Graphene and graphene-based materials have shown great promise in many technological applications, but their large-scale production and processing by simple and cost-effective means still constitute ...significant issues in the path of their widespread implementation. Here, we investigate a straightforward method for the preparation of a ready-to-use and low oxygen content graphene material that is based on electrochemical (anodic) delamination of graphite in aqueous medium with sodium halides as the electrolyte. Contrary to previous conflicting reports on the ability of halide anions to act as efficient exfoliating electrolytes in electrochemical graphene exfoliation, we show that proper choice of both graphite electrode (e.g., graphite foil) and sodium halide concentration readily leads to the generation of large quantities of single-/few-layer graphene nanosheets possessing a degree of oxidation (O/C ratio down to ∼0.06) lower than that typical of anodically exfoliated graphenes obtained with commonly used electrolytes. The halide anions are thought to play a role in mitigating the oxidation of the graphene lattice during exfoliation, which is also discussed and rationalized. The as-exfoliated graphene materials exhibited a three-dimensional morphology that was suitable for their practical use without the need to resort to any kind of postproduction processing. When tested as dye adsorbents, they outperformed many previously reported graphene-based materials (e.g., they adsorbed ∼920 mg g–1 for methyl orange) and were useful sorbents for oils and nonpolar organic solvents. Supercapacitor cells assembled directly from the as-exfoliated products delivered energy and power density values (up to 15.3 Wh kg–1 and 3220 W kg–1, respectively) competitive with those of many other graphene-based devices but with the additional advantage of extreme simplicity of preparation.
The preparation of aqueous graphene dispersions by exfoliation of pristine graphite in the presence of a wide range of surfactants is reported. High graphene concentrations, up to about 1
mg
mL
−1, ...were obtained with the use of some non-ionic surfactants. The dispersions consisted of single- and few-layer graphene platelets with their basal planes virtually free of even atomic-sized (point) defects. The potential utility of such highly concentrated dispersions toward the low-cost, large-scale manipulation and processing of graphene was demonstrated by processing them into electrically conductive, free-standing paper-like films.
Aliment Pharmacol Ther 2011; 34: 125–145
Summary
Background Cross‐sectional imaging techniques, including ultrasonography (US), computed tomography (CT) and magnetic resonance imaging (MRI), are ...increasingly used for evaluation of Crohn’s disease (CD).
Aim To perform an assessment of the diagnostic accuracy of cross‐sectional imaging techniques for diagnosis of CD, evaluation of disease extension and activity and diagnosis of complications, and to provide recommendations for their optimal use.
Methods Relevant publications were identified by literature search and selected based on predefined quality parameters, including a prospective design, sample size and reference standard. A total of 68 publications were chosen.
Results Ultrasonography is an accurate technique for diagnosis of suspected CD and for evaluation of disease activity (sensitivity 0.84, specificity 0.92), is widely available and non‐invasive, but its accuracy is lower for disease proximal to the terminal ileum. MRI has a high diagnostic accuracy for the diagnosis of suspected CD and for evaluation of disease extension and activity (sensitivity 0.93, specificity 0.90), and is less dependent on the examiner and disease location compared with US. CT has a similar accuracy to MRI for assessment of disease extension and activity. The three techniques have a high accuracy for identification of fistulas, abscesses and stenosis (sensitivities and specificities >0.80), although US has false positive results for abscesses. As a result of the lack of radiation, US or MRI should be preferred over CT, particularly in young patients.
Conclusions Cross‐sectional imaging techniques have a high accuracy for evaluation of suspected and established CD, reliably measure disease severity and complications; they may offer the possibility to monitor disease progression.
The preparation of solution-processable graphene from graphite oxide typically involves a hydrazine reduction step, but the use of such a reagent in the large-scale implementation of this approach is ...not desirable due to its high toxicity. Here, we compare the deoxygenation efficiency of graphene oxide suspensions by different reductants (sodium borohydride, pyrogallol, and vitamin C, in addition to hydrazine), as well as by heating the suspensions under alkaline conditions. In almost all cases, the degree of reduction attainable and the subsequent restoration of relevant properties (e.g., electrical conductivity) lag significantly behind those achieved with hydrazine. Only vitamin C is found to yield highly reduced suspensions in a way comparable to those provided by hydrazine. Stable suspensions of vitamin C-reduced graphene oxide can be prepared not only in water but also in common organic solvents, such as N,N-dimethylformamide (DMF) or N-methyl-2-pyrrolidone (NMP). These results open the perspective of replacing hydrazine in the reduction of graphene oxide suspensions by an innocuous and safe reductant of similar efficacy, thus facilitating the use of graphene-based materials for large-scale applications.
The electrochemical exfoliation of graphite, particularly through anodic approaches in aqueous electrolyte, is currently the focus of increasing research attention as a simple, versatile and ...environmentally friendly means to access different types of graphene, for the most part with a view to their use in energy-related applications. Over the last couple of years, the scope of anodically exfoliated graphene has been critically broadened on the basis of significant developments along two main directions: (1) the attainment of high quality, oxide-free graphene nanosheets using strategies that inhibit the oxidative degradation reactions usually associated to anodic exfoliation processes, and (2) the preparation of heteroatom (nitrogen, sulfur)-doped graphene through simultaneous anodic exfoliation/functionalization methods. Here we provide an overview of such developments, highlighting the key aspects that have made these advances possible as well as the applications that have been explored for the resulting graphenes, mainly in the field of electrochemical energy storage and conversion. Open questions and further avenues for progress in this research area are also discussed.
An overview of recently developed strategies to access high quality and chemically doped graphenes by electrochemical exfoliation methods and their energy applications is provided.
The dispersion behavior of graphene oxide in different organic solvents has been investigated. As-prepared graphite oxide could be dispersed in N,N-dimethylformamide, N-methyl-2-pyrrolidone, ...tetrahydrofuran, and ethylene glycol. In all of these solvents, full exfoliation of the graphite oxide material into individual, single-layer graphene oxide sheets was achieved by sonication. The graphene oxide dispersions exhibited long-term stability and were made of sheets between a few hundred nanometers and a few micrometers large, similar to the case of graphene oxide dispersions in water. These results should facilitate the manipulation and processing of graphene-based materials for different applications.
Graphene nanosheets produced in the form of stable aqueous dispersions by chemical reduction of graphene oxide and deposited onto graphite substrates have been investigated by atomic force and ...scanning tunneling microscopy (AFM/STM). The chemically reduced graphene oxide nanosheets were hardly distinguishable from their unreduced counterparts in the topographic AFM images. However, they could be readily discriminated through phase imaging in the attractive regime of tapping-mode AFM, probably because of differences in hydrophilicity arising from their distinct oxygen contents. The chemically reduced nanosheets displayed a smoothly undulated, globular morphology on the nanometer scale, with typical vertical variations in the subnanometer range and lateral feature sizes of ∼5−10 nm. Such morphology was attributed to be the result of significant structural disorder in the carbon skeleton, which originates during the strong oxidation that leads to graphene oxide and remains after chemical reduction. Direct evidence of structural disorder was provided by atomic-scale STM imaging, which revealed an absence of long-range periodicity in the graphene nanosheets. Only structured domains a few nanometers large were observed instead. Likewise, the nanosheet edges appeared atomically rough and ill-defined, though smooth on the nanometer scale. The unreduced graphene oxide nanosheets could only be imaged by STM at very low tunneling currents (∼1 pA), being visualized in some cases with inverted contrast relative to the graphite substrate, a result that was attributed to their extremely low conductivity. Complementary characterization of the unreduced and chemically reduced nanosheets was carried out by thermogravimetric analysis as well as UV−visible absorption and X-ray photoelectron and Raman spectroscopies. In particular, the somewhat puzzling Raman results were interpreted to be the result of an amorphous character of the graphene oxide material.
Stellar-mass black holes have all been discovered through X-ray emission, which arises from the accretion of gas from their binary companions (this gas is either stripped from low-mass stars or ...supplied as winds from massive ones). Binary evolution models also predict the existence of black holes accreting from the equatorial envelope of rapidly spinning Be-type stars (stars of the Be type are hot blue irregular variables showing characteristic spectral emission lines of hydrogen). Of the approximately 80 Be X-ray binaries known in the Galaxy, however, only pulsating neutron stars have been found as companions. A black hole was formally allowed as a solution for the companion to the Be star MWC 656 (ref. 5; also known as HD 215227), although that conclusion was based on a single radial velocity curve of the Be star, a mistaken spectral classification and rough estimates of the inclination angle. Here we report observations of an accretion disk line mirroring the orbit of MWC 656. This, together with an improved radial velocity curve of the Be star through fitting sharp Fe II profiles from the equatorial disk, and a refined Be classification (to that of a B1.5-B2 III star), indicates that a black hole of 3.8 to 6.9 solar masses orbits MWC 656, the candidate counterpart of the γ-ray source AGL J2241+4454 (refs 5, 6). The black hole is X-ray quiescent and fed by a radiatively inefficient accretion flow giving a luminosity less than 1.6 × 10(-7) times the Eddington luminosity. This implies that Be binaries with black-hole companions are difficult to detect in conventional X-ray surveys.
Celotno besedilo
Dostopno za:
DOBA, IJS, IZUM, KILJ, KISLJ, NUK, PILJ, PNG, SAZU, SIK, UILJ, UKNU, UL, UM, UPUK
The pulsar/massive star binary system PSR B1259−63/LS 2883 is one of the best-studied gamma-ray binaries, a class of systems whose bright gamma-ray flaring can provide important insights into ...high-energy physics. Using the Australian Long Baseline Array, we have conducted very long baseline interferometric observations of PSR B1259−63 over 4.4 years, fully sampling the 3.4-year orbital period. From our measured parallax of 0.38 ± 0.05 mas- we use a Bayesian approach to infer a distance of |$2.6^{+0.4}_{-0.3}$| kpc. We find that the binary orbit is viewed at an angle of 154 ± 3° to the line of sight, implying that the pulsar moves clockwise around its orbit as viewed on the sky. Taking our findings together with previous results from pulsar timing observations, all seven orbital elements for the system are now fully determined. We use our measurement of the inclination angle to constrain the mass of the stellar companion to lie in the range 15–31 M_⊙. Our measured distance and proper motion are consistent with the system having originated in the Cen OB1 association and receiving a modest natal kick, causing it to have moved ∼8 pc from its birthplace over the past ∼3 × 10^5 years. The orientation of the orbit on the plane of the sky matches the direction of motion of the X-ray synchrotron-emitting knot observed by the Chandra X-ray Observatory to be moving away from the system.
Anodic exfoliation of graphite has emerged as an attractive method to access graphene nanosheets in large quantities, but oxidation reactions associated to this process compromise the structural ...quality of the resulting materials. Here, we demonstrate that the type of starting graphite material impacts the oxygen and defect content of anodically exfoliated graphenes obtained thereof. We investigated highly oriented pyrolytic graphite (HOPG) as well as graphite foil, flakes and powder as electrode in the anodic process. Importantly, materials with low levels of oxidation and disorder (similar to those typically achieved with cathodic exfoliation approaches) could be attained through proper choice of the graphite electrode. Specifically, using graphite foil afforded nanosheets of higher quality than that of HOPG-derived nanosheets. This discrepancy was interpreted to arise from the structural peculiarities of the former, where the presence of folds, voids and wrinkles would make its exfoliation process to be less reliant on oxidation reactions. Furthermore, cell viability tests carried out with murine fibroblasts on thin graphene films suggested that the anodically exfoliated graphenes investigated here (possessing low or high oxidation levels) are highly biocompatible. Overall, control upon the extent of oxidation and disorder should expand the scope of anodically exfoliated graphenes in prospective applications.
PDF
