Purpose The purpose of this paper is to introduce the multi-solution nature of topology optimization (TO) as a design tool for additive manufacturing (AM). The sensitivity of topologically optimized parts and manufacturing constraints to the initial starting point of the optimization process leading to structures with equivalent performance is explored. Design/methodology/approach A modified bi-directional evolutionary structural optimization (BESO) code was used as the numerical approach to optimize a cantilever beam problem and reduce the mass by 50 per cent. Several optimized structures with relatively equivalent mechanical performance were generated by changing the initial starting point of the TO algorithm. These optimized structures were manufactured using fused deposition modeling (FDM). The equivalence of strain distribution in FDM parts was tested with the digital image correlation (DIC) technique and compared with that from the modified BESO code. Findings The results confirm that TO could lead to a wide variety of non-unique solutions based on loading and manufacturability constraints. The modified BESO code was able to reduce the support structure needed to build the simple two-dimensional cantilever beam by 15 per cent while keeping the mechanical performance at the same level. Originality/value The originality of this paper lies in introduction and application of the multi-solution nature of TO for AM as a design tool for optimizing structures with minimized features in the overhang condition and the need for support structures.