The proven potential of 3D geometries at higher than 1016n˙eq/cm2 radiation fluences, in combination with a small cell approach, makes them an excellent choice for a combined precision timing ...tracker. In this study, the preliminary results on timing resolution of a single 50×50μm2 3D pixel cell are presented through charge collection measurements with discrete electronics in a laboratory setup. Additionally, in a test-beam campaign with 160 GeV SPS pions, a detailed timing, field and efficiency map is presented using a multi-plane timing telescope with an integrated pixelated matrix. Finally, another testbeam campaign has been completed with the help of the EUDET telescope, to study field uniformity, Landau contribution, collected charge and incidence angles of +/−12°; with a preliminary 5μm spatial resolution through MIMOSA CMOS tracking at CERN SPS pion beams.
•Sensors for vertex detectors in high energy physics with high luminosity scenarios.•Testbeam setup development for time and spatial resolution measurements.•3D silicon Pixel sensor time resolution results.
Towards radiation tolerant sensors for pico-second timing, several dopants are explored. Using a common mask, CNM produced LGADs with boron, boron + carbon and gallium gain layers are studied, under ...neutron and proton irradiation. With fluences ranging from
10
14
to
6 × 10
15
n
eq
/cm
2
on both particle species, results focus on acceptor removal, gain reduction via electrical characterization, timing performance and charge collection. An emphasis is placed on stability via dark rate and operating voltage studies.
We report on the results of a radiation campaign with neutrons and protons of Low Gain Avalanche Detectors (LGAD) produced by Hamamatsu (HPK) as prototypes for the High-Granularity Timing Detector ...(HGTD) in ATLAS. Sensors with an active thickness of 50μm were irradiated in steps of roughly 2× up to a fluence of 3×1015neqcm−2. As a function of the fluence, the collected charge and time resolution of the irradiated sensors will be reported for operation at −30 °C.
Beam test results of NDL Low Gain Avalanche Detectors (LGAD) Xiao, S.; Alderweireldt, S.; Ali, S. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
02/2021, Letnik:
989
Journal Article
Recenzirano
A High-Granularity Timing Detector (HGTD) is proposed based on the Low-Gain Avalanche Detector (LGAD) for the ATLAS experiment to satisfy the time resolution requirement for the up-coming High ...Luminosity at LHC (HL-LHC). We report on beam test results for two proto-types LGADs (BV60 and BV170) developed for the HGTD. Such modules were manufactured by the Institute of High Energy Physics (IHEP) of Chinese Academy of Sciences (CAS) collaborated with Novel Device Laboratory (NDL) of the Beijing Normal University. The beam tests were performed with 5 GeV electron beam at DESY. The timing performance of the LGADs was compared to a trigger counter consisting of a quartz bar coupled to a SiPM readout while extracting reference SiPM by fitting with a Gaussian function. The time resolution was obtained as 41 ps and 63 ps for the BV60 and the BV170, respectively.
The High-Granularity Timing Detector is a detector proposed for the ATLAS Phase II upgrade. The detector, based on the Low-Gain Avalanche Detector (LGAD) technology, will cover the pseudo-rapidity ...region of 2.4 < |n| < 4.0 with two end caps on each side and a total area of 6.4 m2. The timing performance can be improved by implanting an internal gain layer that can produce signals with a fast rising edge. It significantly improves the signal-to-noise ratio. The required average timing resolution per track for a minimum ionizing particle is 30 ps at the start and 50 ps at the end of the HL-LHC operation. This is achieved with several layers of LGAD. The innermost region of the detector would accumulate a 1MeV neutron-equivalent fluence up to 2.5 1015 neq/cm2 including a safety factor of 1.5 before being replaced during the scheduled shutdowns. The addition of this new detector is expected to play an important role in the mitigation of high pile-ups at the HL-LHC. The layout and performance of the various versions of LGAD prototypes produced by Hamamatsu (HPK) have been studied by the ATLAS Collaboration. The breakdown voltages, depletion voltages, inter-pad gaps, collected charge as well as the time resolution have been measured and the production yield of large size sensors has been evaluated.