Akademska digitalna zbirka SLovenije - logo
Fakulteta za strojništvo, Ljubljana (FSLJ)
  • Differences in phase transformation in laser peened and shot peened 304 austenitic steel
    Starman, Bojan, 1985- ...
    Laser Shock Peening (LSP) and Shot Peening (SP) are processes used to mechanically alter the surface properties of metals by inducing a transient high-pressure wave by a laser pulse or by a ... high-velocity impact of a peening particle. Both processes aim to induce compressive residual stresses near the surface and the level of residual stresses obtained from SP or LSP is similar. When austenitic steel is peened, martensitic phase transformation takes place. It has been observed in experiments that the amount of martensite in shot-peened surfaces is significantly higher than in laser peened surfaces. The cause of these differences is, however, not yet fully explained and the available explanations are often conflicting. In this study, both SP and LSP are modelled using an elasto-viscoplastic model that also account for martensitic phase transformation. The analyses show that LSP and SP are fundamentally different from a mechanical point of view. By tracing the stress trajectories in the principal stress space, it is shown that martensite formation and plastic straining are highly dependent on the intensity of the individual components of hydrostatic and deviatoric stress, which evolve differently in the two processes.
    Vir: International journal of mechanical sciences. - ISSN 0020-7403 (Vol. 176, 2020, str. 1-18)
    Vrsta gradiva - članek, sestavni del ; neleposlovje za odrasle
    Leto - 2020
    Jezik - angleški
    COBISS.SI-ID - 17043227

    Povezava(-e):

    https://www.sciencedirect.com/science/article/pii/S0020740319344728
    DOI

Vnos na polico