Highlights • Biomineralization enables recovery of the scarce element selenium as Se0 and metal selenides. • An integrated treatment strategy is needed to achieve the selenium discharge limit <5 μg ...l–1. • Polluted waters are a potential selenium resource for recovery. • Selenium has a multitude of functions in health, environment, and nanotechnology.
The characteristics of the extracellular polymeric substances (EPS) extracted with nine different extraction protocols from four different types of anaerobic granular sludge were studied. The ...efficiency of four physical (sonication, heating, cationic exchange resin (CER), and CER associated with sonication) and four chemical (ethylenediaminetetraacetic acid, ethanol, formaldehyde combined with heating, or NaOH) EPS extraction methods was compared to a control extraction protocols (i.e., centrifugation). The nucleic acid content and the protein/polysaccharide ratio of the EPS extracted show that the extraction does not induce abnormal cellular lysis. Chemical extraction protocols give the highest EPS extraction yields (calculated by the mass ratio between sludges and EPS dry weight (DW)). Infrared analyses as well as an extraction yield over 100% or organic carbon content over 1 g g
−1
of DW revealed, nevertheless, a carry-over of the chemical extractants into the EPS extracts. The EPS of the anaerobic granular sludges investigated are predominantly composed of humic-like substances, proteins, and polysaccharides. The EPS content in each biochemical compound varies depending on the sludge type and extraction technique used. Some extraction techniques lead to a slightly preferential extraction of some EPS compounds, e.g., CER gives a higher protein yield.
•Pretreating organic solid wastes leads to an enhanced anaerobic digestion process.•Pretreatments may also reduce the cost for post treatment of digestates.•Efficiency of pretreatment methods depends ...on the substrates’ characteristics.•Only few pretreatment methods are successfully applied at full-scale to date.
This paper reviews pretreatment techniques to enhance the anaerobic digestion of organic solid waste, including mechanical, thermal, chemical and biological methods. The effects of various pretreatment methods are discussed independently and in combination. Pretreatment methods are compared in terms of their efficiency, energy balance, environmental sustainability as well as capital, operational and maintenance costs. Based on the comparison, thermal pretreatment at low (<110°C) temperatures and two-stage anaerobic digestion methods result in a more cost-effective process performance as compared to other pretreatment methods.
During the last decades, the perception of selenium has undergone substantial changes. While its toxic effects were recognized causing hair and hoof loss in animals during the 1930s, its essential ...role in microbial, animal and human metabolism has been recognized later, i.e. with the discovery of selenium deficiency causing “white muscle disease” in feedstock in the 1950s. Nowadays, the positive effect of systematic selenium supplementation is discussed in manifold topics such as cancer or diabetes prevention and avian influenza susceptibility. Treatment of selenium containing waste streams poses a notable challenge to environmental engineers, and to date no ultimate solution has been found for e.g. the selenium contamination in agricultural areas of the western USA. For the future, selenium contamination carries an imminent danger, if the increasing energy demand is covered by fossil fuel combustion, which will lead to major selenium emission and toxicity. This review presents current knowledge of selenium’s role in environmental sciences and outlines potentially feasible treatment options targeting a variety of selenium contaminated waste streams.
Selenium is an essential trace element needed for all living organisms. Despite its essentiality, selenium is a potential toxic element to natural ecosystems due to its bioaccumulation potential. ...Though selenium is found naturally in the earth's crust, especially in carbonate rocks and volcanic and sedimentary soils, about 40% of the selenium emissions to atmospheric and aquatic environments are caused by various industrial activities such as mining-related operations. In recent years, advances in water quality and pollution monitoring have shown that selenium is a contaminant of potential environmental concern. This has practical implications on industry to achieve the stringent selenium regulatory discharge limit of 5μgSeL(-1) for selenium containing wastewaters set by the United States Environmental Protection Agency. Over the last few decades, various technologies have been developed for the treatment of selenium-containing wastewaters. Biological selenium reduction has emerged as the leading technology for removing selenium from wastewaters since it offers a cheaper alternative compared to physico-chemical treatments and is suitable for treating dilute and variable selenium-laden wastewaters. Moreover, biological treatment has the advantage of forming elemental selenium nanospheres which exhibit unique optical and spectral properties for various industrial applications, i.e. medical, electrical, and manufacturing processes. However, despite the advances in biotechnology employing selenium reduction, there are still several challenges, particularly in achieving stringent discharge limits, the long-term stability of biogenic selenium and predicting the fate of bioreduced selenium in the environment. This review highlights the significance of selenium in the environment, health, and industry and biotechnological advances made in the treatment of selenium contaminated wastewaters. The challenges and future perspectives are overviewed considering recent biotechnological advances in the management of these selenium-laden wastewaters.
Treatment of food waste by anaerobic digestion can lead to an energy production coupled to a reduction of the volume and greenhouse gas emissions from this waste type. According to EU Regulation ...EC1774/2002, food waste should be pasteurized/sterilized before or after anaerobic digestion. With respect to this regulation and also considering the slow kinetics of the anaerobic digestion process, thermal and chemical pretreatments of food waste prior to mesophilic anaerobic digestion were studied. A series of batch experiments to determine the biomethane potential of untreated as well as pretreated food waste was carried out. All tested conditions of both thermal and ozonation pretreatments resulted in an enhanced biomethane production. The kinetics of the anaerobic digestion process were, however, accelerated by thermal pretreatment at lower temperatures (<120 °C) only. The best result of 647.5 ± 10.6 mlCH4/gVS, which is approximately 52% higher as compared to the specific biomethane production of untreated food waste, was obtained with thermal pretreatment at 80 °C for 1.5 h. On the basis of net energy calculations, the enhanced biomethane production could cover the energy requirement of the thermal pretreatment. In contrast, the enhanced biomethane production with ozonation pretreatment is insufficient to supply the required energy for the ozonator.
•Pretreatment at 80 °C for 1.5 h yielded the highest biomethane production.•Biomethanation rates were enhanced with only less intensive thermal pretreatment.•Ozonation caused a higher cumulative production, but the rate was not enhanced.•Extra biomethane produced can supply the energy requirement of thermal pretreatment.
•A novel strategy for rapid development of a self-sustaining ABGS was proposed.•Synthetic conditions of mycelial pellets and algal-mycelial pellets were optimized.•Applying AMPs as nuclei ...significantly accelerated the granulation process of ABGS.•Addition of AMPs enhanced the EPS production and the nutrient removal efficiency.•The inherent mechanism for the rapid development of ABGS by adding AMPs was revealed.
Algal-bacterial granular sludge (ABGS) is a promising technology for wastewater treatment, benefiting from the synergetic interactions between algae and bacteria. However, the rapid start-up of the ABGS system is not trivial. Herein, a novel strategy was proposed by applying the algal-mycelial pellets (AMPs) as the primary nuclei for accelerating the development of a self-sustaining symbiotic ABGS system. The results indicated that by using this strategy complete granulation was shortened to 12 days, much shorter than the control system without AMPs dosage (28 days). The ABGS had a large particle diameter (3.3 mm), compact granular structure (1.0253 g/mL), and excellent settleability (SVI30 of 53.2 mL/g). Moreover, 98.6% of COD, 80.8% of TN and 80.0% of PO43−-P were removed by the ABGS. The nuclei of targeted algae (Chlorella) and filamentous fungi (Aspergillus niger), the enhanced production of extracellular polymeric substances (especially proteins) and the enrichment of functional bacteria (such as Neomegalonema and Flavobacterium) facilitated the granules development. The low surface free energy (-69.56 mJ/m2) and energy barrier (89.93 KT) were the inherent mechanisms for the strong surface hydrophobicity, the easy bacterial adhesion, and the short granulation period. This study provides an economically feasible approach to accelerate ABGS granulation and sustain system stability.
Display omitted
An effective strategy for environmentally sound biological recovery of copper and gold from discarded printed circuit boards (PCB) in a two-step bioleaching process was experimented. In the first ...step, chemolithotrophic acidophilic Acidithiobacillus ferrivorans and Acidithiobacillus thiooxidans were used. In the second step, cyanide-producing heterotrophic Pseudomonas fluorescens and Pseudomonas putida were used. Results showed that at a 1% pulp density (10g/L PCB concentration), 98.4% of the copper was bioleached by a mixture of A. ferrivorans and A. thiooxidans at pH 1.0-1.6 and ambient temperature (23±2°C) in 7days. A pure culture of P. putida (strain WCS361) produced 21.5 (±1.5)mg/L cyanide with 10g/L glycine as the substrate. This gold complexing agent was used in the subsequent bioleaching step using the Cu-leached (by A. ferrivorans and A. thiooxidans) PCB material, 44.0% of the gold was mobilized in alkaline conditions at pH 7.3-8.6, and 30°C in 2days. This study provided a proof-of-concept of a two-step approach in metal bioleaching from PCB, by bacterially produced lixiviants.
Display omitted
•This study quantified a hitherto undocumented pathway of ocean debris.•46% of European post-consumer plastic destined for recycling is exported.•Mass flows calculated for end-of-life ...fates of exported polyethylene (PE) waste.•Up to 180,558 Mg of exported PE (7.3%) entered the ocean.•Per capita “recycled” PE entering ocean up to 3.2 kg·head-1·year−1.
Polyethylene (PE) is one of the most common types of plastic. Whilst an increasing share of post-consumer plastic waste from Europe is collected for recycling, 46% of separated PE waste is exported outside of the source country (including intra-EU trade). The fate of this exported European plastic is not well known. This study integrated data on PE waste flows in 2017 from UN Comtrade, an open repository providing detailed international trade data, with best available information on waste management in destination countries, to model the fate of PE exported for recycling from Europe (EU-28, Norway and Switzerland) into: recycled high-density PE (HDPE) and low-density PE (LDPE) resins, “landfill”, incineration and ocean debris. Data uncertainty was reflected in three scenarios representing high, low and average recovery efficiency factors in material recovery facilities and reprocessing facilities, and different ocean debris fate factors. The fates of exported PE were then linked back to the individual European countries of export. Our study estimated that 83,187 Mg (tonnes) (range: 32,115–180,558 Mg), or 3% (1–7%) of exported European PE in 2017 ended up in the ocean, indicating an important and hitherto undocumented pathway of plastic debris entering the oceans. The countries with the greatest percentage of exported PE ending up as recycled HDPE or LDPE were Luxembourg and Switzerland (90% recycled for all scenarios), whilst the country with the lowest share of exported PE being recycled was the United Kingdom (59–80%, average 69% recycled). The results showed strong, significant positive relationships between the percentage of PE exported out of Europe and the percentage of exports which potentially end up as ocean debris. Export countries may not be the ultimate countries of origin owing to complex intra-EU trade in PE waste. Although somewhat uncertain, these mass flows provide pertinent new evidence on the efficacy and risks of current plastic waste management practices pertinent to emerging regulations around trade in plastic waste, and to the development of a more circular economy.
The origin of the organic layer covering colloidal biogenic elemental selenium nanoparticles (BioSeNPs) is not known, particularly in the case when they are synthesized by complex microbial ...communities. This study investigated the presence of extracellular polymeric substances (EPS) on BioSeNPs. The role of EPS in capping the extracellularly available BioSeNPs was also examined. Fourier transform infrared (FT-IR) spectroscopy and colorimetric measurements confirmed the presence of functional groups characteristic of proteins and carbohydrates on the BioSeNPs, suggesting the presence of EPS. Chemical synthesis of elemental selenium nanoparticles in the presence of EPS, extracted from selenite fed anaerobic granular sludge, yielded stable colloidal spherical selenium nanoparticles. Furthermore, extracted EPS, BioSeNPs, and chemically synthesized EPS-capped selenium nanoparticles had similar surface properties, as shown by ζ-potential versus pH profiles and isoelectric point measurements. This study shows that the EPS of anaerobic granular sludge form the organic layer present on the BioSeNPs synthesized by these granules. The EPS also govern the surface charge of these BioSeNPs, thereby contributing to their colloidal properties, hence affecting their fate in the environment and the efficiency of bioremediation technologies.
PDF
