VSE knjižnice (vzajemna bibliografsko-kataložna baza podatkov COBIB.SI)
-
The influence of normal load and slip amplitude on fretting behaviour of AlSi7Mg-T6Pukl, Boris ...Investigations into the fretting behaviour of the AlSi7Mg-T6 aluminium alloy are presented in this paper. With regard to the surface finishing conditions of the material, two types of specimens were ... considered: (i) machined and (ii)machined and shot peened specimens. The research was focused on investigations into the influence of the number of cycles, normal load (contact pressure) and the amplitude of slip on the fretting behaviour of the material. Fretting tests were performed under various running conditions with regard to normal load levels and slip amplitudes. The coefficient of friction between the surfaces at the fretting junction was continuously recorded. The fretting damage on the aluminium specimens was studied by means of microscopic and EPM analyses. With regard to the evolution of coefficient of friction curves, two modes of fretting process were identified. They differ in the transition from the initial phase to the steady-state fretting regime and depend primarily on the severity of the running conditions and the material properties. In general, higher values of the coefficient of friction were observed with machined and shot peened specimens as compared with those which were machined. It was found that for a given normal load, the coefficient of friction increases with an increased amplitude of slip while, for a given amplitude of slip, it decreases with an increased normal load.Vir: Materiálové inžinierstvo = Materials engineering. - ISSN 1335-0803 (Vol. 5, no. 13, 1998, str. 52-59)Vrsta gradiva - članek, sestavni delLeto - 1998Jezik - angleškiCOBISS.SI-ID - 3026971
![loading ... loading ...](themes/default/img/ajax-loading.gif)
vir: Materiálové inžinierstvo = Materials engineering. - ISSN 1335-0803 (Vol. 5, no. 13, 1998, str. 52-59)
![loading ... loading ...](themes/default/img/ajax-loading.gif)
![loading ... loading ...](themes/default/img/ajax-loading.gif)
![loading ... loading ...](themes/default/img/ajax-loading.gif)
Vnos na polico
Trajna povezava
- URL:
Faktor vpliva
Dostop do baze podatkov JCR je dovoljen samo uporabnikom iz Slovenije. Vaš trenutni IP-naslov ni na seznamu dovoljenih za dostop, zato je potrebna avtentikacija z ustreznim računom AAI.
Leto | Faktor vpliva | Izdaja | Kategorija | Razvrstitev | ||||
---|---|---|---|---|---|---|---|---|
JCR | SNIP | JCR | SNIP | JCR | SNIP | JCR | SNIP |
Baze podatkov, v katerih je revija indeksirana
Ime baze podatkov | Področje | Leto |
---|
Povezave do osebnih bibliografij avtorjev | Povezave do podatkov o raziskovalcih v sistemu SICRIS |
---|---|
Pukl, Boris | 07265 |
Vodopivec, Franc, 1931-2021 | 00142 |
Fajdiga, Matija | 00819 |
Vir: Osebne bibliografije
in: SICRIS
Izberite prevzemno mesto:
Prevzem gradiva po pošti
Naslov za dostavo:
Med podatki člana manjka naslov.
Storitev za pridobivanje naslova trenutno ni dostopna, prosimo, poskusite še enkrat.
S klikom na gumb "V redu" boste potrdili zgoraj izbrano prevzemno mesto in dokončali postopek rezervacije.
S klikom na gumb "V redu" boste potrdili zgoraj izbrano prevzemno mesto in naslov za dostavo ter dokončali postopek rezervacije.
S klikom na gumb "V redu" boste potrdili zgoraj izbrani naslov za dostavo in dokončali postopek rezervacije.
Obvestilo
Trenutno je storitev za avtomatsko prijavo in rezervacijo nedostopna. Gradivo lahko rezervirate sami na portalu Biblos ali ponovno poskusite tukaj kasneje.
Gesla v Splošnem geslovniku COBISS
Izbira mesta prevzema
Gradivo iz matične enote je brezplačno. Če je gradivo na mesto prevzema dostavljeno iz drugih enot, lahko knjižnica to storitev zaračuna.
Mesto prevzema | Status gradiva | Rezervacija |
---|
Rezervacija v teku
Prosimo, počakajte trenutek.
Rezervacija je uspela.
Rezervacija ni uspela.
Rezervacija...
Članska izkaznica:
Mesto prevzema: