In the event of a widespread radiological incident, thousands of individuals will require rapid assessment of exposure using validated biodosimetry assays to inform clinical triage. In this scenario, ...multiple biodosimetry laboratories may be necessary for large-volume sample processing. To meet this need, we have developed a high-throughput assay for the rapid measurement of intracellular protein biomarkers in human peripheral blood samples using an Imaging Flow Cytometry (IFC) platform. The objective of this work was to harmonize and validate the reproducibility of our blood biomarker assay for radiation exposure across three IFC instruments, two located at Columbia University (CU) and the third at Health Canada. The Center for Radiological Research (CRR) at CU served as the central laboratory and reference instrument, where samples were prepared in triplicate, labeled with two radiation responsive leukocyte biomarkers (BAX and phosphor-p53 (Ser37)), and distributed for simultaneous interrogation by each IFC. Initial tests showed that significantly different baseline biomarker measurements were generated on each instrument when using the same acquisition settings, suggesting that harmonization of signal intensities is necessary. Subsequent tests harmonized biomarker measurements after irradiation by modulating laser intensity using two reference materials: unstained samples and standardized rainbow beads. Both methods generated measurements on each instrument without significant differences between the new and references instruments, allowing for the use of one master template to quantify biomarker expression across multiple instruments. Deming regression analyses of 0-5 Gy dose-response curves showed overall good correlation of BAX and p53 values across new and reference instruments. While Bland-Altman analyses indicated low to moderate instrument biases, ROC Curve analyses ultimately show successful discrimination between exposed and unexposed samples on each instrument (AUC values > 0.85).
The dose of ionizing radiation received by an individual can be determined using biodosimetry methods which measure biomarkers of exposure in tissue samples from that individual. These markers can be ...expressed in many ways, including DNA damage and repair processes. Following a mass casualty event involving radiological or nuclear material, it is important to rapidly provide this information to medical responders to assist in the medical management of potentially exposed casualties. Traditional methods of biodosimetry rely on microscope analysis, making them time-consuming and labor-intensive. To increase sample throughput following a large-scale radiological mass casualty event, several biodosimetry assays have been adapted for analysis by imaging flow cytometry. This chapter briefly reviews these methods with a focus on the most current methodology to identify and quantify micronuclei in binucleated cells within the cytokinesis-block micronucleus assay using an imaging flow cytometer.
Abstract
Biomarkers for ionising radiation exposure have great utility in scenarios where there has been a potential exposure and physical dosimetry is missing or in dispute, such as for occupational ...and accidental exposures. Biomarkers that respond as a function of dose are particularly useful as biodosemeters to determine the dose of radiation to which an individual has been exposed. These dose measurements can also be used in medical scenarios to track doses from medical exposures and even have the potential to identify an individual’s response to radiation exposure that could help tailor treatments. The measurement of biomarkers of exposure in medicine and for accidents, where a larger number of samples would be required, is limited by the throughput of analysis (i.e. the number of samples that could be processed and analysed), particularly for microscope-based methods, which tend to be labour-intensive. Rapid analysis in an emergency scenario, such as a large-scale accident, would provide dose estimates to medical practitioners, allowing timely administration of the appropriate medical countermeasures to help mitigate the effects of radiation exposure. In order to improve sample throughput for biomarker analysis, much effort has been devoted to automating the process from sample preparation through automated image analysis. This paper will focus mainly on biological endpoints traditionally analysed by microscopy, specifically dicentric chromosomes, micronuclei and gamma-H2AX. These endpoints provide examples where sample throughput has been improved through automated image acquisition, analysis of images acquired by microscopy, as well as methods that have been developed for analysis using imaging flow cytometry.
Display omitted
•The CBMN cytome assay is typically performed by visual microscopy.•The assay includes three biomarkers of DNA damage (MN, NPB, NBUD).•The assay also includes three biomarkers of ...cytotoxicity (NDI, necrosis, apoptosis).•Automated microscopy or flow cytometry cannot score the full range of biomarkers.•Performing the assay by imaging flow cytometry may overcome these limitations.
The lymphocyte Cytokinesis-Block Micronucleus (CBMN) assay was originally developed for the measurement of micronuclei (MN) exclusively in binucleated (BN) cells, which represent the population of cells that can express MN because they completed nuclear division. Recently the assay has evolved into a comprehensive cytome method to include biomarkers that measure chromosomal instability and cytotoxicity by quantification of nuclear buds (NBUDs), nucleoplasmic bridges (NPBs) and apoptotic/necrotic cells. Furthermore, enumeration of mono- and polynucleated cells allows for computation of the nuclear division index (NDI) to assess mitotic activity. Typically performed by manual microscopy, the CBMN cytome assay is laborious and subject to scorer bias and fatigue, leading to inter- and intra-scorer variability. Automated microscopy and conventional flow cytometry methods have been developed to automate scoring of the traditional and cytome versions of the assay. However, these methods have several limitations including the requirement to create high-quality microscope slides, lack of staining consistency and sub-optimal nuclear/cytoplasmic visualization. In the case of flow cytometry, stripping of the cytoplasmic membrane makes it impossible to measure MN in BN cells, calculate the NDI or to quantify apoptotic or necrotic cells. Moreover, the absence of cellular visualization using conventional flow cytometry, makes it impossible to quantify NBUDs and NPBs. In this review, we propose that imaging flow cytometry (IFC), which combines high resolution microscopy with flow cytometry, may overcome these limitations. We demonstrate that by using IFC, images from cells in suspension can be captured, removing the need for microscope slides and allowing visualization of intact cytoplasmic membranes and DNA content. Thus, mono-, bi- and polynucleated cells with and without MN can be rapidly and automatically identified and quantified. Finally, we present high-resolution cell images containing NBUDs and NPBs, illustrating that IFC possesses the potential for completely automated scoring of all components of the CBMN cytome assay.
The cytokinesis-block micronucleus assay is a well-established method to assess radiation-induced genetic damage in human cells. This assay has been adapted to imaging flow cytometry (IFC), allowing ...automated analysis of many cells, and eliminating the need to create microscope slides. Furthermore, to improve the efficiency of assay performance, a small-volume method previously developed was employed. Irradiated human blood samples were cultured, stained, and analyzed by IFC to produce images of the cells. Samples were run using both manual and 96-well plate automated acquisition. Multiple parameter-based image features were collected for each sample, and the results were compared to confirm that these acquisition methods are functionally identical. This paper details the multi-parametric analysis developed and the resulting calibration curves up to 10 Gy. The calibration curves were created using a quadratic random coefficient model with Poisson errors, as well as a logistic discriminant function. The curves were then validated with blinded, irradiated samples, using relative bias and relative mean square error. Overall, the accuracy of the dose estimates was adequate for triage dosimetry (within 1 Gy of the true dose) over 90% of the time for lower doses and about half the time for higher doses, with the lowest success rate between 5 and 6 Gy where the calibration curve reached its peak and there was the smallest change in MN/BNC with dose. This work describes the application of a novel multi-parametric analysis that fits the calibration curves and allows dose estimates up to 10 Gy, which were previously limited to 4 Gy. Furthermore, it demonstrates that the results from samples acquired manually and with the autosampler are functionally similar.
The cytokinesis-block micronucleus (CBMN) assay has become a fully-validated and standardized method for radiation biodosimetry. The assay is typically performed using microscopy, which is labor ...intensive, time consuming and impractical after a large-scale radiological/nuclear event. Imaging flow cytometry (IFC), which combines the statistical power of traditional flow cytometry with the sensitivity and specificity of microscopy, has been recently used to perform the CBMN assay. Since this technology is capable of automated sample acquisition and multi-file analysis, we have integrated IFC into our Rapid Automated Biodosimetry Technology (RABiT-II). Assay development and optimization studies were designed to increase the yield of binucleated cells (BNCs), and improve data acquisition and analysis templates to increase the speed and accuracy of image analysis. Human peripheral blood samples were exposed ex vivo with up to 4 Gy of c rays at a dose rate of 0.73 Gy/min. After irradiation, samples were transferred to microtubes (total volume of 1 ml including blood and media) and organized into a standard 8 × 12 plate format. Sample processing methods were modified by increasing the blood-to-media ratio, adding hypotonic solution prior to cell fixation and optimizing nuclear DRAQ5 staining, leading to an increase of 81% in BNC yield. Modification of the imaging processing algorithms within IFC software also improved BNC and MN identification, and reduced the average time of image analysis by 78%. Finally, 50 ll of irradiated whole blood was cultured with 200 ll of media in 96-well plates. All sample processing steps were performed automatically using the RABiT-II cell: :explorer robotic system adopting the optimized IFC-CBMN assay protocol. The results presented here detail a novel, high-throughput RABiT-IFC CBMN assay that possesses the potential to increase capacity for triage biodosimetry during a large-scale radiological/nuclear event.
The cytokinesis-block micronucleus assay can be employed in triage radiation biodosimetry to determine the dose of radiation to an exposed individual by quantifying the frequency of micronuclei in ...binucleated lymphocyte cells. Partially automated analysis of the assay has been applied to traditional microscope-based methods, and most recently, the assay has been adapted to an automated imaging flow cytometry method. This method is able to automatically score a larger number of binucleated cells than are typically scored by microscopy. Whole blood samples were irradiated, divided into 2 mL and 200 μL aliquots, cultured for 48 h and 72 h, and processed to generate calibration curves from 0-4 Gy. To validate the method for use in radiation biodosimetry, nine separate whole blood samples were then irradiated to known doses, blinded, and processed. Results indicate that dose estimations can be determined to within ±0.5 Gy of the delivered dose after only 48 h of culture time with an initial blood volume of 200 μL. By performing the cytokinesis-block micronucleus assay using imaging flow cytometry, a significant reduction in the culture time and volume requirements is possible, which greatly increases the applicability of the assay in high throughput triage radiation biodosimetry.
Abstract
Purpose: To evaluate the importance of annual intercomparisons for maintaining the capacity and capabilities of a well-established biodosimetry network in conjunction with assessing ...efficient and effective analysis methods for emergency response.
Materials and methods: Annual intercomparisons were conducted between laboratories in the Canadian National Biological Dosimetry Response Plan. Intercomparisons were performed over a six-year period and comprised of the shipment of 10-12 irradiated, blinded blood samples for analysis by each of the participating laboratories. Dose estimates were determined by each laboratory using the dicentric chromosome assay (conventional and QuickScan scoring) and where possible the cytokinesis block micronucleus (CBMN) assay. Dose estimates were returned to the lead laboratory for evaluation and comparison.
Results: Individual laboratories performed comparably from year to year with only slight fluctuations in performance. Dose estimates using the dicentric chromosome assay were accurate about 80% of the time and the QuickScan method for scoring the dicentric chromosome assay was proven to reduce the time of analysis without having a significant effect on the dose estimates. Although analysis with the CBMN assay was comparable to QuickScan scoring with respect to speed, the accuracy of the dose estimates was greatly reduced.
Conclusions: Annual intercomparisons are necessary to maintain a network of laboratories for emergency response biodosimetry as they evoke confidence in their capabilities.
Biodosimetry is a method for measuring the dose of radiation to individuals using biological markers such as chromosome damage. Following mass casualty events, it is important to provide this ...information rapidly in order to assist with the medical management of potentially exposed casualties. Currently, the gold standard for biodosimetry is the dicentric chromosome assay, which accurately estimates the dose from the number of dicentric chromosomes in lymphocytes. To increase throughput of analysis following a large-scale mass casualty event, this assay has been adapted for use on the imaging flow cytometer. This chapter describes the methods for the identification and quantification of mono- and multicentric chromosomes using the imaging flow cytometer.
Display omitted
•Centromeres are visualized by FISH to a highly sensitive and specified PNA probe.•DNA content and centromeres are visualized using DRAQ5 and a PNA probe.•Individual chromosomes are ...identified and quantified using imaging flow cytometry.•Possible applications in biodosimetry by scoring mono- and dicentric chromosomes.
Biodosimetry is an important tool for triage in the case of large-scale radiological or nuclear emergencies, but traditional microscope-based methods can be tedious and prone to scorer fatigue. While the dicentric chromosome assay (DCA) has been adapted for use in triage situations, it is still time-consuming to create and score slides. Recent adaptations of traditional biodosimetry assays to imaging flow cytometry (IFC) methods have dramatically increased throughput. Additionally, recent improvements in image analysis algorithms in the IFC software have resulted in improved specificity for spot counting of small events. In the IFC method for the dicentric chromosome analysis (FDCA), lymphocytes isolated from whole blood samples are cultured with PHA and Colcemid. After incubation, lymphocytes are treated with a hypotonic solution and chromosomes are isolated in suspension, labelled with a centromere marker and stained for DNA content with DRAQ5. Stained individual chromosomes are analyzed on the ImageStream®X (EMD-Millipore, Billerica, MA) and mono- and dicentric chromosome populations are identified and enumerated using advanced image processing techniques. Both the preparation of the isolated chromosome suspensions as well as the image analysis methods were fine-tuned in order to optimize the FDCA. In this paper we describe the method to identify and score centromeres in individual chromosomes by IFC and show that the FDCA method may further improve throughput for triage biodosimetry in the case of large-scale radiological or nuclear emergencies.
PDF
