The swelling and co-nonsolvency behaviors in pure H2O and in a mixed H2O/CH3OH vapor atmosphere of two different polar, water-soluble polymers in thin film geometry are studied in situ. Films of a ...zwitterionic poly(sulfobetaine), namely, poly3-((2-(methacryloyloxy)ethyl)dimethylammonio) propane-1-sulfonate (PSPE), and a polar nonionic polymer, namely, poly(N-isopropylmethacrylamide) (PNIPMAM), are investigated in real time by spectral reflectance (SR) measurements and Fourier transform infrared (FTIR) spectroscopy. Whereas PSPE is insoluble in methanol, PNIPMAM is soluble but exhibits co-nonsolvency behavior in water/methanol mixtures. First, the swelling of PSPE and PNIPMAM thin films in H2O vapor is followed. Subsequently, CH3OH is added to the vapor atmosphere, and its contracting effect on the water-swollen films is monitored, revealing a co-nonsolvency-type behavior for PNIPMAM and PSPE. SR measurements indicate that PSPE and PNIPMAM behave significantly different during the H2O swelling and subsequent exposure to CH3OH, not only with respect to the amounts of absorbed water and CH3OH, but also to the cosolvent-induced contraction mechanisms. While PSPE thin films exhibit an abrupt one-step contraction, the contraction of PNIPMAM thin films occurs in two steps. FTIR studies corroborate these findings on a molecular scale and reveal the role of the specific functional groups, both during the swelling and the cosolvent-induced switching of the solvation state.
A series of zwitterionic model polymers with defined molar masses up to 150,000 Da and defined end groups are prepared from sulfobetaine monomer ...N,N-dimethyl-N-(3-(methacrylamido)propyl)ammoniopropanesulfonate (SPP). Polymers are synthesized by reversible addition-fragmentation chain transfer polymerization (RAFT) using a functional chain transfer agent labeled with a fluorescent probe. Their upper critical solution temperature-type coil-to-globule phase transition in water, deuterated water, and various salt solutions is studied by turbidimetry. Cloud points increase with polyzwitterion concentration and molar mass, being considerably higher in D
2
O than in H
2
O. Moreover, cloud points are strongly affected by the amount and nature of added salts. Typically, they increase with increasing salt concentration up to a maximum value, whereas further addition of salt lowers the cloud points again, mostly down to below freezing point. The different salting-in and salting-out effects of the studied anions can be correlated with the Hofmeister series. In physiological sodium chloride solution and in phosphate buffered saline (PBS), the cloud point is suppressed even for high molar mass samples. Accordingly, SPP-polymers behave strongly hydrophilic under most conditions encountered in biomedical applications. However, the direct transfer of results from model studies in D
2
O, using, e.g.
1
H NMR or neutron scattering techniques, to 'normal' systems in H
2
O is not obvious.
The 2-fold thermoresponsive diblock copolymer PSPP498-b-PNIPMAM144, which consists of a zwitterionic polysulfobetaine (PSPP) block and a nonionic poly(N-isopropylmethacrylamide) (PNIPMAM) block, is ...prepared by consecutive RAFT polymerizations. It combines the upper and lower critical solution temperature (UCST and LCST) behaviors, respectively, of the constitutive homopolymers in aqueous solution. We investigate the temperature-dependent phase behavior and the self-assembled structures of the block copolymer in D2O by turbidimetry and by small-angle neutron scattering (SANS) in salt-free solution and in the presence of small amounts of NaCl and NaBr. For comparison, solutions of PNIPMAM homopolymer in D2O are studied as well. Turbidimetry indicates thermally induced “schizophrenic” aggregation behavior for PSPP498-b-PNIPMAM144. SANS reveals that conventional star-like core–shell micellar structures are formed above the LCST transition, whereas below the UCST-transition, structure formation is much less pronounced. This is attributed to the different types of interactions, namely hydrophobic and ionic ones, dominating in the different regimes. Despite the increased polarity contrast between the zwitterionic and the nonionic blocks, and the much wider separation of the UCST- and LCST-based cloud points, CPUCST and CPLCST, the structural features of the new PSPP498-b-PNIPMAM144 resemble the ones found previously for the also 2-fold thermoresponsive analogue PSPP432-b-PNIPAM200, for which both phase transition temperatures nearly coincide. Remarkably, the addition of small amounts of NaBr or NaCl to the solution of PSPP498-b-PNIPMAM144 causes a significant increase of CPUCST, as well as minor but notable changes in the self–assembled structures, but no gross alterations of the phase behavior.
The swelling and phase transition behavior upon increasing temperature of a doubly thermoresponsive diblock copolymer thin film in steps above the characteristic cloud points (CPs) of the blocks is ...studied. An upper critical solution temperature (UCST)-type zwitterionic poly(sulfobetaine), poly(N,N-dimethyl-N-(3-methacrylamidopropyl)-ammoniopropane sulfonate) (PSPP, CPUCST = 31.5 °C), is combined with a lower critical solution temperature (LCST)-type nonionic poly(N-isopropyl-/methacrylamide) (PNIPMAM, CPLCST = 49.5 °C) block. Using time-of-flight neutron reflectivity (ToF-NR), we observe the swelling in D2O vapor at a constant temperature of 20 °C, followed by two subsequent temperature jumps, from 20 to 40 °C (above CPUCST) and from 40 to 60 °C (above CPLCST). The observed response of the diblock copolymer films deviates from the aqueous solution behavior, which is mainly attributed to the increased polymer concentration. Temperature-induced changes in the thin-film nanostructure are investigated with ToF grazing-incidence small-angle neutron scattering (GISANS). Alterations in the chain conformation and hydrogen bonding are probed by Fourier transform infrared (FTIR) spectroscopy. The ionic SO3 – groups (in the PSPP block) and the nonionic hydrophilic amide groups (in both blocks) are found to affect the mechanisms of D2O uptake and release significantly.
A 2-fold thermoresponsive diblock copolymer PSPP430-b-PNIPAM200 consisting of a zwitterionic polysulfobetaine (PSPP) block and a nonionic poly(N-isopropylacrylamide) (PNIPAM) block is prepared by ...successive RAFT polymerizations. In aqueous solution, the corresponding homopolymers PSPP and PNIPAM feature both upper and lower critical solution temperature (UCST and LCST) behavior, respectively. The diblock copolymer exhibits thermally induced “schizophrenic” aggregation behavior in aqueous solutions. Moreover, the ion sensitivity of the cloud point of the zwitterionic PSPP block to both the ionic strength and the nature of the salt offers the possibility to create switchable systems which respond sensitively to changes of the temperature and of the electrolyte type and concentration. The diblock copolymer solutions in D2O are investigated by means of turbidimetry and small-angle neutron scattering (SANS) with respect to the phase behavior and the self-assembled structures in dependence on temperature and electrolyte content. Marked differences of the aggregation below the UCST-type and above the LCST-type transition are observed. The addition of a small amount of NaBr (0.004 M) does not affect the overall behavior, and only the UCST-type transition and aggregate structures are slightly altered, reflecting the well-known ion sensitivity of the zwitterionic PSPP block.
Several series of presumed dual thermo-responsive diblock copolymers consisting of one non-ionic and one zwitterionic block were synthesized via consecutive reversible addition-fragmentation chain ...transfer (RAFT) polymerization. For all copolymers, poly(N-isopropylmethacrylamide) was chosen as non-ionic block that shows a coil-to-globule collapse transition of the lower critical solution temperature (LCST) type. In contrast, the chemical structure of zwitterionic blocks, which all belonged to the class of poly(sulfobetaine methacrylate)s, was varied broadly, in order to tune their coil-to-globule collapse transition of the upper critical solution temperature (UCST) type. All polymers were labeled with a solvatochromic fluorescent end-group. The dual thermo-responsive behavior and the resulting multifarious temperature-dependent self-assembly in aqueous solution were mapped by temperature-resolved turbidimetry, 1H NMR spectroscopy, dynamic light scattering (DLS), and fluorescence spectroscopy. Depending on the relative positions between the UCST-type and LCST-type transition temperatures, as well as on the width of the window in-between, all the four possible modes of stimulus-induced micellization can be realized. This includes classical induced micellization due to a transition from a double hydrophilic, or respectively, from a double hydrophobic to an amphiphilic state, as well as “schizophrenic” behavior, where the core- and shell-forming blocks are inverted. The exchange of the roles of the hydrophilic and hydrophobic block in the amphiphilic states is possible through a homogeneous intermediate state or a heterogeneous one.
Display omitted
•Well-defined zwitterionic block copolymers are made by RAFT polymerization.•The copolymers show dual thermo-responsive behavior in aqueous solution.•The individual polymer blocks show separate UCST and LCST-transitions.•Temperature dependent 1H NMR, dynamical light scattering and fluorescence studies.•Schizophrenic micellization behavior by inversion of core- and shell-forming blocks.
Smart, fully orthogonal switching was realized in a highly biocompatible diblock copolymer system with variable trigger-induced aqueous self-assembly. The polymers are composed of nonionic and ...zwitterionic blocks featuring lower and upper critical solution temperatures (LCSTs and UCSTs). In the system investigated, diblock copolymers from poly(N-isopropyl methacrylamide) (PNIPMAM) and a poly(sulfobetaine methacrylamide), systematic variation of the molar mass of the latter block allowed for shifting the UCST of the latter above the LCST of the PNIPMAM block in a salt-free condition. Thus, successive thermal switching results in “schizophrenic” micellization, in which the roles of the hydrophobic core block and the hydrophilic shell block are interchanged depending on the temperature. Furthermore, by virtue of the strong electrolyte-sensitivity of the zwitterionic polysulfobetaine block, we succeeded to shift its UCST below the LCST of the PNIPMAM block by adding small amounts of an electrolyte, thus inverting the pathway of switching. This superimposed orthogonal switching by electrolyte addition enabled us to control the switching scenarios between the two types of micelles (i) via an insoluble state, if the LCST-type cloud point is below the UCST-type cloud point, which is the case at low salt concentrations or (ii) via a molecularly dissolved state, if the LCST-type cloud point is above the UCST-type cloud point, which is the case at high salt concentrations. Systematic variation of the block lengths allowed for verifying the anticipated behavior and identifying the molecular architecture needed. The versatile and tunable self-assembly offers manifold opportunities, for example, for smart emulsifiers or for sophisticated carrier systems.
The kinetics of water transfer between the lower critical solution temperature (LCST) and upper critical solution temperature (UCST) thermoresponsive blocks in about 10 nm thin films of a diblock ...copolymer is monitored by in situ neutron reflectivity. The UCST‐exhibiting block in the copolymer consists of the zwitterionic poly(4‐((3‐methacrylamidopropyl)dimethylammonio)butane‐1‐sulfonate), abbreviated as PSBP. The LCST‐exhibiting block consists of the nonionic poly(N‐isopropylacrylamide), abbreviated as PNIPAM. The as‐prepared PSBP80‐b‐PNIPAM400 films feature a three‐layer structure, i.e., PNIPAM, mixed PNIPAM and PSBP, and PSBP. Both blocks have similar transition temperatures (TTs), namely around 32 °C for PNIPAM, and around 35 °C for PSBP, and with a two‐step heating protocol (20 °C to 40 °C and 40 °C to 80 °C), both TTs are passed. The response to such a thermal stimulus turns out to be complex. Besides a three‐step process (shrinkage, rearrangement, and reswelling), a continuous transfer of D2O from the PNIPAM to the PSBP block is observed. Due to the existence of both, LCST and UCST blocks in the PSBP80‐b‐PNIPAM400 film, the water transfer from the contracting PNIPAM, and mixed layers to the expanding PSBP layer occurs. Thus, the hydration kinetics and thermal response differ markedly from a thermoresponsive polymer film with a single LCST transition.
In situ neutron reflectivity is applied to investigate the kinetics of water transfer between the lower critical solution temperature (LCST) and upper critical solution temperature (UCST) thermoresponsive blocks in diblock copolymer thin films. The UCST type block profoundly influences the thermal response and final state of the diblock copolymer thin films, which possess implications for the investigation of complex transitional behaviors of such films.
Polysulfobetaines in aqueous solution show upper critical solution temperature (UCST) behavior. We investigate here the representative of this class of materials, poly (
,
-dimethyl-
...-(3-methacrylamidopropyl) ammonio propane sulfonate) (PSPP), with respect to: (i) the dynamics in aqueous solution above the cloud point as function of NaBr concentration; and (ii) the swelling behavior of thin films in water vapor as function of the initial film thickness. For PSPP solutions with a concentration of 5 wt.%, the temperature dependence of the intensity autocorrelation functions is measured with dynamic light scattering as function of molar mass and NaBr concentration (0⁻8 mM). We found a scaling of behavior for the scattered intensity and dynamic correlation length. The resulting spinodal temperatures showed a maximum at a certain (small) NaBr concentration, which is similar to the behavior of the cloud points measured previously by turbidimetry. The critical exponent of susceptibility depends on NaBr concentration, with a minimum value where the spinodal temperature is maximum and a trend towards the mean-field value of unity with increasing NaBr concentration. In contrast, the critical exponent of the correlation length does not depend on NaBr concentration and is lower than the value of 0.5 predicted by mean-field theory. For PSPP thin films, the swelling behavior was found to depend on film thickness. A film thickness of about 100 nm turns out to be the optimum thickness needed to obtain fast hydration with H₂O.