Outcrop exposures of sedimentary rocks at the Opportunity landing site (Meridiani Planum) form a set of genetically related strata defined here informally as the Burns formation. This formation can ...be subdivided into lower, middle, and upper units which, respectively, represent eolian dune, eolian sand sheet, and mixed eolian sand sheet and interdune facies associations. Collectively, these three units are at least 7 m thick and define a “wetting-upward” succession which records a progressive increase in the influence of groundwater and, ultimately, surface water in controlling primary depositional processes.
The Burns lower unit is interpreted as a dry dune field (though grain composition indicates an evaporitic source), whose preserved record of large-scale cross-bedded sandstones indicates either superimposed bedforms of variable size or reactivation of lee-side slip faces by episodic (possibly seasonal) changes in wind direction. The boundary between the lower and middle units is a significant eolian deflation surface. This surface is interpreted to record eolian erosion down to the capillary fringe of the water table, where increased resistance to wind-induced erosion was promoted by increased sediment cohesiveness in the capillary fringe. The overlying Burns middle unit is characterized by fine-scale planar-laminated to low-angle-stratified sandstones. These sandstones accumulated during lateral migration of eolian impact ripples over the flat to gently undulating sand sheet surface. In terrestrial settings, sand sheets may form an intermediate environment between dune fields and interdune or playa surfaces. The contact between the middle and upper units of the Burns formation is interpreted as a diagenetic front, where recrystallization in the phreatic or capillary zones may have occurred. The upper unit of the Burns formation contains a mixture of sand sheet facies and interdune facies. Interdune facies include wavy bedding, irregular lamination with convolute bedding and possible small tepee or salt-ridge structures, and cm-scale festoon cross-lamination indicative of shallow subaqueous flows marked by current velocities of a few tens of cm/s. Most likely, these currents were gravity-driven, possibly unchannelized flows resulting from the flooding of interdune/playa surfaces. However, evidence for lacustrine sedimentation, including mudstones or in situ bottom-growth evaporites, has not been observed so far at Eagle and Endurance craters.
Mineralogical and elemental data indicate that the eolian sandstones of the lower and middle units, as well as the subaqueous and eolian deposits of the Burns upper unit, were derived from an evaporitic source. This indirectly points to a temporally equivalent playa where lacustrine evaporites or ground-water-generated efflorescent crusts were deflated to provide a source of sand-sized particles that were entrained to form eolian dunes and sand sheets. This process is responsible for the development of sulfate eolianites at White Sands, New Mexico, and could have provided a prolific flux of sulfate sediment at Meridiani. Though evidence for surface water in the Burns formation is mostly limited to the upper unit, the associated sulfate eolianites provide strong evidence for the critical role of groundwater in controlling sediment production and stratigraphic architecture throughout the formation.
The Mars Exploration Rover Panoramic Camera (MER/Pancam) instruments have acquired more than 60,000 high‐resolution, multispectral, stereoscopic images of soil, rocks, and sky at the Gusev crater and ...Meridiani Planum landing sites since January 2004. These images, combined with other MER data sets, have enabled new discoveries about the composition, mineralogy, and geologic/geochemical evolution of both sites. One key to the success of Pancam in contributing to the overall success of MER has been the development of a calibration pipeline that can quickly remove instrumental artifacts and generate both absolute radiance and relative reflectance images with high accuracy and precision in order to influence tactical rover driving and in situ sampling decisions. This paper describes in detail the methods, assumptions, and models/algorithms in the calibration pipeline developed for Pancam images, based on new measurements and refinements performed primarily from flight data acquired on Mars. Major calibration steps include modeling and removal of detector bias signal, active and readout region dark current, electronic “shutter smear,” and pixel‐to‐pixel responsivity (flatfield) variations. Pancam images are calibrated to radiance (W/m2/nm/sr) using refined preflight‐derived calibration coefficients, or radiance factor (I/F) using near‐in‐time measurements of the Pancam calibration target and a model of aeolian dust deposition on the target as a function of time. We are able to verify that the absolute radiance calibration of most Pancam images is accurate to within about 10% or less and that the filter‐to‐filter and pixel‐to‐pixel precision of the calibrated relative reflectance data (both based on measurements of the Pancam calibration target) are typically about 3% and 1% or less, respectively. Examples are also presented of scientific applications made possible by the high fidelity of the calibrated Pancam data. These include 11‐color visible to near‐IR spectral analysis, calculation of “true color” and chromaticity values, and generation of “super resolution” image data products. This work represents a follow‐on and enhancement to the Pancam preflight calibration process described by Bell et al. (2003).
Athena Microscopic Imager investigation Herkenhoff, K. E.; Squyres, S. W.; Bell III, J. F. ...
Journal of Geophysical Research - Planets,
December 2003, Letnik:
108, Številka:
E12
Journal Article
Recenzirano
Odprti dostop
The Athena science payload on the Mars Exploration Rovers (MER) includes the Microscopic Imager (MI). The MI is a fixed‐focus camera mounted on the end of an extendable instrument arm, the Instrument ...Deployment Device (IDD). The MI was designed to acquire images at a spatial resolution of 30 microns/pixel over a broad spectral range (400–700 nm). The MI uses the same electronics design as the other MER cameras but has optics that yield a field of view of 31 × 31 mm across a 1024 × 1024 pixel CCD image. The MI acquires images using only solar or skylight illumination of the target surface. A contact sensor is used to place the MI slightly closer to the target surface than its best focus distance (about 66 mm), allowing concave surfaces to be imaged in good focus. Coarse focusing (∼2 mm precision) is achieved by moving the IDD away from a rock target after the contact sensor has been activated. The MI optics are protected from the Martian environment by a retractable dust cover. The dust cover includes a Kapton window that is tinted orange to restrict the spectral bandpass to 500–700 nm, allowing color information to be obtained by taking images with the dust cover open and closed. MI data will be used to place other MER instrument data in context and to aid in petrologic and geologic interpretations of rocks and soils on Mars.
The Panoramic Camera (Pancam) investigation is part of the Athena science payload launched to Mars in 2003 on NASA's twin Mars Exploration Rover (MER) missions. The scientific goals of the Pancam ...investigation are to assess the high‐resolution morphology, topography, and geologic context of each MER landing site, to obtain color images to constrain the mineralogic, photometric, and physical properties of surface materials, and to determine dust and aerosol opacity and physical properties from direct imaging of the Sun and sky. Pancam also provides mission support measurements for the rovers, including Sun‐finding for rover navigation, hazard identification and digital terrain modeling to help guide long‐term rover traverse decisions, high‐resolution imaging to help guide the selection of in situ sampling targets, and acquisition of education and public outreach products. The Pancam optical, mechanical, and electronics design were optimized to achieve these science and mission support goals. Pancam is a multispectral, stereoscopic, panoramic imaging system consisting of two digital cameras mounted on a mast 1.5 m above the Martian surface. The mast allows Pancam to image the full 360° in azimuth and ±90° in elevation. Each Pancam camera utilizes a 1024 × 1024 active imaging area frame transfer CCD detector array. The Pancam optics have an effective focal length of 43 mm and a focal ratio of f/20, yielding an instantaneous field of view of 0.27 mrad/pixel and a field of view of 16° × 16°. Each rover's two Pancam “eyes” are separated by 30 cm and have a 1° toe‐in to provide adequate stereo parallax. Each eye also includes a small eight position filter wheel to allow surface mineralogic studies, multispectral sky imaging, and direct Sun imaging in the 400–1100 nm wavelength region. Pancam was designed and calibrated to operate within specifications on Mars at temperatures from −55° to +5°C. An onboard calibration target and fiducial marks provide the capability to validate the radiometric and geometric calibration on Mars.
Panoramic Camera images at Gusev crater reveal a rock-strewn surface interspersed with high- to moderate-albedo fine-grained deposits occurring in part as drifts or in small circular swales or ...hollows. Optically thick coatings of fine-grained ferric iron-rich dust dominate most bright soil and rock surfaces. Spectra of some darker rock surfaces and rock regions exposed by brushing or grinding show near-infrared spectral signatures consistent with the presence of mafic silicates such as pyroxene or olivine. Atmospheric observations show a steady decline in dust opacity during the mission, and astronomical observations captured solar transits by the martian moons, Phobos and Deimos, as well as a view of Earth from the martian surface.
Panoramic Camera (Pancam) images from Meridiani Planum reveal a low-albedo, generally flat, and relatively rock-free surface. Within and around impact craters and fractures, laminated outcrop rocks ...with higher albedo are observed. Fine-grained materials include dark sand, bright ferric iron-rich dust, angular rock clasts, and millimeter-size spheroidal granules that are eroding out of the laminated rocks. Spectra of sand, clasts, and one dark plains rock are consistent with mafic silicates such as pyroxene and olivine. Spectra of both the spherules and the laminated outcrop materials indicate the presence of crystalline ferric oxides or oxyhydroxides. Atmospheric observations show a steady decline in dust opacity during the mission. Astronomical observations captured solar transits by Phobos and Deimos and time-lapse observations of sunsets.
PDF
