The excellent particle identification (PID) system is needed for the successful execution of the broad experimental program at future Super C-τ Factory (SCTF) in Novosibirsk. The main requirements ...for the PID system are the following: good π/K-separation in whole operational momentum range and good μ/π-separation in the momentum range from 0.4 up to 1.2 GeV/c. The RICH detector based on focusing aerogel (FARICH) could provide good π/K-separation from 0.4 GeV/c and μ/π-separation in the momentum range from 0.4 up to 1.5 GeV/c. The method FARICH is described, beam test results are presented and the status of multilayer aerogel production is given.
In this paper we investigated Cherenkov radiation component influence on the time of charged particle detection in LYSO(Ce) crystals. Description of the experiment setup and Monte Carlo simulation ...scheme are given. The scintillation and Cherenkov radiation processes in LYSO(Ce) crystal were simulated and studied experimentally with electron beam at Budker Institute of Nuclear Physics beam test facilities. The results of the measurements and simulation are presented. The effect of particle detection time shift due to Cherenkov radiation was obtained. It amounts of several tens of picoseconds for LYSO(Ce) crystal bar (it has dimensions of 3×4×50 mm3). Beam test results are in good agreement with calculations.
Beam test of FARICH prototype with digital photon counter Barnyakov, A.Yu; Barnyakov, M.Yu; Bobrovnikov, V.S. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
12/2013, Letnik:
732
Journal Article
Recenzirano
In June 2012 we tested a Focusing Aerogel RICH detector prototype based on Digital Photon Counters (DPC) by Philips at the CERN PS T10 beam line with a particle momentum up to 6GeV/c. The prototype ...comprises a 20×20cm2 photon detector with 48×48 DPC pixels. In order to reduce the dark count rate, the photon detector was cooled to −40°C in addition to disabling individual DPC's microcells. A four layer focusing aerogel radiator with 200mm focal distance was studied. We obtained a Cherenkov angle resolution of 3.61±0.04mrad. The mean number of photoelectrons in a ring is 12. Directly measured π/K separation at 6GeV/c momentum is 3.5σ, μ/π separation is 5.3σ at 1GeV/c. A comparison with a Monte Carlo simulation is presented as well.
•Focusing Aerogel RICH prototype with Digital Photon Counters by Philips was built.•The prototype was tested at the CERN PS T10 beam line.•We observed Cherenkov rings with 12 photoelectrons in average.•Timing resolution of DPCs is 48ps for single photons.•Cherenkov angle resolution is 3.64±0.04mrad per ring.
The Super Charm-Tau Factory is an electron-positron collider project in Novosibirsk with a peak luminosity of 1035cm−1s−1 operating in the center of mass energy range between 2 and 6 GeV. The physics ...program of the experiment in general is devoted to the study of charm quark and tau lepton. Conceptual designs of the collider and a universal detector are presented. The dedicated particle identification (PID) system is required to provide the state-of-the-art level of μ/π separation for the particle momenta up to 1.2GeV/c. The following options for the PID system are considered in this paper: Focusing Aerogel RICH (FARICH) detector composed of 4-layer aerogel tiles, threshold Cherenkov counters based on aerogel and shifter (ASHIPH), Focusing DIRC (FDIRC) counter and time-of-flight (ToF) detector combined with the time-of-propagation (ToP) approach providing a time resolution better than 30ps. Also the capabilities of particles separation in tracking system are discussed. Comparison of PID approaches with help of parametric simulation is performed.
The fast scintillation crystals such as pure CsI or LYSO(Ce) today are considered for timing measurements in future colliding beam experiments. The aim of such counters is to determine time of ...particles arrival with accuracy better than 100 ps. The work is devoted to investigation of influence of Cherenkov radiation on the time resolution of the detectors based on LYSO(Ce) crystals. The results of MC simulation and beam test are presented.
Aerogel for FARICH detector Barnyakov, A.Yu; Barnyakov, M.Yu; Bobrovnikov, V.S. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
12/2014, Letnik:
766
Journal Article
Recenzirano
We present our current experience in preparation of focusing aerogels for the Focusing Aerogel RICH detector. Multilayer focusing aerogel tiles have been produced in Novosibirsk by a collaboration of ...the Budker Institute of Nuclear Physics and Boreskov Institute of Catalysis since 2004. We have obtained 2-3-4-layer blocks with the thickness of 30-45 mm. In 2012, the first samples of focusing blocks with continuous density (refractive index) gradient along thickness were produced. This technology can significantly reduce the contribution from the geometric factor of the radiator thickness to the resolution of the measured Cherenkov angle in the FARICH detector. The special installation was used for automatic control of reagents ratio during the synthesis process. The first samples were tested using the digital radiography method and on the electron beam with the FARICH prototype.
Abstract
Using the 1.32
$$\hbox {pb}^{-1}$$
pb
-
1
statistics collected at the
$$J/\psi $$
J
/
ψ
peak with the KEDR detector at the VEPP-4M
$$e^{+}e^{-\, }$$
e
+
e
-
collider, we measured the ...branching fractions of
$$J/\psi $$
J
/
ψ
meson decays to the final states 2(
$$\pi ^{+}\pi ^{-})\pi ^{0}$$
π
+
π
-
)
π
0
,
$$K^{+}K^{-}\pi ^{+}\pi ^{-}\pi ^{0}$$
K
+
K
-
π
+
π
-
π
0
, 2(
$$\pi ^{+}\pi ^{-})$$
π
+
π
-
)
and
$$K^{+}K^{-}\pi ^{+}\pi ^{-}$$
K
+
K
-
π
+
π
-
. The results obtained for the decays
$$J/\psi \rightarrow $$
J
/
ψ
→
2(
$$\pi ^{+}\pi ^{-})\pi ^{0}$$
π
+
π
-
)
π
0
,
$$J/\psi \rightarrow K^{+}K^{-}\pi ^{+}\pi ^{-}\pi ^{0}$$
J
/
ψ
→
K
+
K
-
π
+
π
-
π
0
contradict the measurements performed by other groups in the last century, but agree well with recent results of BABAR and BESIII collaborations.
Celotno besedilo
Dostopno za:
DOBA, IZUM, KILJ, NUK, PILJ, PNG, SAZU, SIK, UILJ, UKNU, UL, UM, UPUK
A time-of-flight detector based on microchannel plates (MCP) is under development. The main goal of this work is the creation of a radiation hard large area detector providing 10 ps time resolution ...in strong magnetic field. The conceptual detector design is described in details.
The Super Charm–Tau (SCT) Factory is a proposed electron–positron collider in Novosibirsk with a peak luminosity of 1035cm−1s−1 operating in the energy range between 2and 6 GeV. The interaction ...region should be equipped by an excellent universal particle detector meeting the requirements of broad physics program of the experiment. Research and development for all detector subsystems is currently underway. Particle identification (PID) system of the detector is required to provide the state-of-the-art level of μ/π separation for the particle momenta up to 1.2GeV∕c. The following options for the PID system are considered in this paper: focusing aerogel ring imaging Cherenkov (FARICH) detector composed of 4-layer aerogel tiles, threshold Cherenkov counters based on aerogel shifter photomultiplier (ASHIPH), and time-of-flight (ToF) detector combined with the time-of-propagation (ToP) approach providing a time resolution better than 30ps. Assessment of the charged particle separation performance for these options based on simulation and prototype tests results is presented.
Development of a picosecond MCP based particle detector Barnyakov, A.Yu; Barnyakov, M.Yu; Blinov, V.E. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
02/2020, Letnik:
952
Journal Article
Recenzirano
A time-of-flight detector based on microchannel plates (MCP) is under development. The main goal is the creation of a radiation hard large area detector providing ∼10 ps time resolution for single ...charged particle in strong magnetic field. Conceptually, the detector consists of Cherenkov radiator covered with semitransparent photocathode followed by a chevron pair of MCPs. The detector design and the status of the development are reported.
PDF
