-
Efficient end-milling by using a combination of off-line feed rate optimization and adaptive force control [Elektronski vir]Čuš, Franc, 1953- ...A combination of off-line feedrate optimization and on-line adaptive force control is used to maintain a reference peak force during end milling for safe, accurate, and efficient machining. An ... adaptive control system is built which controlling the cutting force and maintaining constant roughness of the surface being milled by digital adaptation of cutting parameters. In this way it compensates all disturbances during the cutting process: tool wear, non-homogeneity of the workpiece material, vibrations, chatter etc. The basic control principle is based on the control scheme (UNKS) consisting of two neural identificators of the process dynamics and primary artificial controller. Design parameters for the adaptive controllers are selected using an experimentally validated machining process model. The adaptive controllers are implemented on an open architecture controlled (OAC) 4-axis NC milling machine, and evaluated using three experimental test cases: prismatic cuts.Vir: Proceedings of the Eleventh International Scientific Conference, CAM3S'2005, Gliwice-Zakopane, Poland, 6th - 9th December 2005 (Str. 161-166)Vrsta gradiva - prispevek na konferenciLeto - 2005Jezik - angleškiCOBISS.SI-ID - 10147862
Avtor
Čuš, Franc, 1953- |
Župerl, Uroš |
Kiker, Edvard |
Milfelner, Matjaž
Teme
avtomatska regulacija |
nadzor rezalnih sil |
oblikovno frezanje |
adaptivna regulacija |
rezalni pogoji |
mehki adaptivni sistem vodenja |
čelno frezanje |
automatic control |
cutting forces |
force control |
end milling |
adaptive control |
cutting conditions |
fuzzy adaptive control |
ball-end milling
![loading ... loading ...](themes/default/img/ajax-loading.gif)
Vnos na polico
Trajna povezava
- URL:
Faktor vpliva
Dostop do baze podatkov JCR je dovoljen samo uporabnikom iz Slovenije. Vaš trenutni IP-naslov ni na seznamu dovoljenih za dostop, zato je potrebna avtentikacija z ustreznim računom AAI.
Leto | Faktor vpliva | Izdaja | Kategorija | Razvrstitev | ||||
---|---|---|---|---|---|---|---|---|
JCR | SNIP | JCR | SNIP | JCR | SNIP | JCR | SNIP |
Baze podatkov, v katerih je revija indeksirana
Ime baze podatkov | Področje | Leto |
---|
Povezave do osebnih bibliografij avtorjev | Povezave do podatkov o raziskovalcih v sistemu SICRIS |
---|---|
Čuš, Franc, 1953- | 08634 |
Župerl, Uroš | 20232 |
Kiker, Edvard | 03020 |
Milfelner, Matjaž | 19093 |
Izberite prevzemno mesto:
Prevzem gradiva po pošti
Obvestilo
Gesla v Splošnem geslovniku COBISS
Izbira mesta prevzema
Mesto prevzema | Status gradiva | Rezervacija |
---|
Prosimo, počakajte trenutek.