Through combined ferromagnetic resonance, spin pumping, and inverse spin Hall effect experiments in Co|Pt bilayers and Co|Cu|Pt trilayers, we demonstrate consistent values of ℓsfPt=3.4±0.4 nm and ...θSHEPt=0.056±0.010 for the respective spin diffusion length and spin Hall angle for Pt. Our data and model emphasize the partial depolarization of the spin current at each interface due to spin-memory loss. Our model reconciles the previously published spin Hall angle values and explains the different scaling lengths for the ferromagnetic damping and the spin Hall effect induced voltage.
We present results on spin to charge current conversion in experiments of resonant spin pumping into the Dirac cone with helical spin polarization of the elemental topological insulator (TI) α-Sn. By ...angle-resolved photoelectron spectroscopy (ARPES), we first check that the Dirac cone (DC) at the α-Sn (0 0 1) surface subsists after covering Sn with Ag. Then we show that resonant spin pumping at room temperature from Fe through Ag into α-Sn layers induces a lateral charge current that can be ascribed to the inverse Edelstein effect by the DC states. Our observation of an inverse Edelstein effect length much longer than those generally found for Rashba interfaces demonstrates the potential of TIs for the conversion between spin and charge in spintronic devices. By comparing our results with data on the relaxation time of TI free surface states from time-resolved ARPES, we can anticipate the ultimate potential of the TI for spin to charge conversion and the conditions to reach it.
The spin-orbit interaction couples the electrons' motion to their spin. As a result, a charge current running through a material with strong spin-orbit coupling generates a transverse spin current ...(spin Hall effect, SHE) and vice versa (inverse spin Hall effect, ISHE). The emergence of SHE and ISHE as charge-to-spin interconversion mechanisms offers a variety of novel spintronic functionalities and devices, some of which do not require any ferromagnetic material. However, the interconversion efficiency of SHE and ISHE (spin Hall angle) is a bulk property that rarely exceeds ten percent, and does not take advantage of interfacial and low-dimensional effects otherwise ubiquitous in spintronic hetero- and mesostructures. Here, we make use of an interface-driven spin-orbit coupling mechanism-the Rashba effect-in the oxide two-dimensional electron system (2DES) LaAlO
/SrTiO
to achieve spin-to-charge conversion with unprecedented efficiency. Through spin pumping, we inject a spin current from a NiFe film into the oxide 2DES and detect the resulting charge current, which can be strongly modulated by a gate voltage. We discuss the amplitude of the effect and its gate dependence on the basis of the electronic structure of the 2DES and highlight the importance of a long scattering time to achieve efficient spin-to-charge interconversion.
The Rashba effect is an interaction between the spin and the momentum of electrons induced by the spin-orbit coupling (SOC) in surface or interface states. Its potential for conversion between charge ...and spin currents has been theoretically predicted but never clearly demonstrated for surfaces or interfaces of metals. Here we present experiments evidencing a large spin-charge conversion by the Bi/Ag Rashba interface. We use spin pumping to inject a spin current from a NiFe layer into a Bi/Ag bilayer and we detect the resulting charge current. As the charge signal is much smaller (negligible) with only Bi (only Ag), the spin-to-charge conversion can be unambiguously ascribed to the Rashba coupling at the Bi/Ag interface. This result demonstrates that the Rashba effect at interfaces can be used for efficient charge-spin conversion in spintronics.
The spin-orbit coupling relating the electron spin and momentum allows for spin generation, detection and manipulation. It thus fulfils the three basic functions of the spin field-effect transistor. ...However, the spin Hall effect in bulk germanium is too weak to produce spin currents, whereas large Rashba effect at Ge(111) surfaces covered with heavy metals could generate spin-polarized currents. The Rashba spin splitting can actually be as large as hundreds of meV. Here we show a giant spin-to-charge conversion in metallic states at the Fe/Ge(111) interface due to the Rashba coupling. We generate very large charge currents by direct spin pumping into the interface states from 20 K to room temperature. The presence of these metallic states at the Fe/Ge(111) interface is demonstrated by first-principles electronic structure calculations. By this, we demonstrate how to take advantage of the spin-orbit coupling for the development of the spin field-effect transistor.
Cr-doped diamond-like carbon (Cr-DLC) films with Cr contents ranging from 3 up to 20 at. % were synthesised in a codeposition process with HiPIMS (Cr deposition) and DC-pulsed technology (C ...deposition). The application of HiPIMS at low frequencies was observed to significantly enhance the energy density during the Cr plasma discharge due to the interaction of Cr–C species. The higher energy bombardment at low HiPIMS frequencies allowed doping with Cr the DLC structure avoiding the graphitization of the carbon structure. EELS spectroscopy was used to evaluate sp3 content and Raman was used for sp2 structural characterization of the films. Enhanced mechanical properties (hardness up to 30 GPa) were observed with nanoindentation for Cr-doped DLC at low frequencies. High temperature nanoindentation tests were also performed from room temperature to 425 °C in order to evaluate the evolution of hardness and Young Modulus with temperature. The results showed that the mechanical properties at high temperature mainly depend on the initial sp3-sp2 structure. Tribological tests were carried out in air from room temperature to 250 °C. Cr-doped DLC coatings deposited by low-frequency HiPIMS showed lower friction and wear compared to undoped DLC.
•Cr-doped DLC coatings were co-deposited by low-frequency/high current HiPIMS method.•Cr doping by low frequency HiPIMS preserves DLC sp3 content and reduces compressive stress.•Low at. % Cr-doped DLC exhibit high hardness (up to 29 GPa) and delayed graphitization (up to 400 C).•Low at. % Cr-doped DLC presents enhanced tribological behaviour at high temperatures by creating stable tribolayers.
Conversions between charge and spin currents by spin-orbit interactions have become usual in today's spintronics, either by using the spin Hall effect (SHE) and inverse spin Hall effect (ISHE) of ...heavy metals or the Edelstein effect and inverse Edelstein effect of a two-dimensional (2D) electron gas. These conversions can be characterized by the spin Hall angle for SHE or ISHE and by the conversion parameters q IC for EE and λ IEE for IEE. Using typical experimental values of these different parameters for heavy metals and 2D electrons of topological insulators (TIs), we show that, compared to heavy metals, the TIs lead to a gain of about an order of magnitude in the conversion between spin to charge or charge to spin currents and even more in the production of voltage or electrical power by conversion of spin currents. Thus, we anticipate a giant spin Seebeck power generated in devices designed with an insulating magnetic layer and 2DEGs of a TI as α-Sn or Rashba 2DEGs. We also discuss the detrimental role of additional shunts in these conversion experiments.
We describe a huge planetary‐scale disturbance in the highest‐speed Jovian jet at latitude 23.5°N that was first observed in October 2016 during the Juno perijove‐2 approach. An extraordinary ...outburst of four plumes was involved in the disturbance development. They were located in the range of planetographic latitudes from 22.2° to 23.0°N and moved faster than the jet peak with eastward velocities in the range 155 to 175 m s−1. In the wake of the plumes, a turbulent pattern of bright and dark spots (wave number 20–25) formed and progressed during October and November on both sides of the jet, moving with speeds in the range 100–125 m s−1 and leading to a new reddish and homogeneous belt when activity ceased in late November. Nonlinear numerical models reproduce the disturbance cloud patterns as a result of the interaction between local sources (the plumes) and the zonal eastward jet.
Key Points
A planetary‐scale disturbance developed in the highest‐speed Jupiter jet at 23.5°N latitude during October and November 2016
Four “plumes” were involved in the outbreak moving with speeds between 155 and 175 m s−1, the fastest features at cloud level
Nonlinear numerical models reproduce the disturbance from the interaction between local sources (the plumes) and the zonal eastward jet