The role of the NA62 RICH in the BR(K+→π+νν̄) measurement Volpe, R.; Anzivino, G.; Aisa, D. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
02/2020, Letnik:
952
Journal Article
Recenzirano
The NA62 experiment aims to measure the BR(K+→π+νν̄) with a 10% precision. One of the main backgrounds comes from the decay K+→μ+ν, therefore a highly powerful pion/muon separation is needed. The ...NA62 RICH, together with the calorimeter system, provides an accurate particle identification which has been essential to obtain the first results of the NA62 K+→π+νν̄ analysis, based on 2016 data. Two different algorithms have been exploited which, used in combination, allowed to get a pion reconstruction and identification efficiency of 75%, with a muon suppression factor of about 500, in the momentum range 15–35 GeV/c.
NA62 RICH performance: measurement and optimization Anzivino, G.; Barbanera, M.; Bizzeti, A. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
02/2020, Letnik:
952
Journal Article
Recenzirano
Odprti dostop
The Ring Imaging Cherenkov detector of the NA62 experiment at CERN SPS was commissioned in 2014, but the optimal performance was achieved in 2016 after the precise mirror alignment with reconstructed ...tracks. The measurement and monitoring of basic performance parameters is discussed: ring radius resolution, ring centre resolution, single hit resolution and mean number of hits per ring. The performance is measured with 2016 data on the positron sample. Different contributions to the resolutions are calculated.
Status of the NA62 ring imaging Cherenkov detector Cenci, P.; Anzivino, G.; Aisa, D. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
02/2020, Letnik:
952
Journal Article
Recenzirano
The Ring Imaging Cherenkov detector of the NA62 experiment at the CERN SPS is a key element of particle identification in the NA62 experimental strategy. The detector fulfills different conditions: ...to distinguish pions from muons with a muon rejection factor of O(102) in the NA62 momentum range of operation, between 15 and 35 GeV/c; to measure particle arrival time in the decay region with a precision better than 100 ps; to provide fast signals and reference time to the NA62 trigger system. The main design aspects and functional characteristics, as well as the performance of the detector measured with the data taken in the first NA62 physics runs, will be summarized in this paper.
•The NA62 experiment aims to measure the branching ratio of the K+→π+νν¯ decay.•The NA62 RICH performance fulfills the experiment requirements.•Pion–muon identification is performed with a muon rejection factor of O(102).•Time resolution with precision better than 100 ps is achieved.•The RICH is a key element to select charged particles in the trigger system.
Commissioning and performance of the NA62 RICH detector Anzivino, G.; Aisa, D.; Barbanera, M. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
12/2017, Letnik:
876
Journal Article
Recenzirano
NA62 is the last generation kaon experiment at CERN SPS aiming to study the decay K+→π+νν¯. The goal of the experiment is to measure the decay branching ratio, O(10−10), with 10% precision collecting ...about 100 K+→π+νν¯ events in three years of data taking and assuming a 10% signal acceptance. The weak signal and the huge background make the experiment very challenging. The NA62 detector must be able to reject background events from decay channels with branching ratios up to 10 orders of magnitude higher than the signal one and with similar experimental signature. In order to achieve the designed goal, good Particle Identification (PID), kinematic rejection and precise timing are required. The key element of the PID in NA62 is the Ring Imaging Cherenkov detector (RICH) to identify pions and muons and to measure the particle arrival time. After a pilot run in 2014, installation and commissioning of the detector were completed in 2015, when also the first physics run took place. Results on the detector performance will be presented together with preliminary results from the 2015 and 2016 physics runs.
The TOTEM T2 telescope based on triple-GEM chambers Bagliesi, M.G.; Berretti, M.; Brucken, E. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
05/2010, Letnik:
617, Številka:
1
Journal Article
Recenzirano
The TOTEM experiment at LHC has chosen the triple Gas Electron Multiplier (GEM) technology for its T2 telescope which will provide charged track reconstruction in the pseudorapidity range
5.3
<
|
η
|
...<
6.5
and a fully inclusive trigger for inelastic events. GEMs are gas filled detectors which combine good spatial resolution with very high rate capability and a good resistance to radiation. Preliminary results of cosmic ray tests performed at CERN on final T2 modules before installation are here presented. Comparisons between real and simulated detector performance are also shown.
The TOTEM collaboration has measured the proton–proton total cross section at
s
=
13
TeV
with a luminosity-independent method. Using dedicated
β
∗
=
90
m
beam optics, the Roman Pots were inserted ...very close to the beam. The inelastic scattering rate has been measured by the T1 and T2 telescopes during the same LHC fill. After applying the optical theorem the total proton–proton cross section is
σ
tot
=
(
110.6
±
3.4
) mb, well in agreement with the extrapolation from lower energies. This method also allows one to derive the luminosity-independent elastic and inelastic cross sections:
σ
el
=
(
31.0
±
1.7
)
mb
and
σ
inel
=
(
79.5
±
1.8
)
mb
.
The TOTEM collaboration has measured the elastic proton-proton differential cross section
d
σ
/
d
t
at
s
=
13
TeV LHC energy using dedicated
β
∗
=
90
m beam optics. The Roman Pot detectors were ...inserted to 10
σ
distance from the LHC beam, which allowed the measurement of the range 0.04 GeV
2
; 4 GeV
2
in four-momentum transfer squared |
t
|. The efficient data acquisition allowed to collect about 10
9
elastic events to precisely measure the differential cross-section including the diffractive minimum (dip), the subsequent maximum (bump) and the large-|
t
| tail. The average nuclear slope has been found to be
B
=
(
20.40
±
0
.
002
stat
±
0
.
01
syst
)
GeV
-
2
in the |
t
|-range 0.04–0.2 GeV
2
. The dip position is
|
t
dip
|
=
(
0.47
±
0
.
004
stat
±
0
.
01
syst
)
GeV
2
. The differential cross section ratio at the bump vs. at the dip
R
=
1.77
±
0
.
01
stat
has been measured with high precision. The series of TOTEM elastic pp measurements show that the dip is a permanent feature of the pp differential cross-section at the TeV scale.
The TOTEM experiment at the LHC has performed the first measurement at
s
=
13
TeV
of the
ρ
parameter, the real to imaginary ratio of the nuclear elastic scattering amplitude at
t
=
0
, obtaining the ...following results:
ρ
=
0.09
±
0.01
and
ρ
=
0.10
±
0.01
, depending on different physics assumptions and mathematical modelling. The unprecedented precision of the
ρ
measurement, combined with the TOTEM total cross-section measurements in an energy range larger than
10
TeV
(from 2.76 to
13
TeV
), has implied the exclusion of all the models classified and published by COMPETE. The
ρ
results obtained by TOTEM are compatible with the predictions, from other theoretical models both in the Regge-like framework and in the QCD framework, of a crossing-odd colourless 3-gluon compound state exchange in the
t
-channel of the proton–proton elastic scattering. On the contrary, if shown that the crossing-odd 3-gluon compound state
t
-channel exchange is not of importance for the description of elastic scattering, the
ρ
value determined by TOTEM would represent a first evidence of a slowing down of the total cross-section growth at higher energies. The very low-|
t
| reach allowed also to determine the absolute normalisation using the Coulomb amplitude for the first time at the LHC and obtain a new total proton–proton cross-section measurement
σ
tot
=
(
110.3
±
3.5
)
mb
, completely independent from the previous TOTEM determination. Combining the two TOTEM results yields
σ
tot
=
(
110.5
±
2.4
)
mb
.
The TOTEM experiment at the CERN LHC has measured elastic proton–proton scattering at the centre-of-mass energy
s
=
8
TeV and four-momentum transfers squared, |
t
|, from
6
×
10
-
4
to 0.2 GeV
2
. ...Near the lower end of the
t
-interval the differential cross-section is sensitive to the interference between the hadronic and the electromagnetic scattering amplitudes. This article presents the elastic cross-section measurement and the constraints it imposes on the functional forms of the modulus and phase of the hadronic elastic amplitude. The data exclude the traditional Simplified West and Yennie interference formula that requires a constant phase and a purely exponential modulus of the hadronic amplitude. For parametrisations of the hadronic modulus with second- or third-order polynomials in the exponent, the data are compatible with hadronic phase functions giving either central or peripheral behaviour in the impact parameter picture of elastic scattering. In both cases, the
ρ
-parameter is found to be
0.12
±
0.03
. The results for the total hadronic cross-section are
σ
tot
=
(
102.9
±
2.3
)
mb and
(
103.0
±
2.3
)
mb for central and peripheral phase formulations, respectively. Both are consistent with previous TOTEM measurements.