In recent years the harmonization of methods in the frame of the International Co-operative Programme on Assessment and Monitoring of Air Pollution Effects on Forests (ICP Forests) operating under ...the UNECE Convention on Long-range Transboundary Air Pollution (CLRTAP) has been intensified. Among the C-actions of the FutMon project (LIFE07 ENV/D/000218; 2009-2010) the C1-Dep-22(SI) action was established with the goal to harmonize and develop the deposition monitoring procedures and sampling methods. The sampling equipment, spatial design of sampling plots and sampling frequency throughout Europe vary considerably. Therefore a step-by-step approach was made where the harmonized sampling equipment was developed and tested first. The selected collectors were installed at one observation plot of each participating country where measurements of throughfall and bulk deposition were run in parallel with the national collectors for a period of one year. To evaluate the agreement between methods, different statistical analyses were used including Altman-Bland plots, model II regression, and repeated measures ANOVA. Preliminary results from the “Intensive forest ecosystem monitoring plot” plot Brdo in NW Slovenia show a good agreement between national and harmonized bulk (both funnel-type) collectors, while comparison of throughfall measurements indicates systematic bias between harmonized (funnel-type) and national (gutter-type) collectors.
.
Two waterborne acrylic coatings were applied on spruce wood, impregnated with two copper-ethanolamine containing preservatives (CuE and CuEQ), one of them (CuEQ) containing a boron compound, ...octanoic acid and a quaternary ammonium compound as additives. Lower contact angles and deeper penetration of both coating types were observed on CuEQ treated, compared to untreated or CuE-treated wood. Improved adhesion of coatings on CuEQ impregnated wood was exhibited as well. In general, characteristics of surface finishes on copper-ethanolamine treated wood were comparable to untreated wood. It was also shown that copper leaching from the preserved wood was significantly reduced by application of the surface finishes.
Cu–ethanolamine-based preservatives are currently the most important alternatives for classical chromated-copper formulation. However, emissions of Cu from wood impregnated with ...copper–ethanolamine-based preservatives are still higher compared to emissions from wood preserved with copper–chromium based preservatives. In order to elucidate leaching of copper from specimens treated (brushed, soaked or vacuum-impregnated) with different copper–ethanolamine containing biocides of two different concentrations the following research on specimens made of Norway spruce (
Picea abies), Scotch pine (
Pinus sylvestris) and Beech (
Fagus sylvatica) were performed. The results showed that leaching is significantly affected by the wood species used. The lowest leaching rates were determined in specimens made of spruce, while the highest ones were determined in beech wood. Concentration of active ingredient influences the Cu fixation as well. Unfortunately, ethanolamine at higher concentration causes depolymerisation of lignin macromolecules, which results in increased copper leaching.
Market share of copper–ethanolamine-based wood preservatives is increasing in the past decade; despite of the fact that copper fixation is still not comparable to fixation of copper–chromium-based ...ones. One of the reasons for increased emissions originates in ethanolamine. Ethanolamine excesses depolymerizes lignin macromolecule, what consequence in higher leaching rates. In order to eliminate this negative influence of ethanolamine, Norway spruce wood blocks were impregnated with three different copper–ethanolamine solutions of three concentrations. After impregnation, specimens were dried at four different temperatures (25, 50, 75 and 103
°C) and, afterwards, leached according to the modified ENV 1250 procedure. The results showed that increased temperatures during fixation did not decrease but increased copper leaching. It is presumed that the main reason for observed fact is ethanolamine, which did not evaporate from wood. Unfortunately, increased temperatures dramatically increase lignin depolymerization, as well as copper leaching.
Due to the limited use of classical copper/chromium based preservatives, the industry seeks for alternatives for preservation of wood in ground applications. For such purposes, fungicides fixed in ...wood are utilised. For estimation of fixation, standard method that prescribes small specimens with higher portion of axial surfaces than in practice is utilised. The purpose of this article is to determine copper leaching from different anatomical planes.Orientated Norway spruce wood blocks were impregnated with aqueous solution of copper(II) sulphate and commercial preservative Silvanolin. The results showed comparable leaching from radial and tangential surfaces. However, more prominent leaching of copper(II) sulphate at higher concentrations and less extensive leaching of Silvanolin from axial surfaces was established.
PDF
