E-viri
Recenzirano
Odprti dostop
-
Abdallah, Mohammad; Al Mahmoud, Firas; Khelil, Abdelouahab; Mercier, Julien; Almassri, Belal
Composite structures, 06/2020, Letnik: 242Journal Article
This paper deals with strengthening statically indeterminate reinforced concrete (RC) beams with carbon and glass Fiber Reinforced Polymers (FRP) rods by using the Near Surface Mounted (NSM) technique. The test program consisted of six two-span beams; one control beam, which had exploited for comparison purposes, and five others initially strengthened in flexure with NSM-FRP rods in both hogging and sagging regions. The main test parameters were type, ratio and length of the FRP bars as well as characteristics of the filling material. The study presents and discusses their impacts on the global flexural behavior of continuous RC beam that mainly includes investigating the overall capacity, failure mode, moment redistribution and ductility state. All NSM-FRP strengthened beams displayed higher overall capacity than the control beam; the test results showed that implementing the NSM technique in an appropriate way could significantly improve the yielding capacity and load-carrying capacity of RC beams without large decrease in the ductility index or the moment redistribution degree despite the non-conventional failure mode. The beam failure was primary affected by the strengthening length; terminating the FRP bars before the zero moment point caused to change the failure mode from pull out of the FRP bars to premature peeling off of the concrete cover. On the other hand, moment redistribution and ductility of the NSM-FRP beams were negatively affected by: (I) Increasing the FRP reinforcement, (II) Decreasing the FRP length or (III) Using mortar as a filling material instead of epoxy-resin. Adopting a nonlinear analysis of the cross-sections could accurately quantify the moment–curvature and the ultimate load of the NSM-FRP continuous beams.
![loading ... loading ...](themes/default/img/ajax-loading.gif)
Vnos na polico
Trajna povezava
- URL:
Faktor vpliva
Dostop do baze podatkov JCR je dovoljen samo uporabnikom iz Slovenije. Vaš trenutni IP-naslov ni na seznamu dovoljenih za dostop, zato je potrebna avtentikacija z ustreznim računom AAI.
Leto | Faktor vpliva | Izdaja | Kategorija | Razvrstitev | ||||
---|---|---|---|---|---|---|---|---|
JCR | SNIP | JCR | SNIP | JCR | SNIP | JCR | SNIP |
Baze podatkov, v katerih je revija indeksirana
Ime baze podatkov | Področje | Leto |
---|
Povezave do osebnih bibliografij avtorjev | Povezave do podatkov o raziskovalcih v sistemu SICRIS |
---|
Vir: Osebne bibliografije
in: SICRIS
To gradivo vam je dostopno v celotnem besedilu. Če kljub temu želite naročiti gradivo, kliknite gumb Nadaljuj.