The LHCb software trigger has two levels: a high-speed trigger running at 1 MHz with strictly limited latency and a second level running below 40 kHz without latency limitations. The trigger strategy ...requires full flexibility in the distribution of the installed CPU power to the two software trigger levels because of the unknown background levels and event topology distribution at the time the LHC accelerator will start its operation. This requirement suggests using a common CPU farm for both trigger levels fed by a common data acquisition (DAQ) infrastructure. The limited latency budget of the first level of software trigger has an impact on the organization of the CPU farm performing the trigger function for optimal usage of the installed CPU power. We will present the architecture and the design of the hardware infrastructure for the entire LHCb software triggering system based on Ethernet as link technology that fulfills these requirements. The performance of the event-building of the combined traffic of both software trigger levels, as well as the expected scale of the system will be presented.
The DELPHI Trigger System at LEP2 energies Augustinus, A.; Canale, V.; Charpentier, P. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
12/2003, Letnik:
515, Številka:
3
Journal Article
Recenzirano
Odprti dostop
In this paper we describe the modifications carried out on the DELPHI trigger complex since the beginning of the high-energy runs of LEP. The descriptions of the trigger configurations and ...performances for the 2000 data taking period are also presented.
The production of single- and multi-photon events has been studied in the reaction e(+) e(-) --> gamma(gamma) + invisible particles. The data collected with the DELPHI detector during the years 1999 ...and 2000 at centre-of-mass energies between 191 GeV and 209 GeV was combined with earlier data to search for phenomena beyond the Standard Model. The measured number of light neutrino families was consistent with three and the absence of an excess of events beyond that predicted by the Standard Model processes was used to set limits on new physics. Both model-independent searches and searches for new processes predicted by supersymmetric and extra-dimensional models have been made. Limits on new non-standard model interactions between neutrinos and electrons were also determined.
A search for single top production (e(+)e(-) --> t (c) over bar) via flavour changing neutral currents (FCNC) was performed using the data taken by the DELPHI detector at LEP2. The data analyzed have ...been accumulated at center-of-mass energies ranging from 189 to 208 GeV. Limits at 95% confidence level were obtained on the anomalous coupling parameters kappa(gamma) and kappa(Z). (C) 2004 Published by Elsevier B.V.
Oscillations in the B-s(0)- <(B-s(0))over bar> system were studied in events selected from about 4.3 million hadronic Z(0) decays registered by DELPHI between 1992 and 2000. This paper presents ...updates of two published analyses (11, 12). The first analysis, which utilizes leptons emitted with large momentum transverse to a jet, was improved by means of a better algorithm for the vertex reconstuction and a new algorithm for flavour-tagging at production time. The second analysis, which utilizes D-s-lepton events, was improved by optimizing the treatment of proper time resolution. No signal of B-s(0) oscillations was observed and limits on the mass difference between the physical B-s(0) states were obtained to be: Deltam(s)>8.0 ps-1 at the 95% C.L. with a sensitivity of Deltam(s)= 9.1 ps(-1) in the high p(t) lepton analysis and Deltam(s)>4.9 ps(-1) at the 95% C.L. with a sensitivity of Deltam(s)=8.6 ps(-1) in the D-s-lepton analysis. Previously published results on these analyses are superseded. The combination of these results with those obtained in other independent analyses previously performed in DELPHI (D-s-hadron, exclusive B-s(0), inclusive vertex) gives: Deltam(s)>8.5 ps(-1) at the 95% C.L. with a sensitivity of Deltam(s)=12.0 ps(-1).
Searches for HZ production with the Higgs boson decaying into an invisible final state were performed using the data collected by the DELPHI experiment at centre-of-mass energies between 188 GeV and ...209 GeV. Both hadronic and leptonic final states of the Z boson were analysed. In addition to the search for a heavy Higgs boson, a dedicated search for a light Higgs boson down to 40 GeV/c2 was performed. No signal was found. Assuming the Standard Model HZ production cross-section, the mass limit for invisibly decaying Higgs bosons is 112.1 GeV/c2 at 95% confidence level. An interpretation in the Minimal Supersymmetric extension of the Standard Model (MSSM) and in a Majoron model is also given.
These final results on e(+) e(-) W+ W- production cross-section measurements at LEP2 use data collected by the DELPHI detector at centre-of-mass energies up to 209 GeV. Measurements of total ...cross-sections, W angular differential distributions and decay branching fractions, and the value of the CKM element |V-cs| are compared to the expectations of the Standard Model. These results supersede all values previously published by DELPHI.
Delphi (DEtector with Lepton, Photon and Hadron Identification) is one of the four experiments of the LEP (Large Electron Positron) collider at CERN. The detector is laid out to provide a nearly ...4/spl pi/ coverage for charged particle tracking, electromagnetic, hadronic calorimetry and extended particle identification. The trigger system consists of four levels. The first two are synchronous with the BCO (beam cross over) and rely on hardwired control units, while the last two are performed asynchronously with respect to the BCO and are driven by the Delphi host computers. The aim of this paper is to give a comprehensive global view of the trigger system architecture, presenting in detail the first two levels, their various hardware components and the latest modifications introduced in order to improve their performance and make more user friendly the whole software user interface.< >
Searches for pair-production of supersymmetric particles under the assumption of non-conservation of R-parity with a dominant LL (E) over bar or (U) over bar(D) over bar(D) over bar term have been ...performed using the data collected by the DELPHI experiment at LEP in e(+)e(-) collisions at centre-of-mass energies from 192 up to 208 GeV. No excess of data above Standard Model expectations was observed. The results were used to constrain the MSSM parameter space and to derive limits on the masses of supersymmetric particles.