E-viri
Recenzirano
-
Ahmadian, M.; Wexler, D.; Chandra, T.; Calka, A.
International journal of refractory metals & hard materials, 05/2005, Letnik: 23, Številka: 3Journal Article
The abrasion resistance of WC-4Ovol%(FeAl-B), WC-4Ovol%(Ni3Al-B), and WC-4Ovol%Co, prepared from ultra fine precursor powders and processed by uniaxial hot pressing, has been investigated using a pin-on-drum tester. Intermetallic binders, with different amount of boron including 0, 250, 500, 750, and 1000 ppm B, were prepared in ultrafine form under controlled atmosphere using ring grinding, blended with submicron (0.8 mm) WC powder and then uniaxially hot pressed at 1500 DGC under a pressure of 20 MPa for 4 min in 10-2 MPa argon atmosphere. In an additional investigation, wear results were compared with that of commercial H1OF (WC-lOwt%Co, WC particle size of 0.7 mm). It was found that the wear resistance of WC-FeAl-B and WC-Ni3Al-B increased with the increasing amount of boron. WC-4Ovol%FeAl-B showed the highest abrasion resistance, close to that for WC-lOwt%Co (H1OF) composite, followed by WC-40vol%Ni3Al-B and WC-4Ovol%Co.
Vnos na polico
Trajna povezava
- URL:
Faktor vpliva
Dostop do baze podatkov JCR je dovoljen samo uporabnikom iz Slovenije. Vaš trenutni IP-naslov ni na seznamu dovoljenih za dostop, zato je potrebna avtentikacija z ustreznim računom AAI.
Leto | Faktor vpliva | Izdaja | Kategorija | Razvrstitev | ||||
---|---|---|---|---|---|---|---|---|
JCR | SNIP | JCR | SNIP | JCR | SNIP | JCR | SNIP |
Baze podatkov, v katerih je revija indeksirana
Ime baze podatkov | Področje | Leto |
---|
Povezave do osebnih bibliografij avtorjev | Povezave do podatkov o raziskovalcih v sistemu SICRIS |
---|
Vir: Osebne bibliografije
in: SICRIS
To gradivo vam je dostopno v celotnem besedilu. Če kljub temu želite naročiti gradivo, kliknite gumb Nadaljuj.