The advent of stable, highly squeezed states of light has generated great interest in the gravitational wave community as a means for improving the quantum-noise-limited performance of advanced ...interferometric detectors. To confidently measure these squeezed states, it is first necessary to measure the shot-noise across the frequency band of interest. Technical noise, such as non-stationary events, beam pointing, and parasitic interference, can corrupt shot-noise measurements at low Fourier frequencies, below tens of kilo-hertz. In this paper we present a qualitative investigation into all of the relevant noise sources and the methods by which they can be identified and mitigated in order to achieve quantum noise limited balanced homodyne detection. Using these techniques, flat shot-noise down to Fourier frequencies below 0.5 Hz is produced. This enables the direct observation of large magnitudes of squeezing across the entire audio-band, of particular interest for ground-based interferometric gravitational wave detectors. 11.6 dB of shot-noise suppression is directly observed, with more than 10 dB down to 10 Hz.
We present the conceptual design and noise analysis of a novel inertial-isolation scheme based on six degree-of-freedom (6D) interferometric sensing of a single reference mass. It is capable of ...reducing inertial motion by more than two orders of magnitude at 100 mHz compared with what is achievable with state-of-the-art seismometers. This will enable substantial improvements in the low-frequency sensitivity of gravitational-wave detectors. The scheme is inherently two-stage, the reference mass is softly suspended within the platform to be isolated, which is itself suspended from the ground. The platform is held constant relative to the reference mass and this closed-loop control effectively transfers the low acceleration-noise of the reference mass to the platform. The loop gain also reduces non-linear couplings and dynamic range requirements in the soft-suspension mechanics and the interferometric sensing.
We present a compact, fibre-coupled interferometer with high sensitivity and a large working range. We propose to use this interferometer as a readout mechanism for future inertial sensors, removing ...a major limiting noise source, and in precision positioning systems. The interferometer's peak sensitivity is 2×10−14 m Hz−1 at 70 Hz and 7×10−11 m Hz−1 at 10 mHz. If deployed on a GS-13 geophone, the resulting inertial sensing output will be limited by the suspension thermal noise of the reference mass from 10 mHz to 2 Hz.
Abstract
We present a modified commercial L-4C geophone with interferometric readout that demonstrates a resolution 60 times lower than the included coil-magnet readout at low frequencies. The ...intended application for the modified sensor is in vibration isolation platforms that require improved performance at frequencies lower than 1 Hz. To illustrate it’s application a controls- and noise-model of an Advanced LIGO ‘HAM-ISI’ vibration isolation system was developed, and shows that our sensor can reduce the residual motion of the platforms by a factor of 70 at 0.1 Hz.
An accurate readout of low-power optical higher-order spatial modes is of increasing importance to the precision metrology community. Mode sensors are used to prevent mode mismatches from degrading ...quantum and thermal noise mitigation strategies. Direct mode analysis sensors (MODAN) are a promising technology for real-time monitoring of arbitrary higher-order modes. We demonstrate MODAN with photo-diode readout to mitigate the typically low dynamic range of CCDs. We look for asymmetries in the response of our sensor to break degeneracies in the relative alignment of the MODAN and photo-diode and consequently improve the dynamic range of the mode sensor. We provide a tolerance analysis and show methodology that can be applied for sensors beyond first order spatial modes.
Abstract Laser frequency stabilization is a crucial technique for precision metrology. We demonstrate laser frequency control using a compact, interferometric sensor, specially modified for ...sensitivity to laser frequency noise. This setup achieves a balance between compact size, ease of use, and affordability. We stabilize the laser frequency noise, of a low-cost solid-state laser, to 4.5 k H z H z − 1 at 1 Hz. The requirement for additional technology, and expense, is negated when identical, compact, interferometric sensors are deployed. The use of compact interferometric sensors is already a technology under investigation for integration into gravitational-wave observatories and out study enables wider applications by mitigating a fundamental noise source, inherent to their design.
Abstract
High precision interferometers such as gravitational-wave detectors require complex seismic isolation systems in order to decouple the experiment from unwanted ground motion. Improved ...inertial sensors for active isolation potentially enhance the sensitivity of existing and future gravitational-wave detectors, especially below 30 Hz, and thereby increase the range of detectable astrophysical signals. This paper presents a vertical inertial sensor which senses the relative motion between an inertial test mass suspended by a blade spring and a seismically isolated platform. An interferometric readout was used which introduces low sensing noise, and preserves a large dynamic range due to fringe-counting. The expected sensitivity is comparable to other state-of-the-art interferometric inertial sensors and reaches values of
10
−
10
m
(
H
z
1
/
2
)
−
1
at 100 mHz and
10
−
12
m
(
H
z
1
/
2
)
−
1
at 1 Hz. The potential sensitivity improvement compared to commercial L-4C geophones is shown to be about two orders of magnitude at 10 mHz and 100 mHz and one order of magnitude at 1 Hz. The noise performance is expected to be limited by thermal noise of the inertial test mass suspension below 10 Hz. Further performance limitations of the sensor, such as tilt-to-vertical coupling from a non-perfect levelling of the test mass and nonlinearities in the interferometric readout, are also quantified and discussed.