Context. The FORS1 instrument on the ESO Very Large Telescope was used to obtain low-resolution circular polarised spectra of nearly a thousand different stars, with the aim of measuring their mean ...longitudinal magnetic fields. Magnetic fields were measured by different authors, and using different methods and software tools. Aims. A catalogue of FORS1 magnetic measurements would provide a valuable resource with which to better understand the strengths and limitations of this instrument and of similar low-dispersion, Cassegrain spectropolarimeters. However, FORS1 data reduction has been carried out by a number of different groups using a variety of reduction and analysis techniques. Our understanding of the instrument and our data reduction techniques have both improved over time. A full re-analysis of FORS1 archive data using a consistent and fully documented algorithm would optimise the accuracy and usefulness of a catalogue of field measurements. Methods. Based on the ESO FORS pipeline, we have developed a semi-automatic procedure for magnetic field determinations, which includes self-consistent checks for field detection reliability. We have applied our procedure to the full content of circular spectropolarimetric measurements of the FORS1 archive. Results. We have produced a catalogue of spectro-polarimetric observations and magnetic field measurements for ~1400 observations of ~850 different objects. The spectral type of each object has been approximately classified. We have also been able to test different methods for data reduction is a systematic way. The resulting catalogue has been used to produce an estimator for an upper limit to the uncertainty in a field strength measurement of an early type star as a function of the signal-to-noise ratio of the observation. Conclusions. While FORS1 is not necessarily an optimal instrument for the discovery of weak magnetic fields, it is very useful for the systematic study of larger fields, such as those found in Ap/Bp stars and in white dwarfs.
Abstract
Italy is among the countries most likely to be exposed to high hydrogeological risk. The recent 2018 Hydrogeological Disruption Report by ISPRA (Higher Institute for Environmental Protection ...and Research) states that about 90% of Italian municipalities fall within areas with hydrogeological risk, that is where the probability of floods/landslides is high (level P3) or very high (P4) or the hydraulic hazard is of medium level. Floods are the most severe and frequent phenomena affecting landscapes, mainly if they occur in urban contexts. Urban development, if nature-based solutions are not taken into account, determines an increase in the impermeable surface, with the effect of reducing the infiltration and water evaporation, and consequently with an increase in runoff peaks and decrease of the concentration times. In this framework, the work here presented numerically analyses the effect of floods in an urban basin, in term of their three-dimensional interaction with buildings. The site under study is Cervinara, a municipality in the Campania region, Italy, hit by severe floods in 1999. Flow peaks were calculated using the VAPI procedure, a regional methodology based on two-component extreme value (TCEV) distribution. The results show that the level of exposure of the buildings, evaluated by calculating the thrust of the interacting water on the exterior walls, is influenced by the local three-dimensional kinematics.
Mass measurements continue to provide invaluable information for elucidating nuclear structure and scenarios of astrophysical interest. The transition region between the Z=20 and 28 proton shell ...closures is particularly interesting due to the onset and evolution of nuclear deformation as nuclei become more neutron-rich. This provides a critical testing ground for emerging ab-initio nuclear structure models. Here, we present high-precision mass measurements of neutron-rich chromium isotopes using the sensitive electrostatic Multiple-Reflection Time-Of-Flight Mass Spectrometer (MR-TOF-MS) at TRIUMF's Ion Trap for Atomic and Nuclear Science (TITAN) facility. Our high-precision mass measurements of 59,61−63Cr confirm previous results, and the improved precision in measurements of 64−65Cr refine the mass surface beyond N=40. With the ab initio in-medium similarity renormalization group, we examine the trends in collectivity in chromium isotopes and give a complete picture of the N=40 island of inversion from calcium to nickel.
Quantifying the elemental composition of elasmobranch calcified cartilage (hard parts) has the potential to answer a range of ecological and biological questions, at both the individual and ...population level. Few studies, however, have employed elemental analyses of elasmobranch hard parts. This paper provides an overview of the range of applications of elemental analysis in elasmobranchs, discussing the assumptions and potential limitations in cartilaginous fishes. It also reviews the available information on biotic and abiotic factors influencing patterns of elemental incorporation into hard parts of elasmobranchs and provides some comparative elemental assays and mapping in an attempt to fill knowledge gaps. Directions for future experimental research are highlighted to better understand fundamental elemental dynamics in elasmobranch hard parts.
The characteristics of armour paints, historically used to protect ferrous industrial heritage, are explored. Amour paints contain lamellar and highly reflexive pigments of micaceous iron oxide (MIO) ...and metallic, leafing aluminium, bound in linseed oil and linseed oil–tung oil mixtures, on an inhibitive and soap-forming linseed oil primer (red lead). It is the first study of the binding media used for historical armour paints and investigates the chemical and physical ageing of armour paints using a multianalytical approach. Naturally aged examples are compared to accelerated aged replica armour paint, and to historical paints. The ageing and degradation reactions are assessed by complementary GC–MS and FTIR, together with measurements of wettability, hardness and surface colour. The historical paint formulations include linseed oils and alkyd binders. The results confirm that the leafing effect of aluminium pigments results in only a small concentration of binder at the surface: the paints studied reflect light and form a strong chemical and physical barrier. Linseed oils and tung oil mixtures have been proven to be suitable for the production of armour paints, but the evaluation of ageing and assessment of physical changes will require further investigation.
•Adapted C. vulgaris showed growth capacity on winery waste digestion effluent.•Batch growth test with 20% of digestate shows no inhibition effects.•C. vulgaris biomass concentration of ...1.36 ± 0.09 g l−1 was obtained.•Winery waste digestate promoted C. vulgaris lipid storage up to 28%.•Lipid characterization showed 65%w/w of oleic acid and 0.15%w/w of linolenic acid.
The recovery of high added value compound from waste stream is fundamental to keep biotechnological processes sustainable. In this study, anaerobic digestion of two highly produced organic waste was integrated with microalgae-based processes both to treat liquid digestate and recover high value compounds. Chlorella vulgaris growth was assessed for lipids accumulation and subsequent recovery, using two types of digestate: organic waste and sewage sludge digestate (DIG-OFMSW) and wine lees digestate (DIG-WL). Growth tests were carried out in batch mode and results showed a slightly higher final biomass concentration from DIG-WL (1.36 ± 0.09 g l−1) compared to DIG-OFMSW (1.05 ± 0.13 g l−1) and a clearly different lipids accumulation yield (28.86 ± 0.05% in DIG-WL compared to 6.1 ± 0.2% of DIG-OFMSW, on total solids). Lipid characterization showed a high oleic acid accumulation (69.52 ± 0.50%w/w in DIG-WL) that positively influence biodiesel properties and a low linolenic acids content (below 0.30%w/w) that comply with European law EN14214 for biodiesel (linolenic acid content lower than 12%w/w). In addition, due to the high concentration of palmitic and stearic acids detected at the end of test, this oil can be used as new substrate to produce stearin, normally produced from palm oil.
This study quantified the per cent contribution of water chemistry to otolith chemistry using enriched stable isotopes of strontium (86Sr) and barium (137Ba). Euryhaline barramundi Lates calcarifer, ...were reared in marine (salinity 40), estuarine (salinity 20) and freshwater (salinity 0) under different temperature treatments. To calculate the contribution of water to Sr and Ba in otoliths, enriched isotopes in the tank water and otoliths were quantified and fitted to isotope mixing models. Fulton's K and RNA:DNA were also measured to explore the influence of fish condition on sources of element uptake. Water was the predominant source of otolith Sr (between 65 and 99%) and Ba (between 64 and 89%) in all treatments, but contributions varied with temperature (for Ba), or interactively with temperature and salinity (for Sr). Fish condition indices were affected independently by the experimental rearing conditions, as RNA:DNA differed significantly among salinity treatments and Fulton's K was significantly different between temperature treatments. Regression analyses did not detect relations between fish condition and per cent contribution values. General linear models indicated that contributions from water chemistry to otolith chemistry were primarily influenced by temperature and secondly by fish condition, with a relatively minor influence of salinity. These results further the understanding of factors that affect otolith element uptake, highlighting the necessity to consider the influence of environment and fish condition when interpreting otolith element data to reconstruct the environmental histories of fish.
Nuclear mass measurements of isotopes are key to improving our understanding of nuclear structure across the chart of nuclides, in particular, for the determination of the appearance or disappearance ...of nuclear shell closures. We present high-precision mass measurements of neutron-rich Ca, Ti, and V isotopes performed at TRIUMF's Ion Trap for Atomic and Nuclear science (TITAN) and the Low Energy Beam and Ion Trap (LEBIT) facilities. These measurements were made using the TITAN multiple-reflection time-of-flight mass spectrometer (MR-ToF-MS) and the LEBIT 9.4T Penning trap mass spectrometer. In total, 13 masses were measured, 8 of which represent increases in precision over previous measurements. These measurements refine trends in the mass surface around N=32 and N=34, and support the disappearance of the N=32 shell closure with increasing proton number. Additionally, our data do not support the presence of a shell closure at N=34.
A laser ablation source for offline ion production at LEBIT Izzo, C.; Bollen, G.; Bustabad, S. ...
Nuclear instruments & methods in physics research. Section B, Beam interactions with materials and atoms,
06/2016, Letnik:
376
Journal Article
Recenzirano
Odprti dostop
A laser ablation ion source has been developed and implemented at the Low-Energy Beam and Ion Trap (LEBIT) facility at the National Superconducting Cyclotron Laboratory. This offline ion source ...enhances the capabilities of LEBIT by providing increased access to ions used for calibration measurements and checks of systematic effects as well as stable and long-lived ions of scientific interest. The design of the laser ablation ion source and a demonstration of its successful operation are presented.
Wine production represents one of the most important agro-industrial sectors in Italy. Wine lees are the most significant waste in the winery industry and have high disposal and storage costs and few ...applications within the circular economy. In this study, anaerobic digestion and a microalgae coupled process was studied in order to treat wine lees and waste activated sludge produced within the same facility, with the aim of producing energy and valuable microalgae biomass that could be processed to recover biofuel or biostimulant. Chlorella vulgaris was cultivated on liquid digestate in a semi-continuous system without biomass recirculation. The best growth and phytoremediation performance were achieved applying a hydraulic retention time (HRT) of 20 days with a stable dry weight, lipid and protein storage of 1.85 ± 0.02 g l
, 33.48 ± 7.54 % and 57.85 ± 10.14 % respectively. Lipid characterization highlighted the potential use in high quality biodiesel production, according to EN14214 (<12 % v/v linolenic acid). The microalgae reactor's liquid output showed high removal of ammonia (95.72 ± 2.10 %), but low organic soluble matter reduction. Further semi-continuous process optimization was carried out by increasing the time between digestate feeding and biomass recovery at HRT 10. These operative changes avoided biomass wash-out and provided a stable phytoremediation of the digestate with 84.58 ± 4.02 % ammonia removal, 33.01 ± 1.44 % sCOD removal, 38.06 ± 2.65 % of polyphenols removal.
PDF
