Belle II is a new-generation B-factory experiment, dedicated to exploring new physics beyond the standard model of elementary particles in the flavor sector. Belle II started data-taking in April ...2018, using a synchronous data acquisition (DAQ) system based on pipelined trigger flow control. The Belle II DAQ system is designed to handle a 30-kHz trigger rate with approximately 1% of dead time, under the assumption of a raw event size of 1 MB. The DAQ system is reliable, and the overall data-taking efficiency reached 84.2% during the run period of January 2020-June 2020. The current readout system cannot be operated in the terms of ten years from the viewpoint of DAQ maintainability; meanwhile, the readout system is obstructing high-speed data transmission. A solution involving a peripheral component interconnect (PCI)-express-based readout module with high data throughput of up to 100 Gb/s was adopted to upgrade the Belle II DAQ system. We particularly focused on the design of firmware and software based on this new generation of readout board, called PCIe40, with an Altera Arria 10 field-programmable gate array chip. The 48-Gb transceiver (GBT) serial links, PCI-express hard IP-based direct memory access (DMA) architecture, interface of timing and trigger distribution system, and slow control system were designed to integrate with the current Belle II DAQ system. This article describes the performances accomplished during the data readout and slow control tests conducted using a test bench and a demonstration performed using on-site front-end electronics, specifically involving Belle II TOP and KLM subdetectors.
The Belle II experiment and the SuperKEKB collider are designed to operate under a higher luminosity compared to that of Belle for the improvement of rare <inline-formula> <tex-math ...notation="LaTeX">B </tex-math></inline-formula> meson decay study and new physics search. To break the bottleneck of bandwidth and to improve the stability in the operation of the Belle II data acquisition (DAQ) system, a new PCI-express-based readout system has been developed. The new system includes a PCI-express-based high-speed readout board (PCIe40), which was originally developed for the upgrades of the LHCb and ALICE experiments, the PCIe40 firmware, the slow control, and readout software running on a readout PC. The new readout system's commissioning with most of the Belle II subdetectors has been performed, and the readout upgrade is complete for the particle-identification detectors and the neutral kaon and muon detector in Belle II, which has been operating stably with the new system in the beam collision "physics runs." The results of the commissioning and the performance of the global DAQ operation will be reported.
To improve the data throughput of the Belle II data acquisition (DAQ), we are upgrading the central processing unit (CPU)-based COPPER system with a PCIe40 board carrying an Arria 10 ...field-programmable gate array (FPGA). Since one of the main functionalities of the new system is event building in the FPGA, the read-out system must be synchronized with the front-end electronics. This task is performed by the bidirectional trigger timing distribution system. During system commissioning, we prepared several versions of the interface to this system. In the initial version of the interface, we ported the code from Xilinx FPGAs to Arria 10. This revision also introduces monitoring of the status for multiple channels and a ring buffer to distribute trigger information to all channels in parallel. To improve stability under external noise, we implemented a clock-data recovery (CDR) using an independent onboard oscillator as a reference clock in the next revision of the interface. We are also developing a version utilizing a high-speed serial transceiver to replace CAT-7 RJ45 cables with optical fibers. The system commissioning started in 2021 with a few detectors and will be completed after the long shutdown 1 of SuperKEKB in 2023. In this article, we present the architectures of the interface to the trigger timing system implemented in the PCIe40 board and the system performance in the experiment.
A search for the flavor-changing neutral-current decay B+→ K+νν is performed at the Belle II experiment at the SuperKEKB asymmetric energy electron-positron collider. The data sample corresponds to ...an integrated luminosity of 63 fb−1 collected at the Υ(4S) resonance and a sample of 9 fb−1 collected at an energy 60 MeV below the resonance. Because the measurable decay signature involves only a single charged kaon, a novel measurement approach is used that exploits not only the properties of the B+ → K+νν decay, but also the inclusive properties of the other B meson in the Υ(4S) → BB event, to suppress the background from other B meson decays and light-quark pair production. This inclusive tagging approach offers a higher signal efficiency compared to previous searches. No significant signal is observed. An upper limit on the branching fraction of B+ → K+νν of 4.1 × 10−5 is set at the 90% confidence level.
The Belle II experiment with SuperKEKB accelerator has started beam collision in 2018. With a higher luminosity, the target of Belle II is to improve the measurement of rare B meson decays and to ...probe for new physics. The present DAQ system in Belle II is designed to operate under a maximum trigger rate of 30 kHz at expected peak luminosity, and its stability has been confirmed in the early phases of the operation so far. Considering the difficulty of maintenance and the limited performance of the current read-out system, Belle II DAQ group is preparing an upgrade by using PCI-express-based readout board (PCIe40) which is capable of a higher data throughput of 100 Gb/s. PCIe40 board is based on an Intel Arria 10 field-programmable gate array, which has 48 transceivers and PCI-express DMA architecture. The PCIe40 firmware for Belle II needs to have many functionalities, such as custom Belle2Link protocol to detector Front-End, interface to trigger and timing distribution system, data processing logic for first-level event building, and DMA implementation. This paper describes the development of each item and performance tests with various Belle II detectors' Front-End electronics (FEE), as well as the plan of integrating the new readout system in the Belle II global DAQ system.
We measure the tau-to-light-lepton ratio of inclusive B-meson branching fractions R(X_{τ/ℓ})≡B(B→Xτν)/B(B→Xℓν), where ℓ indicates an electron or muon, and thereby test the universality of ...charged-current weak interactions. We select events that have one fully reconstructed B meson and a charged lepton candidate from 189 fb^{-1} of electron-positron collision data collected with the Belle II detector. We find R(X_{τ/ℓ})=0.228±0.016(stat)±0.036(syst), in agreement with standard-model expectations. This is the first direct measurement of R(X_{τ/ℓ}).
Abstract We report results from a study of B ± → DK ± decays followed by D decaying to the CP-even final state K + K − and CP-odd final state K S 0 π 0 $$ {K}_S^0{\pi}^0 $$ , where D is an admixture ...of D 0 and D ¯ 0 $$ {\overline{D}}^0 $$ states. These decays are sensitive to the Cabibbo-Kobayashi-Maskawa unitarity-triangle angle ϕ 3. The results are based on a combined analysis of the final data set of 772 × 106 B B ¯ $$ B\overline{B} $$ pairs collected by the Belle experiment and a data set of 198 × 106 B B ¯ $$ B\overline{B} $$ pairs collected by the Belle II experiment, both in electron-positron collisions at the Υ(4S) resonance. We measure the CP asymmetries to be A $$ \mathcal{A} $$ CP+ = (+12.5 ± 5.8 ± 1.4)% and A $$ \mathcal{A} $$ CP− = (−16.7 ± 5.7 ± 0.6)%, and the ratios of branching fractions to be R $$ \mathcal{R} $$ CP+ = 1.164 ± 0.081 ± 0.036 and R $$ \mathcal{R} $$ CP− = 1.151 ± 0.074 ± 0.019. The first contribution to the uncertainties is statistical, and the second is systematic. The asymmetries A $$ \mathcal{A} $$ CP+ and A $$ \mathcal{A} $$ CP− have similar magnitudes and opposite signs; their difference corresponds to 3.5 standard deviations. From these values we calculate 68.3% confidence intervals of (8.5 ° < ϕ 3 < 16.5 ° ) or (84.5 ° < ϕ 3 < 95.5 ° ) or (163.3 ° < ϕ 3 < 171.5 ° ) and 0.321 < r B < 0.465.
We present the first comprehensive tests of the universality of the light leptons in the angular distributions of semileptonic B^{0}-meson decays to charged spin-1 charmed mesons. We measure five ...angular-asymmetry observables as functions of the decay recoil that are sensitive to lepton-universality-violating contributions. We use events where one neutral B is fully reconstructed in ϒ(4S)→BBover ¯ decays in data corresponding to 189 fb^{-1} integrated luminosity from electron-positron collisions collected with the Belle II detector. We find no significant deviation from the standard model expectations.
Abstract We measure CP asymmetries and branching-fraction ratios for B ± → DK ± and Dπ ± decays with D → K S 0 $$ {K}_{\textrm{S}}^0 $$ K ± π ∓, where D is a superposition of D 0 and D ¯ $$ ...\overline{D} $$ 0. We use the full data set of the Belle experiment, containing 772 × 106 B B ¯ $$ B\overline{B} $$ pairs, and data from the Belle II experiment, containing 387 × 106 B B ¯ $$ B\overline{B} $$ pairs, both collected in electron-positron collisions at the Υ(4S) resonance. Our results provide model-independent information on the unitarity triangle angle ϕ 3.
PDF
