A new plasma heating mechanism for Microwave Discharge Ion Sources (MDIS) was discovered. Unprecedented beam stability was observed during the commissioning of the Proton Source for the European ...Spallation Source (PS-ESS) where several thousand source configurations were tested using a custom software tool. Data analysis and plasma simulation revealed that the new behaviour is generated by a completely new plasma heating schema activated by a precise magnetic configuration peculiarity. The stability showed in this configuration, denominated High Stability Microwave Discharge Ion Source (HSMDIS), is excellent and the emittance of the produced beam is lower than produced by standard MDIS configuration. High linearity between power and beam current was observed making easier the use of the source. This new mode of operation can be easily implemented in all existing sources.
Abstract
We hereby report a study on confinement and electron loss dynamics in the magnetic trap of an electron cyclotron resonance ion source using a special multi-diagnostic setup that has allowed ...the simultaneous collection of plasma radio-self-emission and x-ray images in the range 500 eV–20 keV. Argon plasmas were generated in single- and two-close-frequency heating (SFH and TCFH) modes. Evidence of turbulent regimes has been found: for stable and unstable configurations quantitative characterizations of the plasma radio self-emission have been carried out, then compared with local measurements of plasma energy content evaluated by x-ray imaging. This imaging method is the only one able to clearly separate x-ray radiation coming from the plasma from that coming from the plasma chamber walls. X-ray imaging has also been supported and benchmarked by volumetric spectroscopy performed via silicon drift and high-purity germanium detectors. The obtained results in terms of x-ray intensity signal coming from the plasma core and from the plasma chamber walls permit the estimation of the average ratio: plasma vs. walls (i.e. plasma losses) as a function of input RF power and pumping wave frequency, showing an evident increase (above the experimental errors) of the intensity in the 2–20 keV energy range due to the plasma losses in the case of unstable plasma. This ratio was well correlated with the strength of the instabilities, in SFH operation mode; in TCFH mode, under specific power balance conditions and frequency combinations, it was possible to damp the instabilities, and thus the plasma losses were observed to decrease and a general reconfiguration of the spatial plasma structure occurred (the x-ray emission was more concentrated in the center of the plasma chamber). Finally, a simplified model was used to simulate electron heating under different pumping frequencies, prompting discussion of the impact of velocity anisotropy vs the onset of the instability, and the mechanism of particle diffusion in the velocity space in stable and unstable regimes.
Abstract We present a numerical study of metals dynamics evaporated through resistively heated ovens in electron cyclotron resonance (ECR) plasma traps, used as metal ion beam injectors for ...accelerators and multi-disciplinary research in plasma physics. We use complementary numerical methods to perform calculations in the framework of the PANDORA trap. The diffusion and deposition of metal vapours at the plasma chamber’s surface are explored under molecular flow regime, with stationary and time-dependent particle fluid calculations via COMSOL Multiphysics®. The ionisation of vapours is then studied in the strongly energised ECR plasma. We have developed a Monte Carlo (MC) code to simulate the in-plasma metal ions’ dynamics, coupled to particle-in-cell simulations of the plasma physics in the trap. The presence of strongly inhomogeneous plasmas leads to charge-exchange and electron-impact ionisations of metals, in turn affecting the deposition rate/pattern of the metal on the walls of the trap. Results show how vapours dynamics depends both on evaporated metals and the plasma target. The 134 Cs, 176 Lu, and 48 Ca isotopes were investigated, the first two being radioisotopes interesting for the PANDORA project, and the third as one of the most required rare isotope by the nuclear physics community. We present an application of the study: MC computing the γ activity due to the deposited radioactive neutral nuclei during the measurement time, we quantitatively estimated the overall γ -detection system’s efficiency using GEANT4, including the poisoning γ -signal from the walls of the trap, relevant for the γ -tagging of short-lived nuclei’s decay rate in the PANDORA experiment. This work can give valuable support both to the evaporation technique and plasma source optimisation, for improving the metal ion beam production, avoiding huge deposit/waste of metals known to affect the long-term source stability, as well as for radio-safety aspects and reducing material waste in case of rare isotopes.
Experiments have recently demonstrated that kinetic instabilities occurring in magnetoplasma are huge limiting factors to the flux of highly charged ion beams extracted from ECR ion sources. ...Recently, it has been shown that the two-frequency-heating (TFH) mode has the proven potential to mitigate these instabilities. Since the fundamental physical mechanism of TFH is still unclear, a deeper experimental investigation is necessary. At ATOMKI-Debrecen, the effect on the kinetic instabilities of an argon plasma in a 'two-close-frequency heating' scheme has been explored for the first time by using a frequency gap smaller than 1 GHz (i.e. operating in the so-called two-closed-frequency heating mode). A special multi-diagnostics setup has been designed and implemented. In this paper, we will show the data collected by a two-pin, plasma-chamber immersed antenna connected to an RF detector diode and/or to a spectrum analyzer for the detection of plasma radio-self-emission when varying the pumping frequency in single versus double frequency heating mode. Data have been collected simultaneously to the beam extraction and for different frequency gaps and relative power balances. The turbulent regime of the plasma has been tentatively described in a quantitative way, according to the properties of the plasma self-emitted RF spectrum. The measurements show that plasma self-emitted radiation emerges from the internal ECR region everytime (i.e. below the lower pumping frequency) but the almost total instability damping can be effective for some specific combinations of frequency-gap and power balance, thus eventually improving the plasma confinement.
The ion beam-plasma interaction is a relevant topic in several fields of plasma physics, from fusion devices to modern ion sources. This paper discusses the numerical modelling of the whole ...beam-plus-plasma-target system in case of 1+ ions entering an ECR-based charge breeder (ECR-CB). The model is able to reproduce the ion capture and the creation of the first charge states in the selected physics case, i.e. the interaction of a 85Rb1+ ions with the plasma of the 14.5 GHz PHOENIX ECR-CB installed at the Laboratoire de Physique Subatomique et de Cosmologie (LPSC) of Grenoble. The results show that a very narrow window of physical parameters for both the beam (energy and energy spread especially) and plasma (ion temperature, density, density structural distribution, self-generated ambipolar fields) exists which is able to reproduce very well the experimental results, providing an exhaustive picture of the involved phenomena. Possible non-linear interactions and the role played by the eventual onset of instabilities are also discussed.
Abstract An innovative plasma chamber for Electron Cyclotron Resonance Ion Sources (ECRIS) has been developed at INFN and will soon be installed and tested with the AISHa (Advanced Ion Source for ...Hadrontherapy) ion source. It consists in inserting a particular liner into the existing chamber, which allows an electrical segmentation of the internal walls of the chamber. The purpose of this system is to reduce the ion losses induced by the anisotropic diffusion mechanism, to improve the plasma confinement and thus to increase the overall performance of the ion source. In fact, in ECRIS plasmas, electrons mostly diffuse along magnetic field lines while ions mostly leak across the same lines. In particular, the inner walls of the plasma chamber are covered with 30 tiles, each one polarized to a proper positive voltage. The tiles are made of Al-6082 and anodized except for the surface directly facing the plasma. The anodizing process makes each tile electrically insulated from the others and from the plasma chamber while preserving the correct operation of the cooling system. The tiles are wrapped by 2 half-cylinders made of Al-6082 acting as shells. Some tiles are equipped of a temperature sensor and machined to allow the wiring of the entire system. In this work the results of the preliminary tests of the thermal and electrical behaviour of the active chamber and the future perspectives are presented.
Abstract Electron Cyclotron Resonance Ion Sources (ECRIS) are widely used for production of highly charged high intensity ion beams for research, medical and industrial applications. ECRIS ...performances, especially the charge state distribution and beam intensity, depend significantly on the electron energy distribution function that ranges from a few eV to hundreds of keV. Further improvements of ECRIS performances require a deeper and deeper understanding of the plasma heating mechanisms and ion generation by means of opportune plasma diagnostics. Amongst others, optical emission spectroscopy (OES) is the most remarkable for application in ECRIS: it is a non-invasive diagnostics able to operate also in high-voltage conditions and it requires small room for operation. OES has been already tested for plasma diagnostics in proton sources. This work presents the experimental set-up developed for the plasma diagnostics of the Advanced Ion Source for Hadrontherapy (AISHa), an ECRIS for medical applications, together with the strategy applied to relate plasma emission lines in the visible and near-infrared domain to plasma parameters for some ions of interest. Preliminary results and perspectives will be also discussed.
A compact dc‐break for ECR ion source @ 18 GHZ Leonardi, O.; Torrisi, G.; Sorbello, G. ...
Microwave and optical technology letters,
December 2018, 2018-12-00, 20181201, Letnik:
60, Številka:
12
Journal Article
Recenzirano
This paper shows simulations and experimental result of a 1.5 kW waveguide DC‐Break designed for the AISHa ion source in commissioning phase at INFN‐LNS.
The DC‐Break was designed to fulfill an ...insulation of 50 kV, power losses lower than 0.5 dB by considering the compactness as key requirement.
PDF
