Controlling the motion of liquid drops in contact with a solid surface has broad technological implications in many different areas ranging from textiles to microfluidics and heat exchangers. The ...wettability of a surface is determined by specifying the apparent contact angle and contact angle hysteresis (CAH) that depend on the surface chemistry and morphology. The presence of chemical inhomogeneity and morphological disorder usually increases CAH. A liquid substrate, whose surface is atomically flat and homogenous, is then expected to exhibit a very low CAH. Low CAH determines high drop mobility, while high CAH favours drop pinning. Very slippery surfaces with exceptional omniphobicity are obtained by impregnating a textured solid with a lubricant. To guide and control the motion of drops, the solid surface can be decorated with suitable chemical patterns. In this review, we briefly outline the main results obtained in the past few years to passively control drop motion and produce robust omniphobic surfaces, highlighting some of the most promising applications of these novel functional surfaces.
We studied the effects of vertical vibrations on a water drop that was pinned to the sharp edges of a rectangular post. By varying the frequency and amplitude of the vertical displacement, distinct ...resonance peaks were observed using a simple optical technique. The vibrational spectra of the first two modes exhibited two closely spaced peaks, which corresponded to standing waves that exist along the major and minor contour lengths of the drops. The values of the resonance frequencies can be explained rather well by a simple model, which was originally proposed for axially symmetric drops.
Magnetic beads (or particles) having a size between 1 and 5 µm are largely used in many biochemical assays devoted to both purification and quantification of cells, nucleic acids, or proteins. ...Unfortunately, the use of these beads within microfluidic devices suffers from natural precipitation because of their size and density. The strategies applied thus far to cells or polymeric particles cannot be extended to magnetic beads, mainly due to their magnetization and their higher densities. We report an effective shaking device capable of preventing the sedimentation of beads that are stored in a custom PCR tube. After the characterization of the operating principle, the device is validated for magnetic beads in droplets, leading to an equal distribution between the droplets, barely affecting their generation.
Drop motion induced by vertical vibrations Sartori, Paolo; Quagliati, Damiano; Varagnolo, Silvia ...
New journal of physics,
11/2015, Letnik:
17, Številka:
11
Journal Article
Recenzirano
Odprti dostop
We have studied the motion of liquid drops on an inclined plate subject to vertical vibrations. The liquids comprised distilled water and different aqueous solutions of glycerol, ethanol and ...isopropanol spanning the range 1-39 mm2 s−1 in kinematic viscosities and 40-72 mN m−1 in surface tension. At sufficiently low oscillating amplitudes, the drops are always pinned to the surface. Vibrating the plate above a certain amplitude yields sliding of the drop. Further increasing the oscillating amplitude drives the drop upward against gravity. In the case of the most hydrophilic aqueous solutions, this motion is not observed and the drop only slides downward. Images taken with a fast camera show that the drop profile evolves in a different way during sliding and climbing. In particular, the climbing drop experiences a much bigger variation in its profile during an oscillating period. Complementary numerical simulations of 2D drops based on a diffuse interface approach confirm the experimental findings. The overall qualitative behavior is reproduced suggesting that the contact line pinning due to contact angle hysteresis is not necessary to explain the drop climbing.
Extracellular vesicles (EVs) are double-layered lipid membrane vesicles released by cells. Currently, EVs are attracting a lot of attention in the biological and medical fields due to their role as ...natural carriers of proteins, lipids, and nucleic acids. Thus, they can transport useful genomic information from their parental cell through body fluids, promoting cell-to-cell communication even between different organs. Due to their functionality as cargo carriers and their protein expression, they can play an important role as possible diagnostic and prognostic biomarkers in various types of diseases, e.g., cancers, neurodegenerative, and autoimmune diseases. Today, given the invaluable importance of EVs, there are some pivotal challenges to overcome in terms of their isolation. Conventional methods have some limitations: they are influenced by the starting sample, might present low throughput and low purity, and sometimes a lack of reproducibility, being operator dependent. During the past few years, several microfluidic approaches have been proposed to address these issues. In this review, we summarize the most important microfluidic-based devices for EV isolation, highlighting their advantages and disadvantages compared to existing technology, as well as the current state of the art from the perspective of the use of these devices in clinical applications.
The inertial sliding of physisorbed submonolayer islands on crystal surfaces contains unexpected information on the exceptionally smooth sliding state associated with incommensurate superlubricity ...and on the mechanisms of its disappearance. Here, in a joint quartz crystal microbalance and molecular dynamics simulation case study of Xe on Cu(111), we show how superlubricity emerges in the large size limit of naturally incommensurate Xe islands. As coverage approaches a full monolayer, theory also predicts an abrupt adhesion-driven two-dimensional density compression on the order of several per cent, implying a hysteretic jump from superlubric free islands to a pressurized commensurate immobile monolayer. This scenario is fully supported by the quartz crystal microbalance data, which show remarkably large slip times with increasing submonolayer coverage, signalling superlubricity, followed by a dramatic drop to zero for the dense commensurate monolayer. Careful analysis of this variety of island sliding phenomena will be essential in future applications of friction at crystal/adsorbate interfaces.
•Fabrication of polyester-toner T-junction devices.•Generation of W/O and O/W droplets in the same device without surface treatments.•Production of highly monodisperse W/O or O/W emulsions.•Fast ...(<10min) and low cost (∼$0.10 per device) fabrication procedure.
This paper demonstrates that disposable polyester-toner microfluidic devices are suitable to produce either water-in-oil (W/O) or oil-in-water (O/W) droplets without using any surface treatment of the microchannels walls. Highly monodisperse W/O and O/W emulsions were generated in T-junction microdevices by simply adding appropriate surfactants to the continuous phase. The dispersion in size of droplets generated at frequencies up to 500Hz was always less than about 2% over time intervals of a couple of hours.
.
We have investigated the sliding of droplets made of solutions of Xanthan, a stiff rodlike polysaccharide exhibiting a non-Newtonian behavior, notably characterized by a shear thinning viscosity ...accompanied by the emergence of normal stress difference as the polymer concentration is increased. These experimental results are quantitatively compared with those of Newtonian fluids (water). The impact of the non-Newtonian behavior on the sliding process was shown through the relation between the average dimensionless velocity (
i.e.
the capillary number) and the dimensionless volume forces (
i.e.
the Bond number). To this aim, it is needed to define operative strategies to compute the capillary number for the shear thinning fluids and compare with the corresponding Newtonian case. The resulting capillary number for the Xanthan solutions scales linearly with the Bond number at small inclinations, as well known for Newtonian fluids, while it shows a plateau as the Bond number is increased. Experimental data were complemented with lattice Boltzmann numerical simulations of sliding droplets, aimed to disentangle the specific contribution of shear thinning and elastic effects on the sliding behavior. In particular the deviation from the linear (Newtonian) trend is more likely attributed to the emergence of normal stresses inside the non-Newtonian droplet.
Graphical abstract
Abstract
The introduction of slippery lubricated surfaces allows for the investigation of the flow of highly viscous fluids, which otherwise will hardly move on standard solid surfaces. Here we ...present the study of the gravity induced motion of small drops of polymeric fluids deposited on inclined lubricated surfaces. The viscosity of these fluids decreases with increasing shear rate (shear thinning) and, more importantly, they exert normal forces on planes perpendicular to shear directions (elasticity). Despite the homogeneity of the surface and of the fluids, drops of sufficiently elastic fluids move downward with an oscillating instantaneous speed whose frequency is found to be directly proportional to the average speed and inversely to the drop volume. The oscillatory motion is caused by the formation of a bulge at the rear of the drop, which will be dragged along the drop free contour by the rolling motion undergone by the drop. This finding can be considered as a kind of new Weissenberg effect applied to moving drops that combines dynamic wetting and polymer rheology.
The actuation of droplets on a surface is extremely relevant for microfluidic applications. In recent years, various methodologies have been used. A promising solution relies on iron-doped lithium ...niobate crystals that, when illuminated, generate an evanescent electric field in the surrounding space due to the photovoltaic effect. This field can be successfully exploited to control the motion of water droplets. Here, we present an experimental method to determine the attractive force exerted by the evanescent field. It consists of the analysis of the elongation of a pendant droplet and its detachment from the suspending syringe needle, caused by the illumination of an iron-doped lithium niobate crystal. We show that this interaction resembles that obtained by applying a voltage between the needle and a metallic substrate, and a quantitative investigation of these two types of actuation yields similar results. Pendant droplet tensiometry is then demonstrated to offer a simple solution for quickly mapping out the force at different distances from the crystal, generated by the photovoltaic effect and its temporal evolution, providing important quantitative data for the design and characterization of optofluidic devices based on lithium niobate crystals.
PDF
