Vertex locator (VELO) is a silicon microstrip detector situated around the interaction point in the large Hadron Collider beauty (LHCb) spectrometer at the Large Hadron Collider. The LHCb experiment ...is dedicated to studying charge conjugation and parity symmetry violation in the heavy flavor sector and rare decays of B mesons. The precise reconstruction of both the primary and secondary vertices, obtained by the VELO, is crucial in the selection of signal events containing b and c quarks and lifetime measurements. VELO consists of two retractable parts that operate at 8 mm from the interaction region. Its proximity to proton beams makes the LHCb VELO a place for studying radiation damage effects in silicon detectors in proton-proton and heavy-ion collisions. The latest results from radiation damage studies and their impact on the operation of the LHCb VELO after the first data-taking period (Run I) and the ongoing Run II are presented in this paper. The main macroscopic parameters, influenced by particle fluence, are described along with selected methods of their monitoring. All the results show that VELO sustains the impact of high fluence of radiation, and its performance will not change significantly until the end of Run II.
The LHCb detector has undergone a major upgrade for LHC Run 3. This Upgrade I detector facilitates operation at higher luminosity and utilises full-detector information at the LHC collision rate, ...critically including the use of vertex information. A new vertex locator system, the VELO Upgrade, has been constructed. The core element of the new VELO are the double-sided pixelated hybrid silicon detector modules which operate in vacuum close to the LHC beam in a high radiation environment. The construction and quality assurance tests of these modules are described in this paper. The modules incorporate 200 \mum thick, n-on-p silicon sensors bump-bonded to 130 \nm technology ASICs. These are attached with high precision to a silicon microchannel substrate that uses evaporative CO\(_2\) cooling. The ASICs are controlled and read out with flexible printed circuits that are glued to the substrate and wire-bonded to the chips. The mechanical support of the module is given by a carbon fibre plate, two carbon fibre rods and an aluminium plate. The sensor attachment was achieved with an average precision of 21 \(\mathrm{\mu m}\), more than 99.5\% of all pixels are fully functional, and a thermal figure of merit of 3 \mathrm{Kcm^{2}W^{-1}}$ was achieved. The production of the modules was successfully completed in 2021, with the final assembly and installation completed in time for data taking in 2022.
A comprehensive study of the spatial resolution and detection efficiency of sensor prototypes developed for the LHCb VELO upgrade is presented. Data samples were collected at the CERN SPS H8 beam ...line using a hadron mixture of protons and pions with momenta of approximately 180 GeV/c. The sensor performance was characterised using both irradiated and non-irradiated sensors. Irradiated samples were subjected to a maximum fluence of \(\mathrm{8\times10^{15}~1~MeV~n_{eq}~cm^{-2}}\), of both protons and neutrons. The spatial resolution is measured comparing the detected hits to the position as predicted by tracks reconstructed by the Timepix3 telescope. The resolution is presented for different applied bias voltages and track angles, sensor thickness and implant size.
PDF
