-
Percentage of harmful discharges for surface current density monitoring in electrical discharge machining processBlatnik, Oki ; Valentinčič, Joško ; Junkar, MihaelElectrical discharge machining (EDM) is performed in the gap between the workpiece (usually the anode) and the electrode (usually the cathode). The gapis filled with a dielectric and the pulses ... generated by a special generatorcause an electrical breakdown in the gap. A breakdown discharge occurs which removes material from the workpiece. The EDM process has been used for more than 50 years, but the influence of the surface current density on the process stability is not well understood. The surface current density is very important in the case of the machining of rough surfaces where the highest material removal rate (MRR) is preferred. For a given eroding surface there exists an optimal electrical current at which the highest MRR is achieved. It is reported in the literature that the percentage of the discharges that are harmful to the EDM process depends on the surface current density in the gap. Thus, experiments were performed to find out the possibility of using the percentage of harmful discharges to monitor the surface current density of the EDM process.Vir: Proceedings of the Institution of Mechanical Engineers. Part B, Journal of engineering manufacture. - ISSN 0954-4054 (Letn. 221, št. 12, 2007, str. 1677-1684)Vrsta gradiva - članek, sestavni delLeto - 2007Jezik - angleškiCOBISS.SI-ID - 10335515
Avtor
Blatnik, Oki |
Valentinčič, Joško |
Junkar, Mihael
Teme
elektroerozivne obdelave |
obdelave površin |
grobe obdelave |
električni tok |
gostota toka |
stabilnost procesov |
obraba orodij |
electrical discharge machining process |
spark erosion |
discrimination |
surface current density |
rough machining |
machining surface |
process stability |
tool wear
Vnos na polico
Trajna povezava
- URL:
Faktor vpliva
Dostop do baze podatkov JCR je dovoljen samo uporabnikom iz Slovenije. Vaš trenutni IP-naslov ni na seznamu dovoljenih za dostop, zato je potrebna avtentikacija z ustreznim računom AAI.
Leto | Faktor vpliva | Izdaja | Kategorija | Razvrstitev | ||||
---|---|---|---|---|---|---|---|---|
JCR | SNIP | JCR | SNIP | JCR | SNIP | JCR | SNIP |
Baze podatkov, v katerih je revija indeksirana
Ime baze podatkov | Področje | Leto |
---|
Povezave do osebnih bibliografij avtorjev | Povezave do podatkov o raziskovalcih v sistemu SICRIS |
---|---|
Blatnik, Oki | 26038 |
Valentinčič, Joško | 18553 |
Junkar, Mihael | 09006 |
Izberite prevzemno mesto:
Prevzem gradiva po pošti
Obvestilo
Gesla v Splošnem geslovniku COBISS
Izbira mesta prevzema
Mesto prevzema | Status gradiva | Rezervacija |
---|
Prosimo, počakajte trenutek.