A novel method for the measurement of the number of positrons contained in intense positron bunches is presented. The technique is based on the Poisson distribution of the number of gamma rays ...emitted by many simultaneous positron–electron annihilations in a small solid angle. The results have been found in good agreement with those achieved with a calibrated CsI(Tl) detector coupled to a photodiode. The small dimension of the required equipment and the reduced constraints of the technique open the possibility of monitoring, in complex positrons systems, the number of positrons at different positions that are too difficult to reach with other devices.
We report on a newly developed scanning positron microbeam based on threefold moderation of positrons provided by the high intensity positron source NEPOMUC. For brightness enhancement a remoderation ...unit with a 100 nm thin Ni(100) foil and 9.6% efficiency is applied to reduce the area of the beam spot by a factor of 60. In this way, defect spectroscopy is enabled with a lateral resolution of 33 m over a large scanning range of 19 × 19 mm2. Moreover, 2D defect imaging using Doppler broadening spectroscopy (DBS) is demonstrated to be performed within exceptional short measurement times of less than two minutes for an area of 1 × 1 mm2 (100 × 100 m2) with a resolution of 250 m (50 m). We studied the defect structure in laser beam welds of the high-strength age-hardened Al alloy (AlCu6Mn, EN AW-2219 T87) by applying (coincident) DBS with unprecedented spatial resolution. The visualization of the defect distribution revealed a sharp transition between the raw material and the welded zone as well as a very small heat affected zone. Vacancy-like defects and Cu rich precipitates are detected in the as-received material and, to a lesser extent, in the transition zone of the weld. Most notably, in the center of the weld vacancies without forming Cu-vacancy complexes, and the dissolution of the Cu atoms in the crystal lattice, i.e. formation of a supersaturated solution, could be clearly identified.
A fiber detector to monitor ortho-Ps formation and decay Rienäcker, B.; Brusa, R.S.; Caravita, R. ...
Nuclear instruments & methods in physics research. Section A, Accelerators, spectrometers, detectors and associated equipment,
03/2022, Letnik:
1027
Journal Article
Recenzirano
Odprti dostop
We describe a novel method to use a scintillating fiber detector similar to the Fast Annihilation Cryogenic Tracking (FACT) used at the antimatter experiment AEḡIS to monitor the presence of ...ortho-positronium. A single scintillating fiber was coupled to a photomultiplier tube and irradiated by flashes of about 6 × 106 gamma quanta with 511keV energy, produced by approximately 10ns long positron pulses. The results were used to demonstrate the ability to track the creation and annihilation of ortho-positronium atoms over time in cryogenic and highly magnetic environments by using the FACT detector as a “digital calorimeter”.
We characterized the pulsed Rydberg-positronium production inside the Antimatter Experiment: Gravity, Interferometry, Spectroscopy (AE¯gIS) apparatus in view of antihydrogen formation by means of a ...charge exchange reaction between cold antiprotons and slow Rydberg-positronium atoms. Velocity measurements on the positronium along two axes in a cryogenic environment (≈10K) and in 1T magnetic field were performed. The velocimetry was done by microchannel-plate (MCP) imaging of a photoionized positronium previously excited to the n=3 state. One direction of velocity was measured via Doppler scan of this n=3 line, another direction perpendicular to the former by delaying the exciting laser pulses in a time-of-flight measurement. Self-ionization in the magnetic field due to the motional Stark effect was also quantified by using the same MCP-imaging technique for Rydberg positronium with an effective principal quantum number neff ranging between 14 and 22. We conclude with a discussion about the optimization of our experimental parameters for creating Rydberg positronium in preparation for an efficient pulsed production of antihydrogen.
We present the commissioning of the Fast Annihilation Cryogenic Tracker detector (FACT), installed around the antihydrogen production trap inside the 1T superconducting magnet of the AEgIS ...experiment. FACT is designed to detect pions originating from the annihilation of antiprotons. Its 794 scintillating fibers operate at 4K and are read out by silicon photomultipliers (MPPCs) at near room temperature. FACT provides the antiproton/antihydrogen annihilation position information with a few ns timing resolution.
We present the hardware and software developments which led to the successful operation of the detector for antihydrogen detection and the results of an antiproton-loss based efficiency assessment. The main background to the antihydrogen signal is that of the positrons impinging onto the positronium conversion target and creating a large amount of gamma rays which produce a sizeable signal in the MPPCs shortly before the antihydrogen signal is expected. We detail the characterization of this background signal and its impact on the antihydrogen detection efficiency.
We describe a system designed to re-bunch positron pulses delivered by an accumulator supplied by a positron source and a Surko-trap. Positron pulses from the accumulator are magnetically guided in a ...0.085T field and are injected into a region free of magnetic fields through a μ-metal field terminator. Here positrons are temporally compressed, electrostatically guided and accelerated towards a porous silicon target for the production and emission of positronium into vacuum. Positrons are focused in a spot of less than 4mm FWTM in bunches of ∼8ns FWHM. Emission of positronium into the vacuum is shown by single shot positron annihilation lifetime spectroscopy.
In this work we describe a high-resolution position-sensitive detector for positronium. The detection scheme is based on the photoionization of positronium in a magnetic field and the imaging of the ...freed positrons with a Microchannel Plate assembly. A spatial resolution of (88±5) μm on the position of the ionized positronium –in the plane perpendicular to a 1.0 T magnetic field– is obtained. The possibility to apply the detection scheme for monitoring the emission into vacuum of positronium from positron/positronium converters, imaging positronium excited to a selected state and characterizing its spatial distribution is discussed. Ways to further improve the spatial resolution of the method are presented.
PDF
