TC轴承激光增材制造工艺及组织性能研究

E-resources

Peer reviewed

TC轴承激光增材制造工艺及组织性能研究

杨胶溪胡星王艳芳

材料工程, 2016, Volume: 44, Issue: 7

Journal Article

为解决常规方法制备TC轴承带来的磨损不均问题,提高TC轴承服役寿命,采用激光增材制造方法在钢制零件基体表面制备耐磨涂层。选用两套不同工艺参数分别在TC轴承内轴套外圆、外轴套内孔进行Cr3C2/Fe基耐磨材料的激光熔覆,获得了无气孔、裂纹且冶金质量优良的耐磨涂层。采用扫描电镜（SEM）、能谱仪（EDS）、X射线衍射（XRD）检测分析手段进行形貌观察、成分分析、物相表征,并使用数字显微硬度计、摩擦磨损试验机、盐雾腐蚀实验箱分别对熔覆层进行硬度、耐磨性和耐腐蚀性进行测试。结果表明：TC轴承耐磨涂层的平均显微硬度为HV700,耐磨性为Ni60涂层的3倍,耐腐蚀性接近于316L不锈钢。

Keep searching

Author

Access to the JCR database is permitted only to users from Slovenia. Your current IP address is not on the list of IP addresses with access permission, and authentication with the relevant AAI accout is required.

Year	Impact factor		Edition		Category		Classification
Year	JCR	SNIP	JCR	SNIP	JCR	SNIP	JCR	SNIP

Links to authors' personal bibliographies	Links to information on researchers in the SICRIS system

Source: Personal bibliographies and: SICRIS

Upload image

Shelf entry

Adding material to shelf was successful.

Adding material to shelf failed.

It was not necessary to add the material to the shelf.

Permalink

E-mail

Impact factor

Select the library membership card:

DRS, in which the journal is indexed

Citations

Theme