Vertex locator (VELO) is a silicon microstrip detector situated around the interaction point in the large Hadron Collider beauty (LHCb) spectrometer at the Large Hadron Collider. The LHCb experiment ...is dedicated to studying charge conjugation and parity symmetry violation in the heavy flavor sector and rare decays of B mesons. The precise reconstruction of both the primary and secondary vertices, obtained by the VELO, is crucial in the selection of signal events containing b and c quarks and lifetime measurements. VELO consists of two retractable parts that operate at 8 mm from the interaction region. Its proximity to proton beams makes the LHCb VELO a place for studying radiation damage effects in silicon detectors in proton-proton and heavy-ion collisions. The latest results from radiation damage studies and their impact on the operation of the LHCb VELO after the first data-taking period (Run I) and the ongoing Run II are presented in this paper. The main macroscopic parameters, influenced by particle fluence, are described along with selected methods of their monitoring. All the results show that VELO sustains the impact of high fluence of radiation, and its performance will not change significantly until the end of Run II.
Local thermal management of detector electronics through ultra-thin micro-structured silicon cooling plates is a very promising technique for pixel detectors in high energy physics experiments, ...especially at the LHC where the heavily irradiated sensors must be operated at temperatures below −20°C. It combines a very high thermal efficiency with a very low addition of mass and space, and suppresses all problems of CTE mismatch between the heat source and the heat sink. In addition, the use of CO2 as evaporative coolant liquid brings all the benefits of reliable and stable operation, but the high pressures involved impose additional challenges on the micro channel design and the fluidic connectivity. A series of designs have already been prototyped and tested for LHCb. The challenges, the current status of the measurements and the solutions under development will be described.
Probing active-edge silicon sensors using a high precision telescope Akiba, K.; Artuso, M.; van Beveren, V. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
03/2015, Letnik:
777
Journal Article
Recenzirano
Odprti dostop
The performance of prototype active-edge VTT sensors bump-bonded to the Timepix ASIC is presented. Non-irradiated sensors of thicknesses 100–200μm and pixel-to-edge distances of 50μm and 100μm were ...probed with a beam of charged hadrons with sub-pixel precision using the Timepix telescope assembled at the SPS at CERN. The sensors are shown to be highly efficient up to a few micrometers from the physical edge of the sensor. The distortion of the electric field lines at the edge of the sensors is studied by reconstructing the streamlines of the electric field using two-pixel clusters. These results are supported by TCAD simulations. The reconstructed streamlines are used to study the field distortion as a function of the bias voltage and to apply corrections to the cluster positions at the edge.
A first alignment of the LHCb Vertex Locator has been obtained from beam induced tracks at the LHC. A 450
GeV/
c protons were collided on a beam absorber during the LHC synchronisation tests of the ...anti-clockwise beam in August and September 2008. The resulting particle tracks have been reconstructed by the Vertex Locator. This was the first full reconstruction of tracks induced by the LHC beam. The quality of the data obtained is discussed. A total of 2200 tracks were reconstructed from the full data sample, and a first spatial alignment was obtained. The detector is aligned to an accuracy of
5
μ
m
in the sensor plane. The results confirm that all detector modules have not been displaced from their surveyed positions by more than
10
μ
m
.
PDF
