ, NUK, PNG, UL, UM
PDF
