We present the first experimental evidence supported by simulations of kinetic effects launched in the interpenetration layer between the laser-driven hohlraum plasma bubbles and the corona plasma of ...the compressed pellet at the Shenguang-III prototype laser facility. Solid plastic capsules were coated with carbon-deuterium layers; as the implosion neutron yield is quenched, DD fusion yield from the corona plasma provides a direct measure of the kinetic effects inside the hohlraum. An anomalous large energy spread of the DD neutron signal (∼282 keV) and anomalous scaling of the neutron yield with the thickness of the carbon-deuterium layers cannot be explained by the hydrodynamic mechanisms. Instead, these results can be attributed to kinetic shocks that arise in the hohlraum-wall-ablator interpenetration region, which result in efficient acceleration of the deuterons (∼28.8 J, 0.45% of the total input laser energy). These studies provide novel insight into the interactions and dynamics of a vacuum hohlraum and near-vacuum hohlraum.
Scattering of solar radiation by aerosol particles is highly dependent on relative humidity (RH) as hygroscopic particles take up water with increasing RH. To achieve a better understanding of the ...effect of aerosol hygroscopic growth on light scattering properties and radiative forcing, the aerosol scattering coefficients at RH in the range of 40 to ~ 90 % were measured using a humidified nephelometer system in the Yangtze River Delta of China in March 2013. In addition, the aerosol size distribution and chemical composition were measured. During the observation period, the mean and standard deviation (SD) of enhancement factors at RH = 85 % for the scattering coefficient (f(85 %)), backscattering coefficient (fb(85 %)), and hemispheric backscatter fraction (f beta (85 %)) were 1.58 plus or minus 0.12, 1.25 plus or minus 0.07, and 0.79 plus or minus 0.04, respectively, i.e., aerosol scattering coefficient and backscattering coefficient increased by 58 and 25 % as the RH increased from 40 to 85 %. Concurrently, the aerosol hemispheric backscatter fraction decreased by 21 %. The relative amount of organic matter (OM) or inorganics in PM1 was found to be a main factor determining the magnitude of f(RH). The highest values of f(RH) corresponded to the aerosols with a small fraction of OM, and vice versa. The relative amount of NO3- in fine particles was strongly correlated with f(85 %), which suggests that NO3- played a vital role in aerosol hygroscopic growth during this study. The mass fraction of nitrate also had a close relationship to the curvature of the humidograms; higher mass fractions of nitrate were associated with humidograms that had the least curvature. Aerosol hygroscopic growth caused a 47 % increase in the calculated aerosol direct radiative forcing at 85 % RH, compared to the forcing at 40 % RH.
One of the most promising approaches to reach a high gain in inertial confinement fusion is the fast ignition scheme. In this scheme, a relativistic electron beam is generated; this passes through ...the imploded plasma and deposits parts of its energy in the core. However, the large angular spread of the relativistic electron beam and the poorly controlled compression of the target affect realization of the fast ignition technique. Here, we demonstrate that indirectly driven (that is, driven by X-rays generated inside a gold hohlraum) implosions with a ‘high-foot’ and a short-coast time of less than 200 ps allow us to tightly compress the shell. Furthermore, we show the ability to optimize the symmetry of the imploding shell by changing the hohlraum length, successfully tuning a suitable tube-shaped shell to compensate for the large angular spread of the relativistic electron beam and to enhance the electron-to-core coupling efficiency via resistive magnetic fields. Benefiting from those experimental techniques, a significant enhancement in neutron yield was achieved in our indirectly driven fast ignition experiments. These results pave the way towards high-coupling fast ignition experiments with indirectly driven targets similar to those at the National Ignition Facility.Experiments realizing the indirect-drive fast ignition scheme for inertial confinement fusion are reported. Enabled by a tightly compressed target, an increase of neutron yield is observed.
Stimulation with ultrafast light pulses can realize and manipulate states of matter with emergent structural, electronic and magnetic phenomena. However, these non-equilibrium phases are often ...transient and the challenge is to stabilize them as persistent states. Here, we show that atomic-scale PbTiO
/SrTiO
superlattices, counterpoising strain and polarization states in alternate layers, are converted by sub-picosecond optical pulses to a supercrystal phase. This phase persists indefinitely under ambient conditions, has not been created via equilibrium routes, and can be erased by heating. X-ray scattering and microscopy show this unusual phase consists of a coherent three-dimensional structure with polar, strain and charge-ordering periodicities of up to 30 nm. By adjusting only dielectric properties, the phase-field model describes this emergent phase as a photo-induced charge-stabilized supercrystal formed from a two-phase equilibrium state. Our results demonstrate opportunities for light-activated pathways to thermally inaccessible and emergent metastable states.
Abstract Objective Multi-mode universal adhesives offer clinicians the choice of using the etch-and-rinse technique, selective enamel etch technique or self-etch technique to bond to tooth ...substrates. The present study examined the short-term in vitro performance of five universal adhesives bonded to human coronal dentine. Methods Two hundred non-carious human third molars were assigned to five groups based on the type of the universal adhesives (Prime&Bond Elect, Scotchbond Universal, All-Bond Universal, Clearfil Universal Bond and Futurabond U). Two bonding modes (etch-and-rinse and self-etch) were employed for each adhesive group. Bonded specimens were stored in deionized water for 24 h or underwent a 10,000-cycle thermocycling ageing process prior to testing ( N = 10). Microtensile bond testing (μTBS), transmission electron microscopy (TEM) of resin–dentine interfaces in non-thermocycled specimens and scanning electron microscopy (SEM) of tracer-infused water-rich zones within hybrid layers of thermocycled specimens were performed. Results Both adhesive type and testing condition (with/without thermocycling) have significant influences on μTBS. The use of each adhesive in either the etch-and-rinse or self-etch application mode did not result in significantly different μTBS to dentine. Hybrid layers created by these adhesives in the etch-and-rinse bonding mode and self-etch bonding mode were ∼5 μm and ≤0.5 μm thick respectively. Tracer-infused regions could be identified within the resin–dentine interface from all the specimens prepared. Conclusion The increase in versatility of universal adhesives is not accompanied by technological advances for overcoming the challenges associated with previous generations of adhesives. Therapeutic adhesives with bio-protective and bio-promoting effects are still lacking in commercialized adhesives. Clinical significance Universal adhesives represent manufacturers’ attempt to introduce versatility in product design via adaptation of a single-bottle self-etch adhesive for other application modes without compromising its bonding effectiveness.
High-β_{θe} (a ratio of the electron thermal pressure to the poloidal magnetic pressure) steady-state long-pulse plasmas with steep central electron temperature gradient are achieved in the ...Experimental Advanced Superconducting Tokamak. An intrinsic current is observed to be modulated by turbulence driven by the electron temperature gradient. This turbulent current is generated in the countercurrent direction and can reach a maximum ratio of 25% of the bootstrap current. Gyrokinetic simulations and experimental observations indicate that the turbulence is the electron temperature gradient mode (ETG). The dominant mechanism for the turbulent current generation is due to the divergence of ETG-driven residual flux of current. Good agreement has been found between experiments and theory for the critical value of the electron temperature gradient triggering ETG and for the level of the turbulent current. The maximum values of turbulent current and electron temperature gradient lead to the destabilization of an m/n=1/1 kink mode, which by counteraction reduces the turbulence level (m and n are the poloidal and toroidal mode number, respectively). These observations suggest that the self-regulation system including turbulence, turbulent current, and kink mode is a contributing mechanism for sustaining the steady-state long-pulse high-β_{θe} regime.
The unique immunomodulatory properties of mesenchymal stem cells (MSCs) make them an invaluable cell type for the repair of tissue/ organ damage caused by chronic inflammation or autoimmune ...disorders. Although they hold great promise in the treatment of immune disorders such as graft versus host disease (GvHD) and allergic disorders, there remain many challenges to overcome before their widespread clinical application. An understanding of the biological properties of MSCs will clarify the mechanisms of MSC-based transplantation for immunomodulation. In this review, we summarize the preclinical and clinical studies of MSCs from different adult tissues, discuss the current hurdles to their use and propose the future development of pluripotent stem cell-derived MSCs as an approach to immunomodulation therapy.
Early detection of cancer offers the opportunity to identify candidates when curative treatments are achievable. The THUNDER study (THe UNintrusive Detection of EaRly-stage cancers, NCT04820868) ...aimed to evaluate the performance of enhanced linear-splinter amplification sequencing, a previously described cell-free DNA (cfDNA) methylation-based technology, in the early detection and localization of six types of cancers in the colorectum, esophagus, liver, lung, ovary, and pancreas.
A customized panel of 161 984 CpG sites was constructed and validated by public and in-house (cancer: n = 249; non-cancer: n = 288) methylome data, respectively. The cfDNA samples from 1693 participants (cancer: n = 735; non-cancer: n = 958) were retrospectively collected to train and validate two multi-cancer detection blood test (MCDBT-1/2) models for different clinical scenarios. The models were validated on a prospective and independent cohort of age-matched 1010 participants (cancer: n = 505; non-cancer: n = 505). Simulation using the cancer incidence in China was applied to infer stage shift and survival benefits to demonstrate the potential utility of the models in the real world.
MCDBT-1 yielded a sensitivity of 69.1% (64.8%-73.3%), a specificity of 98.9% (97.6%-99.7%), and tissue origin accuracy of 83.2% (78.7%-87.1%) in the independent validation set. For early-stage (I-III) patients, the sensitivity of MCDBT-1 was 59.8% (54.4%-65.0%). In the real-world simulation, MCDBT-1 achieved a sensitivity of 70.6% in detecting the six cancers, thus decreasing late-stage incidence by 38.7%-46.4%, and increasing 5-year survival rate by 33.1%-40.4%, respectively. In parallel, MCDBT-2 was generated at a slightly low specificity of 95.1% (92.8%-96.9%) but a higher sensitivity of 75.1% (71.9%-79.8%) than MCDBT-1 for populations at relatively high risk of cancers, and also had ideal performance.
In this large-scale clinical validation study, MCDBT-1/2 models showed high sensitivity, specificity, and accuracy of predicted origin in detecting six types of cancers.
•MCDBT-1 had a sensitivity of 69.1% and a specificity of 98.9% in detecting six cancers.•In the real world, MCDBT-1 decreased late-stage incidence by 38.7%-46.4% and increased 5-year survival rate by 33.1%-40.4%.•In parallel, MCDBT-2 was set at a lower specificity but a higher sensitivity than MCDBT-1 and had an ideal performance.
PDF
