High concentrations of graphene oxide (GO), a nanoparticle substance with rapid manufacturing development, have the ability to penetrate the soil surface down to the mineral-rich subsurface layers. ...The destiny and distribution of such an unusual sort of nanomaterial in the environment must therefore be fully understood. However, the way the chemistry of solutions impacts GO nanoparticle adsorption on clay minerals is still unclear. Here, the adsorption of GO on clay minerals (e.g., bentonite and kaolinite) was tested under various chemical conditions (e.g., GO concentration, soil pH, and cation valence). Non-linear Langmuir and Freundlich models have been applied to describe the adsorption isotherm by comparing the amount of adsorbed GO nanoparticle to the concentration at the equilibrium of the solution. Our results showed fondness for GO in bentonite and kaolinite under similar conditions, but the GO nanoparticle adsorption with bentonite was superior to kaolinite, mainly due to its higher surface area and surface charge. We also found that increasing the ionic strength and decreasing the pH increased the adsorption of GO nanoparticles to bentonite and kaolinite, mainly due to the interaction between these clay minerals and GO nanoparticles’ surface oxygen functional groups. Experimental data fit well to the non-linear pseudo-second-order kinetic model of Freundlich. The model of the Freundlich isotherm was more fitting at a lower pH and higher ionic strength in the bentonite soil while the lowest R2 value of the Freundlich model was recorded at a higher pH and lower ionic strength in the kaolinite soil. These results improve our understanding of GO behavior in soils by revealing environmental factors influencing GO nanoparticle movement and transmission towards groundwater.
Previous studies investigated the direct application of phosphate rock and its partially acidulated to enhance its solubility compared to soluble fertilizers. However, the interaction between the ...effect of particles diameter and partial acidulation of phosphate rock on phosphorus (P) availability and its effect on dry matter yield and P uptake is still elusive. This study was conducted to assess the effect of partially acidulated Egyptian phosphate rocks with different particle size diameters on P availability and its effect on dry matter yield and P uptake of maize (Zea mays L.). A pot experiment was conducted on maize plants grown on light clay soil for 42 days. Acidulation was done by mixing phosphate rock with single superphosphate or triple superphosphate at a total rate of 200 mg P kg−1 with five acidulation mix ratios (100:0, 75:25, 50:50, 25:75, and 0:100). Different particle size diameters of phosphate rocks (500, 212, 75, and <45 µm included nano-particles ranged from 69.3 to 25.7 nm) were used. We found that dry matter yield and P uptake increased significantly due to the use of partially acidulated phosphate rocks especially when triple superphosphate was used for acidulation and the mixing ratio of 50:50 was the best. We also found that maize yield and P uptake increased significantly with decreasing particle size. It is recommended to use finely grounded partially acidulated phosphate rocks with particles diameter less than 45 µm at acidulation ratio 50% and no need to increase acidulation ratio above that as a slow-release phosphate fertilizer.
Pectin is a heterogeneous polysaccharide present in plants and citrus fruits. It exhibits different beneficial biological activities. Conflicting reports exist about the antimicrobial effect of ...pectin and its derivatives.
In this study, we investigate the antimicrobial effect of Modified Citrus Pectin (MCP) against Staphylococcus aureus, a pathogen showing increasing rates of antimicrobial resistance worldwide.
Forty-three clinical isolates of S. aureus were obtained from a hospital in North Lebanon. Minimum Inhibitory Concentrations (MICs) and Minimum Bactericidal Concentrations (MBCs) were determined using MCP after determining its optimum pH activity. The combination between MCP and cefotaxime was then investigated for S. aureus isolates using the checkerboard technique.
The optimum pH for the activity of MCP was 6.0. MIC and MBC values against S. aureus ranged between 0.39-50 µg/µl and 3.13-50 µg/µl, respectively. These values are promising for using MCP in the inhibition of some S. aureus isolates at relatively low concentrations. Combination experiments showed an additive effect in most S. aureus strains between MCP and cefotaxime, and a synergistic effect in two strains. These preliminary findings open the way for further investigation into the therapeutic potential of MCP in the treatment of S. aureus infections.
MCP demonstrates in vitro antimicrobial activity alone and in combination with cefotaxime against S. aureus.