Neutron stars are not only of astrophysical interest, but are also of great interest to nuclear physicists because their attributes can be used to determine the properties of the dense matter in ...their cores. One of the most informative approaches for determining the equation of state (EoS) of this dense matter is to measure both a star's equatorial circumferential radius Re and its gravitational mass M. Here we report estimates of the mass and radius of the isolated 205.53 Hz millisecond pulsar PSR J0030+0451 obtained using a Bayesian inference approach to analyze its energy-dependent thermal X-ray waveform, which was observed using the Neutron Star Interior Composition Explorer (NICER). This approach is thought to be less subject to systematic errors than other approaches for estimating neutron star radii. We explored a variety of emission patterns on the stellar surface. Our best-fit model has three oval, uniform-temperature emitting spots and provides an excellent description of the pulse waveform observed using NICER. The radius and mass estimates given by this model are km and (68%). The independent analysis reported in the companion paper by Riley et al. explores different emitting spot models, but finds spot shapes and locations and estimates of Re and M that are consistent with those found in this work. We show that our measurements of Re and M for PSR J0030+0451 improve the astrophysical constraints on the EoS of cold, catalyzed matter above nuclear saturation density.
We report on Bayesian parameter estimation of the mass and equatorial radius of the millisecond pulsar PSR J0030+0451, conditional on pulse-profile modeling of Neutron Star Interior Composition ...Explorer X-ray spectral-timing event data. We perform relativistic ray-tracing of thermal emission from hot regions of the pulsar's surface. We assume two distinct hot regions based on two clear pulsed components in the phase-folded pulse-profile data; we explore a number of forms (morphologies and topologies) for each hot region, inferring their parameters in addition to the stellar mass and radius. For the family of models considered, the evidence (prior predictive probability of the data) strongly favors a model that permits both hot regions to be located in the same rotational hemisphere. Models wherein both hot regions are assumed to be simply connected circular single-temperature spots, in particular those where the spots are assumed to be reflection-symmetric with respect to the stellar origin, are strongly disfavored. For the inferred configuration, one hot region subtends an angular extent of only a few degrees (in spherical coordinates with origin at the stellar center) and we are insensitive to other structural details; the second hot region is far more azimuthally extended in the form of a narrow arc, thus requiring a larger number of parameters to describe. The inferred mass M and equatorial radius Req are, respectively, 1.34 − 0.16 + 0.15 M and 12.71 − 1.19 + 1.14 km , while the compactness GM R eq c 2 = 0.156 − 0.010 + 0.008 is more tightly constrained; the credible interval bounds reported here are approximately the 16% and 84% quantiles in marginal posterior mass.
We study electron-positron pair production in polar caps of energetic pulsars to determine the maximum multiplicity of pair plasma a pulsar can produce under the most favorable conditions. This paper ...complements and updates our study of pair cascades presented in Timokhin & Harding (2015) with a more accurate treatment of the effects of ultrastrong G magnetic fields and emission processes of primary and secondary particles. We include pairs produced by curvature and synchrotron radiation photons as well as resonant Compton-scattered photons. We develop a semianalytical model of electron-positron cascades that can efficiently simulate pair cascades with an arbitrary number of microphysical processes and use it to explore cascade properties for a wide range of pulsar parameters. We argue that the maximum cascade multiplicity cannot exceed and that the multiplicity has a rather weak dependence on pulsar period. The highest multiplicity is achieved in pulsars with magnetic field and hot surfaces, with T 106 K. We also derive analytical expressions for several physical quantities relevant for electromagnetic cascade in pulsars, which may be useful in future works on pulsar cascades, including the upper limit on cascade multiplicity and various approximations for the parameter χ, the exponential factor in the expression for photon attenuation in strong magnetic fields.
Recent modeling of Neutron Star Interior Composition Explorer observations of thermal X-ray pulsations from the surface of the isolated millisecond pulsar PSR J0030+0451 suggests that the hot ...emitting regions on the pulsar's surface are far from antipodal, which is at odds with the classical assumption that the magnetic field in the pulsar magnetosphere is predominantly that of a centered dipole. Here, we review these results and examine previous attempts to constrain the magnetospheric configuration of PSR J0030+0451. To the best of our knowledge, there is in fact no direct observational evidence that PSR J0030+0451's magnetic field is a centered dipole. Developing models of physically motivated, non-canonical magnetic field configurations and the currents that they can support poses a challenging task. However, such models may have profound implications for many aspects of pulsar research, including pulsar braking, estimates of birth velocities, and interpretations of multi-wavelength magnetospheric emission.
Using the Parkes Radio Telescope, we have carried out deep observations of 11 unassociated gamma-ray sources. Periodicity searches of these data have discovered two millisecond pulsars, PSR ...J1103−5403 (1FGL J1103.9−5355) and PSR J2241−5236 (1FGL J2241.9−5236), and a long-period pulsar, PSR J1604−44 (1FGL J1604.7−4443). In addition, we searched for but did not detect any radio pulsations from six gamma-ray pulsars discovered by the Fermi satellite to a level of ∼0.04 mJy (for pulsars with a 10 per cent duty cycle).
The timing of the millisecond pulsar PSR J1103−5403 has shown that its position is 9 arcmin from the centroid of the gamma-ray source. Since these observations were carried out, independent evidence has shown that 1FGL J1103.9−5355 is associated with the flat spectrum radio source PKS 1101−536. It appears certain that the pulsar is not associated with the gamma-ray source, despite the seemingly low probability of a chance detection of a radio millisecond pulsar. We consider that PSR J1604−44 is a chance discovery of a weak, long-period pulsar and is unlikely to be associated with 1FGL J1604.7−4443. PSR J2241−5236 has a spin period of 2.2 ms and orbits a very low mass companion with a 3.5-h orbital period. The relatively high flux density and low dispersion measure of PSR J2241−5236 make it an excellent candidate for high precision timing experiments. The gamma rays of 1FGL J2241.9−5236 have a spectrum that is well modelled by a power law with an exponential cut-off, and phase binning with the radio ephemeris results in a multipeaked gamma-ray pulse profile. Observations with Chandra have identified a coincident X-ray source within 0.1 arcsec of the position of the pulsar obtained by radio timing.
An interesting new high-energy pulsar sub-population is emerging following early discoveries of gamma-ray millisecond pulsars (MSPs) by the Fermi Large Area Telescope (LAT). We present results from ...three-dimensional emission modeling, including the special relativistic effects of aberration and time-of-flight delays and also rotational sweepback of B-field lines, in the geometric context of polar cap (PC), outer gap (OG), and two-pole caustic (TPC) pulsar models. In contrast to the general belief that these very old, rapidly rotating neutron stars (NSs) should have largely pair-starved magnetospheres due to the absence of significant pair production, we find that most of the light curves are best fit by TPC and OG models, which indicates the presence of narrow accelerating gaps limited by robust pair production-even in these pulsars with very low spin-down luminosities. The gamma-ray pulse shapes and relative phase lags with respect to the radio pulses point to high-altitude emission being dominant for all geometries. We also find exclusive differentiation of the current gamma-ray MSP population into two MSP sub-classes: light curve shapes and lags across wavebands impose either pair-starved PC (PSPC) or TPC/OG-type geometries. In the first case, the radio pulse has a small lag with respect to the single gamma-ray pulse, while the (first) gamma-ray peak usually trails the radio by a large phase offset in the latter case. Finally, we find that the flux correction factor as a function of magnetic inclination and observer angles is typically of order unity for all models. Our calculation of light curves and flux correction factor for the case of MSPs is therefore complementary to the 'ATLAS paper' of Watters et al. for younger pulsars.
Advances in peri-operative care of surgical oncology patients result in shorter hospital stays. Earlier discharge may bring benefits, but complications can occur while patients are recovering at ...home. Electronic patient-reported outcome (ePRO) systems may enhance remote, real-time symptom monitoring and detection of complications after hospital discharge, thereby improving patient safety and outcomes. Evidence of the effectiveness of ePRO systems in surgical oncology is lacking. This pilot study evaluated the feasibility of a real-time electronic symptom monitoring system for patients after discharge following cancer-related upper gastrointestinal surgery.
A pilot study in two UK hospitals included patients who had undergone cancer-related upper gastrointestinal surgery. Participants completed the ePRO symptom-report at discharge, twice in the first week and weekly post-discharge. Symptom-report completeness, system actions, barriers to using the ePRO system and technical performance were examined. The ePRO surgery system is an online symptom-report that allows clinicians to view patient symptom-reports within hospital electronic health records and was developed as part of the eRAPID project. Clinically derived algorithms provide patients with tailored self-management advice, prompts to contact a clinician or automated clinician alerts depending on symptom severity. Interviews with participants and clinicians determined the acceptability of the ePRO system to support patients and their clinical management during recovery.
Ninety-one patients were approached, of which 40 consented to participate (27 male, mean age 64 years). Symptom-report response rates were high (range 63-100%). Of 197 ePRO completions analysed, 76 (39%) triggered self-management advice, 72 (36%) trigged advice to contact a clinician, 9 (5%) triggered a clinician alert and 40 (20%) did not require advice. Participants found the ePRO system reassuring, providing timely information and advice relevant to supporting their recovery. Clinicians regarded the system as a useful adjunct to usual care, by signposting patients to seek appropriate help and enhancing their understanding of patients' experiences during recovery.
Use of the ePRO system for the real-time, remote monitoring of symptoms in patients recovering from cancer-related upper gastrointestinal surgery is feasible and acceptable. A definitive randomised controlled trial is needed to evaluate the impact of the system on patients' wellbeing after hospital discharge.
ABSTRACT We report the results of a 16 month monitoring campaign using the Swift satellite of PSR B0540-69, a young pulsar in the Large Magellanic Cloud. Phase connection was maintained throughout ...the campaign so that a reliable ephemeris could be determined, and the length of the campaign is adequate to accurately determine the spin frequency and its first and second derivatives. The braking index n is 0.031 0.013 (90% confidence), a value much lower than previously reported for B0540-69 and almost all other young pulsars. We use data from the extensive monitoring campaign with Rossi X-ray Timing Explorer to show that timing noise is unlikely to significantly affect the measurement. This is the first measurement of the braking index in the pulsar's recently discovered high spin-down state. We discuss possible mechanisms for producing the low braking index.
We present results of recent Neutron Star Interior Composition Explorer (NICER) observations of the accreting millisecond X-ray pulsar (AMXP) IGR J17062−6143 that show that it resides in a circular, ...ultracompact binary with a 38-minute orbital period. NICER observed the source for 26 ks over a 5.3-day span in 2017 August, and again for 14 and 11 ks in 2017 October and November, respectively. A power spectral analysis of the August exposure confirms the previous detection of pulsations at 163.656 Hz in Rossi X-ray Timing Explorer (RXTE) data, and reveals phase modulation due to orbital motion of the neutron star. A coherent search for the orbital solution using the Z2 method finds a best-fitting circular orbit with a period of 2278.21 s (37.97 minutes), a projected semimajor axis of 0.00390 lt-s, and a barycentric pulsar frequency of 163.6561105 Hz. This is currently the shortest known orbital period for an AMXP. The mass function is 9.12 × 10−8 M , presently the smallest known for a stellar binary. The minimum donor mass ranges from 0.005 to 0.007 M for a neutron star mass from 1.2 to 2 M . Assuming mass transfer is driven by gravitational radiation, we find donor mass and binary inclination bounds of 0.0175-0.0155 M and 19° < i < 27 5, where the lower and upper bounds correspond to 1.4 and 2 M neutron stars, respectively. Folding the data accounting for the orbital modulation reveals a sinusoidal profile with fractional amplitude 2.04 0.11% (0.3-3.2 keV).
In modern manufacturing environments, vast amounts of data are collected in database management systems and data warehouses from all involved areas, including product and process design, assembly, ...materials planning, quality control, scheduling, maintenance, fault detection etc. Data mining has emerged as an important tool for knowledge acquisition from the manufacturing databases. This paper reviews the literature dealing with knowledge discovery and data mining applications in the broad domain of manufacturing with a special emphasis on the type of functions to be performed on the data. The major data mining functions to be performed include characterization and description, association, classification, prediction, clustering and evolution analysis. The papers reviewed have therefore been categorized in these five categories. It has been shown that there is a rapid growth in the application of data mining in the context of manufacturing processes and enterprises in the last 3 years. This review reveals the progressive applications and existing gaps identified in the context of data mining in manufacturing. A novel text mining approach has also been used on the abstracts and keywords of 150 papers to identify the research gaps and find the linkages between knowledge area, knowledge type and the applied data mining tools and techniques.