The design of wireless information and power transfer (WIPT) has so far relied on an oversimplified and inaccurate linear model of the energy harvester. In this paper, we depart from this linear ...model and design WIPT considering the rectifier nonlinearity. We develop a tractable model of the rectifier nonlinearity that is flexible enough to cope with general multicarrier modulated input waveforms. Leveraging that model, we motivate and introduce a novel WIPT architecture relying on the superposition of multicarrier unmodulated and modulated waveforms at the transmitter. The superposed WIPT waveforms are optimized as a function of the channel state information so as to characterize the rate-energy region of the whole system. Analysis and numerical results illustrate the performance of the derived waveforms and WIPT architecture and highlight that nonlinearity radically changes the design of WIPT. We make key and refreshing observations. First, analysis (confirmed by circuit simulations) shows that modulated and unmodulated waveforms are not equally suitable for wireless power delivery, namely, modulation being beneficial in single-carrier transmissions but detrimental in multicarrier transmissions. Second, a multicarrier unmodulated waveform (superposed to a multicarrier modulated waveform) is useful to enlarge the rate-energy region of WIPT. Third, a combination of power splitting and time sharing is in general the best strategy. Fourth, a nonzero mean Gaussian input distribution outperforms the conventional capacity-achieving zero-mean Gaussian input distribution in multicarrier transmissions. Fifth, the rectifier nonlinearity is beneficial to system performance and is essential to efficient WIPT design.
This paper investigates joint wireless information and energy transfer in a two-user MIMO interference channel, in which each receiver either decodes the incoming information data (information ...decoding, ID) or harvests the RF energy (energy harvesting, EH) to operate with a potentially perpetual energy supply. In the two-user interference channel, we have four different scenarios according to the receiver mode - (I D1 , I D2 ), (E H1 , E H2 ), (E H1 , I D2 ), and (I D1 , E H2 ). While the maximum information bit rate is unknown and finding the optimal transmission strategy is still open for (I D1 , I D2 ), we have derived the optimal transmission strategy achieving the maximum harvested energy for (E H1 , E H2 ). For (E H1 , I D2 ), and (I D1 , E H2 ), we find a necessary condition of the optimal transmission strategy and, accordingly, identify the achievable rate-energy (R-E) tradeoff region for two transmission strategies that satisfy the necessary condition - maximum energy beamforming (MEB) and minimum leakage beamforming (MLB). Furthermore, a new transmission strategy satisfying the necessary condition - signal-to-leakage-and-energy ratio (SLER) maximization beamforming - is proposed and shown to exhibit a better R-E region than the MEB and the MLB strategies. Finally, we propose a mode scheduling method to switch between (E H1 , I D2 ) and (I D1 , E H2 ) based on the SLER.
Radiative wireless power transfer (WPT) is a promising technology to provide cost-effective and real-time power supplies to wireless devices. Although radiative WPT shares many similar ...characteristics with the extensively studied wireless information transfer or communication, they also differ significantly in terms of design objectives, transmitter/receiver architectures and hardware constraints, and so on. In this paper, we first give an overview on the various WPT technologies, the historical development of the radiative WPT technology and the main challenges in designing contemporary radiative WPT systems. Then, we focus on the state-of-the-art communication and signal processing techniques that can be applied to tackle these challenges. Topics discussed include energy harvester modeling, energy beamforming for WPT, channel acquisition, power region characterization in multi-user WPT, waveform design with linear and non-linear energy receiver model, safety and health issues of WPT, massive multiple-input multiple-output and millimeter wave enabled WPT, wireless charging control, and wireless power and communication systems co-design. We also point out directions that are promising for future research.
Channel-adaptive waveforms for wireless power transfer significantly boost the dc power level at the rectifier output. However, the design of those waveforms is computationally complex and does not ...lend itself easily to practical implementation. We here propose a low-complexity channel-adaptive waveform design whose performance is very close to that of the optimal design. Performance evaluations confirm the advantages of the new design in various rectifier topologies, with gains in dc output power of 100% over conventional waveforms.
Radio waves carry both energy and information simultaneously. Nevertheless, radio-frequency (RF) transmissions of these quantities have traditionally been treated separately. Currently, the community ...is experiencing a paradigm shift in wireless network design, namely, unifying wireless transmission of information and power so as to make the best use of the RF spectrum and radiation as well as the network infrastructure for the dual purpose of communicating and energizing. In this paper, we review and discuss recent progress in laying the foundations of the envisioned dual purpose networks by establishing a signal theory and design for wireless information and power transmission (WIPT) and identifying the fundamental tradeoff between conveying information and power wirelessly. We start with an overview of WIPT challenges and technologies, namely, simultaneous WIPT (SWIPT), wirelessly powered communication networks (WPCNs), and wirelessly powered backscatter communication (WPBC). We then characterize energy harvesters and show how WIPT signal and system designs crucially revolve around the underlying energy harvester model. To that end, we highlight three different energy harvester models, namely, one linear model and two nonlinear models, and show how WIPT designs differ for each of them in single-user and multi-user deployments. Topics discussed include rate-energy region characterization, transmitter and receiver architectures, waveform design, modulation, beamforming and input distribution optimizations, resource allocation, and RF spectrum use. We discuss and check the validity of the different energy harvester models and the resulting signal theory and design based on circuit simulations, prototyping, and experimentation. We also point out numerous directions that are promising for future research.
Space-division multiple access (SDMA) utilizes linear precoding to separate users in the spatial domain and relies on
fully
treating any residual multi-user interference as noise. Non-orthogonal ...multiple access (NOMA) uses linearly precoded superposition coding with successive interference cancellation (SIC) to superpose users in the power domain and relies on user grouping and ordering to enforce some users to fully decode and cancel interference created by other users.
In this paper, we argue that to efficiently cope with the high throughput, heterogeneity of quality of service (QoS), and massive connectivity requirements of future multi-antenna wireless networks, multiple access design needs to depart from those two extreme interference management strategies, namely fully treat interference as noise (as in SDMA) and fully decode interference (as in NOMA).
Considering a multiple-input single-output broadcast channel, we develop a novel multiple access framework, called rate-splitting multiple access (RSMA). RSMA is a more general and more powerful multiple access for downlink multi-antenna systems that contains SDMA and NOMA as special cases. RSMA relies on linearly precoded rate-splitting with SIC to decode part of the interference and treat the remaining part of the interference as noise. This capability of RSMA to
partially
decode interference and partially treat interference as noise enables to softly bridge the two extremes of fully decoding interference and treating interference as noise and provides room for rate and QoS enhancements and complexity reduction.
The three multiple access schemes are compared, and extensive numerical results show that RSMA provides a smooth transition between SDMA and NOMA and outperforms them both in a wide range of network loads (underloaded and overloaded regimes) and user deployments (with a diversity of channel directions, channel strengths, and qualities of channel state information at the transmitter). Moreover, RSMA provides rate and QoS enhancements over NOMA at a lower computational complexity for the transmit scheduler and the receivers (number of SIC layers).
This letter focuses on integrating rate-splitting multiple-access (RSMA) with time-division-duplex Cell-free Massive MIMO (multiple-input multiple-output) for massive machine-type communications. Due ...to the large number of devices, their sporadic access behaviour and limited coherence interval, we assume a random access strategy with all active devices utilizing the same pilot for uplink channel estimation. This gives rise to a highly pilot-contaminated scenario, which inevitably deteriorates channel estimates. Motivated by the robustness of RSMA towards imperfect channel state information, we propose a novel RSMA-assisted downlink transmission framework for cell-free massive MIMO. On the basis of the downlink achievable spectral efficiency of the common and private streams, we devise a heuristic common precoder design and propose a novel max-min power control method for the proposed RSMA-assisted scheme. Numerical results show that RSMA effectively mitigates the effect of pilot contamination in the downlink and achieves a significant performance gain over a conventional cell-free massive MIMO network.
Wireless power transfer (WPT) is an emerging paradigm that will enable using wireless to its full potential in future networks, not only to convey information but also to deliver energy. Such ...networks will enable trillions of future low-power devices to sense, compute, connect, and energize anywhere, anytime, and on the move. The design of such future networks brings new challenges and opportunities for signal processing, machine learning, sensing, and computing. The objective is to make the best use of the RF radiations, spectrum, and network infrastructure to provide cost-effective and real-time power supplies to wireless devices and enable wireless-powered applications. In this paper, we first review recent signal processing techniques to make WPT and wireless information and power transfer (WIPT) as efficient as possible. Topics include high-power amplifier and energy harvester nonlinearities, active and passive beamforming, intelligent reflecting surfaces, receive combining with multi-antenna harvester, modulation, coding, waveform, large-scale (massive) multiple-input multiple-output (MIMO), channel acquisition, transmit diversity, multi-user power region characterization, coordinated multipoint, and distributed antenna systems. Then, we overview two different design methodologies: the model and optimize approach relying on analytical system models, modern convex optimization, and communication/information theory, and the learning approach based on data-driven end-to-end learning and physics-based learning. We discuss the pros and cons of each approach, especially when accounting for various nonlinearities in wireless-powered networks, and identify interesting emerging opportunities for the approaches to complement each other. Finally, we identify new emerging wireless technologies where WPT may play a key role-wireless-powered mobile edge computing, wireless-powered sensing, and wireless-powered federated learning-arguing WPT, communication, computation, sensing, and learning must be jointly designed.
In order to efficiently cope with the high throughput, reliability, heterogeneity of Quality-of-Service (QoS), and massive connectivity requirements of future 6G multi-antenna wireless networks, ...multiple access and multiuser communication system design need to depart from conventional interference management strategies, namely fully treat interference as noise (as commonly used in 4G/5G, MU-MIMO, CoMP, Massive MIMO, millimetre wave MIMO) and fully decode interference (as in Non-Orthogonal Multiple Access, NOMA). This paper is dedicated to the theory and applications of a more general and powerful transmission framework based on Rate-Splitting Multiple Access (RSMA) that splits messages into common and private parts and enables to partially decode interference and treat remaining part of the interference as noise. This enables RSMA to softly bridge and therefore reconcile the two extreme strategies of fully decode interference and treat interference as noise and provide room for spectral efficiency, energy efficiency and QoS enhancements, robustness to imperfect Channel State Information at the Transmitter (CSIT), and complexity reduction. This paper provides an overview of RSMA and its potential to address the requirements of 6G.
Waveform Design for Wireless Power Transfer Clerckx, Bruno; Bayguzina, Ekaterina
IEEE transactions on signal processing,
2016-Dec.1,-1, 2016-12-1, Letnik:
64, Številka:
23
Journal Article
Recenzirano
Odprti dostop
Far-field Wireless Power Transfer (WPT) has attracted significant attention in recent years. Despite the rapid progress, the emphasis of the research community in the last decade has remained largely ...concentrated on improving the design of energy harvester (so-called rectenna) and has left aside the effect of transmitter design. In this paper, we study the design of transmit waveform so as to enhance the dc power at the output of the rectenna. We derive a tractable model of the nonlinearity of the rectenna and compare with a linear model conventionally used in the literature. We then use those models to design novel multisine waveforms that are adaptive to the channel state information (CSI). Interestingly, while the linear model favours narrowband transmission with all the power allocated to a single frequency, the nonlinear model favours a power allocation over multiple frequencies. Through realistic simulations, waveforms designed based on the nonlinear model are shown to provide significant gains (in terms of harvested dc power) over those designed based on the linear model and over nonadaptive waveforms. We also compute analytically the theoretical scaling laws of the harvested energy for various waveforms as a function of the number of sinewaves and transmit antennas. Those scaling laws highlight the benefits of CSI knowledge at the transmitter in WPT and of a WPT design based on a nonlinear rectenna model over a linear model. Results also motivate the study of a promising architecture relying on large-scale multisine multiantenna waveforms for WPT. As a final note, results stress the importance of modeling and accounting for the nonlinearity of the rectenna in any system design involving wireless power.
PDF
