Introduction of the new ecologically accepted cutting fluids in the machining processes. Part II
Soković, Mirko ; Kopač, Janez, 1949-
ǂThe ǂdevelopment of environmentally clean manufacturing technologies requires careful and circumstantial analysis especially on the field of cutting fluids. The development of additives for cutting ...fluids has led to new products, which are used in specific machining procedures such as tapping. In this paper an analysis of the ecological parameters of the cutting fluids and its influence on the machinability parameters is shown. Some results of machinability tests, which were done in tapping threads into standard reference steel C 45 E4 and Al-alloy AlMgSiPbBi for free cutting show how it is possible to achieve accaptable machinability parameters by use of new environment - friendly cutting fluid.
It was not necessary to add the material to the shelf.
Bibliographic material was successfully added on shelf.
Adding bibliographical material on shelf was not successful.
Material is already on the shelf.
Permalink
URL:
Impact factor
Access to the JCR database is permitted only to users from Slovenia. Your current IP address is not on the list of IP addresses with access permission, and authentication with the relevant AAI accout is required.
Year
Impact factor
Edition
Category
Classification
JCR
SNIP
JCR
SNIP
JCR
SNIP
JCR
SNIP
Select the library membership card:
DRS,
in which the journal is indexed
Database name
Field
Year
Links to authors' personal bibliographies
Links to information on researchers in the SICRIS system
Subject headings in COBISS General List of Subject Headings
Select pickup location
The material from the parent unit is free. If the material is delivered to the pickup location from another unit, the library may charge you for this service.
