This paper describes the design and the performance of the timing detector developed by the TOTEM Collaboration for the Roman Pots (RPs) to measure the Time-Of-Flight (TOF) of the protons produced in ...central diffractive interactions at the LHC . The measurement of the TOF of the protons allows the determination of the longitudinal position of the proton interaction vertex and its association with one of the vertices reconstructed by the CMS detectors. The TOF detector is based on single crystal Chemical Vapor Deposition (scCVD) diamond plates and is designed to measure the protons TOF with about 50 ps time precision. This upgrade to the TOTEM apparatus will be used in the LHC run 2 and will tag the central diffractive events up to an interaction pileup of about 1. A dedicated fast and low noise electronics for the signal amplification has been developed. The digitization of the diamond signal is performed by sampling the waveform. In conclusion, after introducing the physics studies that will most profit from the addition of these new detectors, we discuss in detail the optimization and the performance of the first TOF detector installed in the LHC in November 2015.
The TOTEM experiment has made a precise measurement of the elastic proton–proton differential cross-section at the centre-of-mass energy s=8 TeV based on a high-statistics data sample obtained with ...the β⁎=90 m optics. Both the statistical and systematic uncertainties remain below 1%, except for the t-independent contribution from the overall normalisation. This unprecedented precision allows to exclude a purely exponential differential cross-section in the range of four-momentum transfer squared 0.027<|t|<0.2 GeV2 with a significance greater than 7 σ. Two extended parametrisations, with quadratic and cubic polynomials in the exponent, are shown to be well compatible with the data. Using them for the differential cross-section extrapolation to t=0, and further applying the optical theorem, yields total cross-section estimates of (101.5±2.1) mb and (101.9±2.1) mb, respectively, in agreement with previous TOTEM measurements.
The TOTEM experiment at the CERN LHC has measured elastic proton–proton scattering at the centre-of-mass energy
s
=
8
TeV and four-momentum transfers squared, |
t
|, from
6
×
10
-
4
to 0.2 GeV
2
. ...Near the lower end of the
t
-interval the differential cross-section is sensitive to the interference between the hadronic and the electromagnetic scattering amplitudes. This article presents the elastic cross-section measurement and the constraints it imposes on the functional forms of the modulus and phase of the hadronic elastic amplitude. The data exclude the traditional Simplified West and Yennie interference formula that requires a constant phase and a purely exponential modulus of the hadronic amplitude. For parametrisations of the hadronic modulus with second- or third-order polynomials in the exponent, the data are compatible with hadronic phase functions giving either central or peripheral behaviour in the impact parameter picture of elastic scattering. In both cases, the
ρ
-parameter is found to be
0.12
±
0.03
. The results for the total hadronic cross-section are
σ
tot
=
(
102.9
±
2.3
)
mb and
(
103.0
±
2.3
)
mb for central and peripheral phase formulations, respectively. Both are consistent with previous TOTEM measurements.
Celotno besedilo
Dostopno za:
DOBA, IZUM, KILJ, NUK, PILJ, PNG, SAZU, SIK, UILJ, UKNU, UL, UM, UPUK
The TOTEM experiment at the CERN LHC has measured elastic proton-proton scattering at the centre-of-mass energy Formula omittedTeV and four-momentum transfers squared, |t|, from Formula omitted to ...0.2 GeV Formula omitted. Near the lower end of the t-interval the differential cross-section is sensitive to the interference between the hadronic and the electromagnetic scattering amplitudes. This article presents the elastic cross-section measurement and the constraints it imposes on the functional forms of the modulus and phase of the hadronic elastic amplitude. The data exclude the traditional Simplified West and Yennie interference formula that requires a constant phase and a purely exponential modulus of the hadronic amplitude. For parametrisations of the hadronic modulus with second- or third-order polynomials in the exponent, the data are compatible with hadronic phase functions giving either central or peripheral behaviour in the impact parameter picture of elastic scattering. In both cases, the Formula omitted-parameter is found to be Formula omitted. The results for the total hadronic cross-section are Formula omitted mb and Formula omitted mb for central and peripheral phase formulations, respectively. Both are consistent with previous TOTEM measurements.
Celotno besedilo
Dostopno za:
DOBA, IZUM, KILJ, NUK, PILJ, PNG, SAZU, SIK, UILJ, UKNU, UL, UM, UPUK
Here, the TOTEM experiment at the CERN LHC has measured elastic proton–proton scattering at the centre-of-mass energy s√=8TeV and four-momentum transfers squared, |t|, from 6 × 10–4 to 0.2 GeV2. Near ...the lower end of the t-interval the differential cross-section is sensitive to the interference between the hadronic and the electromagnetic scattering amplitudes. This article presents the elastic cross-section measurement and the constraints it imposes on the functional forms of the modulus and phase of the hadronic elastic amplitude. The data exclude the traditional Simplified West and Yennie interference formula that requires a constant phase and a purely exponential modulus of the hadronic amplitude. For parametrisations of the hadronic modulus with second- or third-order polynomials in the exponent, the data are compatible with hadronic phase functions giving either central or peripheral behaviour in the impact parameter picture of elastic scattering. In both cases, the ρ-parameter is found to be 0.12±0.03. The results for the total hadronic cross-section are σtot = (102.9±2.3) mb and (103.0±2.3) mb for central and peripheral phase formulations, respectively. Both are consistent with previous TOTEM measurements.
Celotno besedilo
Dostopno za:
DOBA, IZUM, KILJ, NUK, PILJ, PNG, SAZU, SIK, UILJ, UKNU, UL, UM, UPUK
This paper describes the design and the performance of the timing detector developed by the TOTEM Collaboration for the Roman Pots (RPs) to measure the Time-Of-Flight (TOF) of the protons produced in ...central diffractive interactions at the LHC. The measurement of the TOF of the protons allows the determination of the longitudinal position of the proton interaction vertex and its association with one of the vertices reconstructed by the CMS detectors. The TOF detector is based on single crystal Chemical Vapor Deposition (scCVD) diamond plates and is designed to measure the protons TOF with about 50 ps time precision. This upgrade to the TOTEM apparatus will be used in the LHC run 2 and will tag the central diffractive events up to an interaction pileup of about 1. A dedicated fast and low noise electronics for the signal amplification has been developed. The digitization of the diamond signal is performed by sampling the waveform. After introducing the physics studies that will most profit from the addition of these new detectors, we discuss in detail the optimization and the performance of the first TOF detector installed in the LHC in November 2015.
Eur. Phys. J. C (2016) 76: 661 The TOTEM experiment at the CERN LHC has measured elastic proton-proton
scattering at the centre-of-mass energy $\sqrt{s}$ = 8 TeV and four-momentum
transfers squared, ...|t|, from 6 x $10^{-4}$ GeV$^2$ to 0.2 GeV$^2$. Near the
lower end of the |t|-interval the differential cross-section is sensitive to
the interference between the hadronic and the electromagnetic scattering
amplitudes. This article presents the elastic cross-section measurement and the
constraints it imposes on the functional forms of the modulus and phase of the
hadronic elastic amplitude. The data exclude the traditional Simplified West
and Yennie interference formula that requires a constant phase and a purely
exponential modulus of the hadronic amplitude. For parametrisations of the
hadronic modulus with second- or third-order polynomials in the exponent, the
data are compatible with hadronic phase functions giving either central or
peripheral behaviour in the impact parameter picture of elastic scattering. In
both cases, the $\rho$-parameter is found to be 0.12 $\pm$ 0.03. The results
for the total hadronic cross-section are $\sigma_{tot}$ = (102.9 $\pm$ 2.3) mb
and (103.0 $\pm$ 2.3) mb for central and peripheral phase formulations,
respectively. Both are consistent with previous TOTEM measurements.
The TOTEM experiment at the CERN LHC has measured elastic proton-proton scattering at the centre-of-mass energy \(\sqrt{s}\) = 8 TeV and four-momentum transfers squared, |t|, from 6 x \(10^{-4}\) ...GeV\(^2\) to 0.2 GeV\(^2\). Near the lower end of the |t|-interval the differential cross-section is sensitive to the interference between the hadronic and the electromagnetic scattering amplitudes. This article presents the elastic cross-section measurement and the constraints it imposes on the functional forms of the modulus and phase of the hadronic elastic amplitude. The data exclude the traditional Simplified West and Yennie interference formula that requires a constant phase and a purely exponential modulus of the hadronic amplitude. For parametrisations of the hadronic modulus with second- or third-order polynomials in the exponent, the data are compatible with hadronic phase functions giving either central or peripheral behaviour in the impact parameter picture of elastic scattering. In both cases, the \(\rho\)-parameter is found to be 0.12 \(\pm\) 0.03. The results for the total hadronic cross-section are \(\sigma_{tot}\) = (102.9 \(\pm\) 2.3) mb and (103.0 \(\pm\) 2.3) mb for central and peripheral phase formulations, respectively. Both are consistent with previous TOTEM measurements.