The coronavirus disease 2019 (COVID-19) pandemic has resulted in millions of patients infected worldwide and indirectly affecting even more individuals through disruption of daily living. Long-term ...adverse outcomes have been reported with similar diseases from other coronaviruses, namely Middle East Respiratory Syndrome (MERS) and Severe Acute Respiratory Syndrome (SARS). Emerging evidence suggests that COVID-19 adversely affects different systems in the human body. This review summarizes the current evidence on the short-term adverse health outcomes and assesses the risk of potential long-term adverse outcomes of COVID-19. Major adverse outcomes were found to affect different body systems: immune system (including but not limited to Guillain-Barré syndrome and paediatric inflammatory multisystem syndrome), respiratory system (lung fibrosis and pulmonary thromboembolism), cardiovascular system (cardiomyopathy and coagulopathy), neurological system (sensory dysfunction and stroke), as well as cutaneous and gastrointestinal manifestations, impaired hepatic and renal function. Mental health in patients with COVID-19 was also found to be adversely affected. The burden of caring for COVID-19 survivors is likely to be huge. Therefore, it is important for policy makers to develop comprehensive strategies in providing resources and capacity in the healthcare system. Future epidemiological studies are needed to further investigate the long-term impact on COVID-19 survivors.
.
Display omitted
► The maximum residual stress for laser-peened samples was found at the surface. ► Two methods of FLPF and FSIP were analyzed to get the optimum process parameters. ► The fatigue ...cracks are at the subsurface for shot- and laser-peened samples. ► The comprehensive effect of surface integrity on fatigue property was considered.
The fatigue strength for 1
×
10
7 cycles of 7050–T7451 aluminum alloy was determined for machined, laser-peened, and shot-peened specimens. Moreover, fatigue lives were compared under the same load conditions. Results show that the laser peening induces a deeper compressive residual stress layer and better surface finish, therefore, it improves fatigue properties more effectively. Fractographic examination and analysis shows that the fatigue cracks initiate in the subsurface layer beneath the compressive residual stress field for laser- and shot-peened specimens, whereas the fatigue cracks form at surface for as-machined ones.
Despite the significant progresses made in all-polymer solar cells (all-PSCs) recently, the relatively low short-circuit current density (J sc) and large energy loss are still quite difficult to ...overcome for further development. To address these challenges, we developed a new class of narrow-bandgap polymer acceptors incorporating a benzotriazole (BTz)-core fused-ring segment, named the PZT series. Compared to the commonly used benzothiadiazole (BT)-containing polymer PYT, the less electron-deficient BTz renders PZT derivatives with significantly red-shifted optical absorption and up-shifted energy levels, leading to simultaneously improved J sc and open-circuit voltage in the resultant all-PSCs. More importantly, a regioregular PZT (PZT-γ) has been developed to achieve higher regiospecificity for avoiding the formation of isomers during polymerization. Benefiting from the more extended absorption, better backbone ordering, and more optimal blend morphology with donor component, PZT-γ-based all-PSCs exhibit a record-high power conversion efficiency of 15.8% with a greatly enhanced J sc of 24.7 mA/cm2 and a low energy loss of 0.51 eV.
A record power conversion efficiency (PCE) of over 19% is realized in planar‐mixed heterojunction (PMHJ) organic solar cells (OSCs) by adopting the asymmetric selenium substitution strategy in making ...a pseudosymmetric electron acceptor, BS3TSe‐4F. The combined molecular asymmetry with more polarizable selenium substitution increases the dielectric constant of the D18/BS3TSe‐4F blend, helping lower the exciton binding energy. On the other hand, dimer packing in BS3TSe‐4F is facilitated to enable free charge generation, helping more efficient exciton dissociation and lowering the radiative recombination loss (ΔE2) of OSCs. As a result, PMHJ OSCs based on D18/BS3TSe‐4F achieve a PCE of 18.48%. By incorporating another mid‐bandgap acceptor Y6‐O into D18/BS3TSe‐4F to form a ternary PMHJ, a higher open‐circuit voltage (VOC) can be achieved to realize an impressive PCE of 19.03%. The findings of using pseudosymmetric electron acceptors in enhancing device efficiency provides an effective way to develop highly efficient acceptor materials for OSCs.
A pseudosymmetric electron acceptor, BS3TSe‐4F, designed from asymmetric selenium substitution strategy promotes free charge generation to enhance exciton dissociation and suppress energy loss in sequentially processed organic solar cells, leading to a record power conversion efficiency of over 19%.
The active layer morphology transition of organic photovoltaics under non-equilibrium conditions are of vital importance in determining the device power conversion efficiency and stability; however, ...a general and unified picture on this issue has not been well addressed. Using combined in situ and ex situ morphology characterizations, morphological parameters relating to kinetics and thermodynamics of morphology evolution are extracted and studied in model systems under thermal annealing. The coupling and competition of crystallization and demixing are found to be critical in morphology evolution, phase purification and interfacial orientation. A unified model summarizing different phase diagrams and all possible kinetic routes is proposed. The current observations address the fundamental issues underlying the formation of the complex multi-length scale morphology in bulk heterojunction blends and provide useful morphology optimization guidelines for processing devices with higher efficiency and stability.
Two cheliform non-fullerene acceptors, DTPC-IC and DTPC-DFIC, based on a highly electron-rich core, dithienopicenocarbazole (DTPC), are synthesized, showing ultra-narrow bandgaps (as low as 1.21 ...eV). The two-dimensional nitrogen-containing conjugated DTPC possesses strong electron-donating capability, which induces intense intramolecular charge transfer and intermolecular π–π stacking in derived acceptors. The solar cell based on DTPC-DFIC and a spectrally complementary polymer donor, PTB7-Th, showed a high power conversion efficiency of 10.21% and an extremely low energy loss of 0.45 eV, which is the lowest among reported efficient OSCs.
Layered molybdenum disulfide has demonstrated great promise as a low-cost alternative to platinum-based catalysts for electrochemical hydrogen production from water. Research effort on this material ...has focused mainly on synthesizing highly nanostructured molybdenum disulfide that allows the exposure of a large fraction of active edge sites. Here we report a promising microwave-assisted strategy for the synthesis of narrow molybdenum disulfide nanosheets with edge-terminated structure and a significantly expanded interlayer spacing, which exhibit striking kinetic metrics with onset potential of -103 mV, Tafel slope of 49 mV per decade and exchange current density of 9.62 × 10(-3) mA cm(-2), performing among the best of current molybdenum disulfide catalysts. Besides benefits from the edge-terminated structure, the expanded interlayer distance with modified electronic structure is also responsible for the observed catalytic improvement, which suggests a potential way to design newly advanced molybdenum disulfide catalysts through modulating the interlayer distance.
A state of matter in which molecules show a long-range orientational order and no positional order is called a nematic liquid crystal. The best known and most widely used (for example, in modern ...displays) is the uniaxial nematic, with the rod-like molecules aligned along a single axis, called the director. When the molecules are chiral, the director twists in space, drawing a right-angle helicoid and remaining perpendicular to the helix axis; the structure is called a chiral nematic. Here using transmission electron and optical microscopy, we experimentally demonstrate a new nematic order, formed by achiral molecules, in which the director follows an oblique helicoid, maintaining a constant oblique angle with the helix axis and experiencing twist and bend. The oblique helicoids have a nanoscale pitch. The new twist-bend nematic represents a structural link between the uniaxial nematic (no tilt) and a chiral nematic (helicoids with right-angle tilt).
Exciton-polaritons are hybrid light-matter quasiparticles formed by strongly interacting photons and excitons (electron-hole pairs) in semiconductor microcavities. They have emerged as a robust ...solid-state platform for next-generation optoelectronic applications as well as for fundamental studies of quantum many-body physics. Importantly, exciton-polaritons are a profoundly open (that is, non-Hermitian) quantum system, which requires constant pumping of energy and continuously decays, releasing coherent radiation. Thus, the exciton-polaritons always exist in a balanced potential landscape of gain and loss. However, the inherent non-Hermitian nature of this potential has so far been largely ignored in exciton-polariton physics. Here we demonstrate that non-Hermiticity dramatically modifies the structure of modes and spectral degeneracies in exciton-polariton systems, and, therefore, will affect their quantum transport, localization and dynamical properties. Using a spatially structured optical pump, we create a chaotic exciton-polariton billiard--a two-dimensional area enclosed by a curved potential barrier. Eigenmodes of this billiard exhibit multiple non-Hermitian spectral degeneracies, known as exceptional points. Such points can cause remarkable wave phenomena, such as unidirectional transport, anomalous lasing/absorption and chiral modes. By varying parameters of the billiard, we observe crossing and anti-crossing of energy levels and reveal the non-trivial topological modal structure exclusive to non-Hermitian systems. We also observe mode switching and a topological Berry phase for a parameter loop encircling the exceptional point. Our findings pave the way to studies of non-Hermitian quantum dynamics of exciton-polaritons, which may uncover novel operating principles for polariton-based devices.
Celotno besedilo
Dostopno za:
DOBA, IJS, IZUM, KILJ, KISLJ, NUK, PILJ, PNG, SAZU, SBMB, SIK, UILJ, UKNU, UL, UM, UPUK
•We model thermal performance of U-pipe evacuated solar tube.•Temperature distribution along fine circumferential direction is in consideration.•Tube size parameters affects on thermal efficiency is ...studied.•Mass flow rate optimal design is analyzed.•Tube thermal parameters adaptation to metrological condition is proposed.
This paper proposes a mathematical model for predicting the thermal performance of U-pipe evacuated solar tube (UpEST) collector, which takes into account the temperature distribution along the tube axis and radius. Furthermore, the modeling predictions were validated using experimental data. Theoretical results agreed well with the measured results that validated the feasibility of the mathematical model. The dependence of the thermal efficiency on meteorological conditions and important tube design parameters, including tube size, thermal characteristics (flow rate, heat loss coefficient, absorption coefficient of the selective absorbing coating), was investigated. In particular, the adaptation of collector thermal parameters to meteorological conditions was analyzed. The analysis results will be helpful for UpEST collector optimization design and application.
PDF
