Seasonal-mean concentrations of particulate matter with diameters smaller than 2.5 μm (PM2.5) have been decreasing across the United States (US) for several decades, with large reductions in spring ...and summer in the eastern US. In contrast, summertime-mean PM2.5 in the western US has not significantly decreased. Wildfires, a large source of summertime PM2.5 in the western US, have been increasing in frequency and burned area in recent decades. Increases in extreme PM2.5 events attributable to wildland fires have been observed in wildfire-prone regions, but it is unclear how these increases impact trends in seasonal-mean PM2.5. Using two distinct methods, (1) interpolated surface observations combined with satellite-based smoke plume estimates and (2) the GEOS-Chem chemical transport model (CTM), we identify recent trends (2006–2016) in summer smoke, nonsmoke, and total PM2.5 across the US. We observe significant decreases in nonsmoke influenced PM2.5 in the western US and find increases in summer-mean smoke PM2.5 in fire-prone regions, although these are not statistically significant due to large interannual variability in the abundance of smoke. These results indicate that without the influence of wildland fires, we would expect to have observed improvements in summer fine particle pollution in the western US but likely weaker improvements than those observed in the eastern US.
Wet and dry deposition remove aerosols from the atmosphere, and these processes control aerosol lifetime and thus impact climate and air quality. Dry deposition is a significant source of aerosol ...uncertainty in global chemical transport and climate models. Dry deposition parameterizations in most global models were developed when few particle deposition measurements were available. However, new measurement techniques have enabled more size-resolved particle flux observations. We combined literature measurements with data that we collected over a grassland in Oklahoma and a pine forest in Colorado to develop a dry deposition parameterization. We find that relative to observations, previous parameterizations overestimated deposition of the accumulation and Aitken mode particles, and underestimated in the coarse mode. These systematic differences in observed and modeled accumulation mode particle deposition velocities are as large as an order of magnitude over terrestrial ecosystems. As accumulationmode particles formmost of the cloud condensation nuclei (CCN) that influence the indirect radiative effect, this model-measurement discrepancy in dry deposition alters modeled CCN and radiative forcing. We present a revised observationally driven parameterization for regional and global aerosol models. Using this revised dry deposition scheme in the Goddard Earth Observing System (GEOS)-Chem chemical transport model, we find that global surface accumulation-mode number concentrations increase by 62% and enhance the global combined anthropogenic and natural aerosol indirect effect by −0.63 W m−2. Our observationally constrained approach should reduce the uncertainty of particle dry deposition in global chemical transport models.
Exposure to outdoor fine particulate matter (PM2.5) is a leading risk factor for mortality. We develop global estimates of annual PM2.5 concentrations and trends for 1998–2018 using advances in ...satellite observations, chemical transport modeling, and ground-based monitoring. Aerosol optical depths (AODs) from advanced satellite products including finer resolution, increased global coverage, and improved long-term stability are combined and related to surface PM2.5 concentrations using geophysical relationships between surface PM2.5 and AOD simulated by the GEOS-Chem chemical transport model with updated algorithms. The resultant annual mean geophysical PM2.5 estimates are highly consistent with globally distributed ground monitors (R 2 = 0.81; slope = 0.90). Geographically weighted regression is applied to the geophysical PM2.5 estimates to predict and account for the residual bias with PM2.5 monitors, yielding even higher cross validated agreement (R 2 = 0.90–0.92; slope = 0.90–0.97) with ground monitors and improved agreement compared to all earlier global estimates. The consistent long-term satellite AOD and simulation enable trend assessment over a 21 year period, identifying significant trends for eastern North America (−0.28 ± 0.03 μg/m3/yr), Europe (−0.15 ± 0.03 μg/m3/yr), India (1.13 ± 0.15 μg/m3/yr), and globally (0.04 ± 0.02 μg/m3/yr). The positive trend (2.44 ± 0.44 μg/m3/yr) for India over 2005–2013 and the negative trend (−3.37 ± 0.38 μg/m3/yr) for China over 2011–2018 are remarkable, with implications for the health of billions of people.
Urban outdoor air pollution in the developing world, mostly due to particulate matter with diameters smaller than 2.5 μm (PM2.5), has been highlighted in recent years. It leads to millions of ...premature deaths. Outdoor air pollution has also been viewed mostly as an urban problem. We use satellite-derived demarcations to parse India’s population into urban and nonurban regions, which agrees with the census data. We also use the satellite-derived surface PM2.5 levels to calculate the health impacts in the urban and nonurban regions. We show that outdoor air pollution is just as severe in nonurban regions as in the urban regions of India, with implications to monitoring, regulations, health, and policy.
Anthropogenic emissions and land use changes have modified atmospheric aerosol concentrations and size distributions over time. Understanding preindustrial conditions and changes in organic aerosol ...due to anthropogenic activities is important because these features (1) influence estimates of aerosol radiative forcing and (2) can confound estimates of the historical response of climate to increases in greenhouse gases. Secondary organic aerosol (SOA), formed in the atmosphere by oxidation of organic gases, represents a major fraction of global submicron‐sized atmospheric organic aerosol. Over the past decade, significant advances in understanding SOA properties and formation mechanisms have occurred through measurements, yet current climate models typically do not comprehensively include all important processes. This review summarizes some of the important developments during the past decade in understanding SOA formation. We highlight the importance of some processes that influence the growth of SOA particles to sizes relevant for clouds and radiative forcing, including formation of extremely low volatility organics in the gas phase, acid‐catalyzed multiphase chemistry of isoprene epoxydiols, particle‐phase oligomerization, and physical properties such as volatility and viscosity. Several SOA processes highlighted in this review are complex and interdependent and have nonlinear effects on the properties, formation, and evolution of SOA. Current global models neglect this complexity and nonlinearity and thus are less likely to accurately predict the climate forcing of SOA and project future climate sensitivity to greenhouse gases. Efforts are also needed to rank the most influential processes and nonlinear process‐related interactions, so that these processes can be accurately represented in atmospheric chemistry‐climate models.
Plain Language Summary
Secondary organic aerosol (SOA), formed in the atmosphere by oxidation of organic gases, often represents a major fraction of global submicron‐sized atmospheric organic aerosol. Myriad processes affect SOA formation, several of which relate to interactions between natural biogenic emissions and predominantly anthropogenic species such as SO2, NOx, sulfate, nitrate, and ammonium. Many of these key processes are nonlinear and can be synergistic or act to compensate each other in terms of climate forcing. Current atmospheric chemistry‐climate models mostly do not treat these processes. We highlight a number of process‐level mechanisms related to the interactions between anthropogenic and biogenic SOA precursors, for which the corresponding impacts on the radiative effects of SOA need to be investigated in atmospheric chemistry‐climate models. Ultimately, climate models need to capture enough important features of the chemical and dynamic evolution of SOA, in terms of both aerosol number and aerosol mass, as a function of atmospheric variables and anthropogenic perturbations to reasonably predict the spatial and temporal distributions of SOA. A better understanding of SOA formation mechanisms and physical properties is needed to improve estimates of the extent to which anthropogenic emissions and land use changes have modified global aerosol concentrations and size distributions since preindustrial times.
Key Points
We review some important developments in secondary organic aerosol (SOA) that could impact aerosol radiative forcing and response of climate to greenhouse gases
We highlight some of the important processes that involve interactions between natural biogenic emissions and anthropogenic emissions
We discuss fundamental SOA properties volatility and viscosity and their relation to evolution of aerosol mass and number concentrations in the atmosphere
Biomass burning is a major source of atmospheric particulate matter (PM) with impacts on health, climate, and air quality. The particles and vapors within biomass burning plumes undergo chemical and ...physical aging as they are transported downwind. Field measurements of the evolution of PM with plume age range from net decreases to net increases, with most showing little to no change. In contrast, laboratory studies tend to show significant mass increases on average. On the other hand, similar effects of aging on the average PM composition (e.g., oxygen-to-carbon ratio) are reported for lab and field studies. Currently, there is no consensus on the mechanisms that lead to these observed similarities and differences. This review summarizes available observations of aging-related biomass burning aerosol mass concentrations and composition markers, and discusses four broad hypotheses to explain variability within and between field and laboratory campaigns: (1) variability in emissions and chemistry, (2) differences in dilution/entrainment, (3) losses in chambers and lines, and (4) differences in the timing of the initial measurement, the baseline from which changes are estimated. We conclude with a concise set of research needs for advancing our understanding of the aging of biomass burning aerosol.
Chemical transport models have historically struggled to
accurately simulate the magnitude and variability of observed organic
aerosol (OA), with previous studies demonstrating that models ...significantly
underestimate observed concentrations in the troposphere. In this study, we
explore two different model OA schemes within the standard GEOS-Chem
chemical transport model and evaluate the simulations against a suite of 15
globally distributed airborne campaigns from 2008 to 2017, primarily in the
spring and summer seasons. These include the ATom, KORUS-AQ, GoAmazon,
FRAPPE, SEAC4RS, SENEX, DC3, CalNex, OP3, EUCAARI, ARCTAS and ARCPAC
campaigns and provide broad coverage over a diverse set of
atmospheric composition regimes – anthropogenic, biogenic, pyrogenic and
remote. The schemes include significant differences in their treatment of
the primary and secondary components of OA – a “simple scheme” that models
primary OA (POA) as non-volatile and takes a fixed-yield approach to
secondary OA (SOA) formation and a “complex scheme” that simulates POA as
semi-volatile and uses a more sophisticated volatility basis set approach
for non-isoprene SOA, with an explicit aqueous uptake mechanism to model
isoprene SOA. Despite these substantial differences, both the simple and
complex schemes perform comparably across the aggregate dataset in their
ability to capture the observed variability (with an R2 of 0.41 and
0.44, respectively). The simple scheme displays greater skill in minimizing
the overall model bias (with a normalized mean bias of 0.04 compared to 0.30 for the
complex scheme). Across both schemes, the model skill in reproducing
observed OA is superior to previous model evaluations and approaches the
fidelity of the sulfate simulation within the GEOS-Chem model. However,
there are significant differences in model performance across different
chemical source regimes, classified here into seven categories.
Higher-resolution nested regional simulations indicate that model resolution
is an important factor in capturing variability in highly localized
campaigns, while also demonstrating the importance of well-constrained
emissions inventories and local meteorology, particularly over Asia. Our
analysis suggests that a semi-volatile treatment of POA is superior to a
non-volatile treatment. It is also likely that the complex scheme
parameterization overestimates biogenic SOA at the global scale. While this
study identifies factors within the SOA schemes that likely contribute to OA
model bias (such as a strong dependency of the bias in the complex scheme on
relative humidity and sulfate concentrations), comparisons with the skill of
the sulfate aerosol scheme in GEOS-Chem indicate the importance of other
drivers of bias, such as emissions, transport and deposition, that are
exogenous to the OA chemical scheme.
Biomass burning is the largest combustion-related source of volatile organic compounds (VOCs) to the atmosphere. We describe the development of a state-of-the-science model to simulate the ...photochemical formation of secondary organic aerosol (SOA) from biomass-burning emissions observed in dry (RH <20%) environmental chamber experiments. The modeling is supported by (i) new oxidation chamber measurements, (ii) detailed concurrent measurements of SOA precursors in biomass-burning emissions, and (iii) development of SOA parameters for heterocyclic and oxygenated aromatic compounds based on historical chamber experiments. We find that oxygenated aromatic compounds, including phenols and methoxyphenols, account for slightly less than 60% of the SOA formed and help our model explain the variability in the organic aerosol mass (R 2 = 0.68) and O/C (R 2 = 0.69) enhancement ratios observed across 11 chamber experiments. Despite abundant emissions, heterocyclic compounds that included furans contribute to ∼20% of the total SOA. The use of pyrolysis-temperature-based or averaged emission profiles to represent SOA precursors, rather than those specific to each fire, provide similar results to within 20%. Our findings demonstrate the necessity of accounting for oxygenated aromatics from biomass-burning emissions and their SOA formation in chemical mechanisms.
Atmospheric marine aerosol particles impact Earth's albedo and climate. These particles can be primary or secondary and come from a variety of sources, including sea salt, dissolved organic matter, ...volatile organic compounds, and sulfur-containing compounds. Dimethylsulfide (DMS) marine emissions contribute greatly to the global biogenic sulfur budget, and its oxidation products can contribute to aerosol mass, specifically as sulfuric acid and methanesulfonic acid (MSA). Further, sulfuric acid is a known nucleating compound, and MSA may be able to participate in nucleation when bases are available. As DMS emissions, and thus MSA and sulfuric acid from DMS oxidation, may have changed since pre-industrial times and may change in a warming climate, it is important to characterize and constrain the climate impacts of both species. Currently, global models that simulate aerosol size distributions include contributions of sulfate and sulfuric acid from DMS oxidation, but to our knowledge, global models typically neglect the impact of MSA on size distributions.
Measurements at high-Arctic sites (Alert, Nunavut, and Mt. Zeppelin, Svalbard) during the years 2011 to 2013 show a strong and similar annual cycle in aerosol number and size distributions. Each year ...at both sites, the number of aerosols with diameters larger than 20 nm exhibits a minimum in October and two maxima, one in spring associated with a dominant accumulation mode (particles 100 to 500 nm in diameter) and a second in summer associated with a dominant Aitken mode (particles 20 to 100 nm in diameter). Seasonal-mean aerosol effective diameter from measurements ranges from about 180 in summer to 260 nm in winter. This study interprets these annual cycles with the GEOS-Chem-TOMAS global aerosol microphysics model. Important roles are documented for several processes (new-particle formation, coagulation scavenging in clouds, scavenging by precipitation, and transport) in controlling the annual cycle in Arctic aerosol number and size. Our simulations suggest that coagulation scavenging of interstitial aerosols in clouds by aerosols that have activated to form cloud droplets strongly limits the total number of particles with diameters less than 200 nm throughout the year. We find that the minimum in total particle number in October can be explained by diminishing new-particle formation within the Arctic, limited transport of pollution from lower latitudes, and efficient wet removal. Our simulations indicate that the summertime-dominant Aitken mode is associated with efficient wet removal of accumulation-mode aerosols, which limits the condensation sink for condensable vapours. This in turn promotes new-particle formation and growth. The dominant accumulation mode during spring is associated with build up of transported pollution from outside the Arctic coupled with less-efficient wet-removal processes at colder temperatures. We recommend further attention to the key processes of new-particle formation, interstitial coagulation, and wet removal and their delicate interactions and balance in size-resolved aerosol simulations of the Arctic to reduce uncertainties in estimates of aerosol radiative effects on the Arctic climate.