Single-crystal metals have distinctive properties owing to the absence of grain boundaries and strong anisotropy. Commercial single-crystal metals are usually synthesized by bulk crystal growth or by ...deposition of thin films onto substrates, and they are expensive and small. We prepared extremely large single-crystal metal foils by "contact-free annealing" from commercial polycrystalline foils. The colossal grain growth (up to 32 square centimeters) is achieved by minimizing contact stresses, resulting in a preferred in-plane and out-of-plane crystal orientation, and is driven by surface energy minimization during the rotation of the crystal lattice followed by "consumption" of neighboring grains. Industrial-scale production of single-crystal metal foils is possible as a result of this discovery.
Patterned graphene sheets are fabricated by an inkjet printing technique. High line resolution and sustained electrical conductivity is achieved, and tuning of the sheet resistance is dependent on ...the concentration of graphene oxide ink and the number of print layers. A patterned graphene‐based thin film is also applied as a practical wideband dipole antenna.
•IRB/AML fixed-dose regimens show superior antihypertensive efficacy over IRB monotherapy.•A potential benefit of IRB/AML regimens was noted in the elderly and T2DM patients.•IRB/AML combinations are ...well-tolerated and have comparable safety to IRB monotherapy.
This study aimed to evaluate the efficacy and tolerability of irbesartan (IRB) and amlodipine (AML) combination therapy in patients with essential hypertension whose blood pressure (BP) was not controlled by IRB monotherapy.
Two multicenter, randomized, double-blind, placebo-controlled, phase III studies were conducted in Korea (the I-DUO 301 study and the I-DUO 302 study). After a 4-week run-in period with either 150 mg IRB (I-DUO 301 study) or 300 mg IRB (I-DUO 302 study), patients with uncontrolled BP (ie, mean sitting systolic BP MSSBP ≥140 mmHg to <180 mmHg and mean sitting diastolic BP <110 mmHg) were randomized to the placebo, AML 5 mg, or AML 10 mg group. A total of 428 participants were enrolled in the 2 I-DUO studies. In the I-DUO 301 study, 271 participants were randomized in a 1:1:1 ratio to receive either IRB/AML 150/5 mg, IRB/AML 150/10 mg, or IRB 150 mg/placebo. In the I-DUO 302 study, 157 participants were randomized in a 1:1 ratio to receive IRB/AML 300/5 mg or IRB 300 mg/placebo. The primary endpoint was the change in MSSBP from baseline to week 8. Tolerability was assessed according to the development of treatment-emergent adverse events (TEAEs) and clinically significant changes in physical examination, laboratory tests, pulse, and 12-lead electrocardiography.
In I-DUO 301, the mean (SD) changes of MSSBP at week 8 from baseline were −14.78 (12.35) mmHg, −21.47 (12.78) mmHg, and −8.61 (12.19) mmHg in the IRB/AML 150/5 mg, IRB/AML 150/10 mg, and IRB 150 mg/placebo groups, respectively. In I-DUO 302, the mean (SD) changes of MSSBP at week 8 from baseline were −13.30 (12.47) mmHg and −7.19 (15.37) mmHg in the IRB/AML 300/5 mg and IRB 300 mg/placebo groups, respectively. In both studies, all combination groups showed a significantly higher reduction in MSSBP than the IRB monotherapy groups (P < 0.001 for both). TEAEs occurred in 10.00%, 10.99%, and 12.22% of participants in the IRB/AML 150/5 mg, IRB/AML 150/10 mg, and IRB 150 mg/placebo groups, respectively, in I-DUO 301 and in 6.33% and 10.67% of participants in the IRB/AML 300/5 mg and IRB 300 mg/placebo groups, respectively, in I-DUO 302, with no significant between-group differences. Overall, there was one serious adverse event throughout I-DUO study.
The combination of IRB and AML has superior antihypertensive effects compared with IRB alone over an 8-week treatment period, with placebo-like tolerability.
ClinicalTrials.gov identifier: NCT05476354 (I-DUO 301), NCT05475665 (I-DUO 302).
With the prevalence of non-alcoholic fatty liver disease (NAFLD) increasing worldwide, many noninvasive techniques have been used to improve its diagnosis. Recently, the serum uric acid/creatinine ...(sUA/sCr) ratio was identified as an indicator of fatty liver disease. Therefore, we examined the relationship between sUA/sCr levels and ultrasound-diagnosed NAFLD in Korean adults.
This study included 16,666 20-year-olds or older who received health checkups at a university hospital's health promotion center from January to December 2021. Among them, 11,791 non-patients with and without NAFLD were analyzed, excluding those without abdominal ultrasound, those without data on fatty liver, cancer, or chronic kidney disease severity, those with a history of alcohol abuse, and those with serum hs-CRP <5 mg/L. The odds ratio (OR) and 95% confidence interval (CI) of the sUA/sCr ratio according to the presence or absence of fatty liver disease and severity were calculated after correcting for confounding variables using logistic regression analysis. The receiver operating characteristic (ROC) curve and area under the curve (AUC) of the sUA/sCr ratio confirmed and compared the sensitivity and specificity of NAFLD and serum uric acid.
sUA/sCr increased with fatty liver severity, and the post-correction OR in the NAFLD group was 1.183 (95% CI: 1.137-1.231) compared to the group without NAFLD. Concerning the fatty liver severity, the post-correction OR in the mild NAFLD group increased to 1.147 (95% CI: 1.099-1.196), and that in the moderate-to-severe NAFLD group increased to 1.275 (95% CI: 1.212-1.341) compared to the group without NAFLD. The sensitivity of sUA/sCr to fatty liver severity was 57.9% for the non-NAFLD group, 56.7% for the mild NAFLD group, and 59.0% for the moderate-to-severe NAFLD group; the specificity of sUA/sCr to fatty liver severity 61.4% for the non-NAFLD group, 57.3% for the mild NAFLD group, and 65.2% for the moderate-to-severe NAFLD group.
NAFLD severity is associated with sUA/sCR.
Formation, evolution and vanishing of bubbles are common phenomena in nature, which can be easily observed in boiling or falling water, carbonated drinks, gas-forming electrochemical reactions and so ...on. However, the morphology and the growth dynamics of the bubbles at nanoscale have not been fully investigated owing to the lack of proper imaging tools that can visualize nanoscale objects in the liquid phase. Here, we demonstrate for the first time that the nanobubbles in water encapsulated by graphene membrane can be visualized by in-situ ultra-high vacuum transmission electron microscopy. Our microscopic results indicate two distinct growth mechanisms of merging nanobubbles and the existence of a critical radius of nanobubbles that determines the unusually long stability of nanobubbles. Interestingly, the gas transport through ultrathin water membranes at nanobubble interface is free from dissolution, which is clearly different from conventional gas transport that includes condensation, transmission and evaporation.
Display omitted
► The monodisperse and multigram-scale N-MCNPs are fabricated by carbonization of polypyrrole as a carbon precursor. ► The synthesized N-MCNPs provide an enhanced adsorption uptake ...for various heavy metal ions. ► The N-MCNPs can be applied to the Langmuir model and pseudo-second-order kinetics. ► The iron-impregnated N-MCNPs are reused up to 5 times with no loss of removal efficiency.
To clarify the heavy metal adsorption mechanism of nitrogen-doped magnetic carbon nanoparticles (N-MCNPs), adsorption capacity was investigated from the adsorption isotherms, kinetics and thermodynamics points of view. The obtained results showed that the equilibrium adsorption behavior of Cr
3+ ion onto the N-MCNPs can be applied to the Langmuir model and pseudo-second-order kinetics. It indicated that the fabricated N-MCNPs had the homogenous surface for adsorption and all adsorption sites had equal adsorption energies. Furthermore, the adsorption onto N-MCNPs taken place through a chemical process involving the valence forces. According to the thermodynamics, the adsorption process is spontaneous and endothermic in nature which means that the adsorption capacity increases with increasing temperature due to the enhanced mobility of adsorbate molecules. The effects of the solution pH and the species of heavy metal ion on the adsorption uptake were also studied. The synthesized N-MCNPs exhibited an enhanced adsorption capacity for the heavy metal ions due to the high surface area and large amount of nitrogen contents.
Multifunctional electronic skins have attracted considerable attention for soft electronics including humanoid robots, wearable devices, and health monitoring systems. Simultaneous detection of ...multiple stimuli in a single self‐powered device is desired to simplify artificial somatosensory systems. Here, inspired by the structure and function of human skin, an ultrasensitive self‐powered multimodal sensor is demonstrated based on an interlocked ferroelectric copolymer microstructure. The triboelectric and pyroelectric effects of ferroelectric microstructures enable the simultaneous detection of mechanical and thermal stimuli in a spacer‐free single device, overcoming the drawbacks of conventional devices, including complex fabrication, structural complexity, and high‐power consumption. Furthermore, the interlocked microstructure induces electric field localization during ferroelectric polarization, leading to enhanced output performance. The multimodal tactile sensor provides ultrasensitive pressure and temperature detection capability (2.2 V kPa−1, 0.27 nA °C−1) over a broad range (0.1–98 kPa, −20 °C < ΔT < 30 °C). Furthermore, multiple simultaneous stimuli can be distinguished based on different response times of triboelectric and pyroelectric effects. The remarkable performance of this sensor enables real‐time monitoring of pulse pressure, acoustic wave detection, surface texture analysis, and profiling of multiple stimuli.
Inspired by the structure and function of human skin, an ultrasensitive self‐powered multimodal sensor is demonstrated based on an interlocked ferroelectric copolymer microstructure. The triboelectric and pyroelectric effects of ferroelectric microstructures enable the simultaneous detection of mechanical and thermal stimuli in a single device, demonstrating potential applications in humanoid robots, wearable devices, and healthcare systems.
Although it has been shown that the size of nanoparticle-based vaccines is a key determining factor for the induction of immune responses, few studies have provided detailed analyses of thresholds or ...critical sizes of nanoparticle vaccines. Here we report effects of the size of gold nanoparticle (GNP)-based vaccines on their efficiency of delivery to lymph nodes (LNs) and induction of CD8+ T-cell responses. We further propose a threshold size of GNPs for use as an effective vaccine. To examine the effects of GNP size, we synthesized GNPs with diameters of 7, 14 and 28nm, and then conjugated them with recombinant ovalbumin (OVA) as a model antigen. The resulting OVA-GNPs had hydrodynamic diameter (HD) of ~10, 22, and 33nm for 7, 14 and 28nm GNPs, respectively and exhibited a size-dependent increase in cellular uptake by dendritic cells (DCs) and subsequent T-cell cross-priming and activation. Upon injection into a mouse footpad, both 22- and 33-nm OVA-GNPs showed much higher delivery efficiency to draining LNs than did 10-nm OVA-GNPs. An ex vivo restimulation assay using OVA as an antigen revealed that frequencies of OVA-specific CD8+ T cells were higher in mice immunized with 22- and 33-nm OVA-GNPs than in those immunized with 10-nm OVA-GNPs; moreover, these cells were shown to be poly-functional. In a tumor-prevention study, 22-nm OVA-GNPs showed greater antitumor efficacy, and higher infiltration of CD8+ T-cells and greater tumor cell apoptosis and cell death than 10-nm OVA-GNPs. Taken together, our results suggest that the size threshold for induction of potent cellular responses and T-cell poly-functionality by GNPs lies between 10nm and 22nm, and highlight the importance of nanoparticle size as a critical parameter in designing and developing nanoparticle-based vaccines.
Display omitted
We prepared two-dimensional (2D) stack-structured magnetic iron oxide (Fe3O4) nanoparticle anchored titanium carbide (Ti3C2Tx) MXene material (Ti3C2Tx/Fe3O4). It was used as a potential adsorbent to ...remove carcinogenic cationic dyes, such as methylene blue (MB) and rhodamine B (Rh B), from aqueous solutions. Ti3C2Tx/Fe3O4 exhibited maximum adsorption capacities of 153 and 86 mg g−1 for MB and Rh B dyes, respectively. Batch adsorption experimental data fits the Langmuir model well, revealing monolayer adsorption of MB and Rh B onto the adsorption sites of Ti3C2Tx/Fe3O4. Additionally, Ti3C2Tx/Fe3O4 showed rapid MB/Rh B adsorption kinetics and attained equilibrium within 45 min. Moreover, Ti3C2Tx/Fe3O4 demonstrated recyclability over four cycles with high stability due to the presence of magnetic Fe3O4 nanoparticles. Furthermore, it exhibited remarkable selectivities of 91% and 88% in the presence of co-existing cationic and anionic dyes, respectively. Given the extraordinary adsorption capacities, Ti3C2Tx/Fe3O4 may be a promising material for the effective removal of cationic dyes from aqueous media.
Display omitted
•Magnetic 2D MXene material towards multiple cationic dye sequestration.•Unprecedented MB and Rh B adsorption capacities of 153 and 86 mg g−1, respectively.•Presence of Fe3O4 provides excellent regeneration capability with high stability.•High selectivities of 91 % and 88 % for MB and Rh B, respectively, with rapid kinetics.•MB and Rh B removal via electrostatic attraction and hydrogen bonding with MXene.
PDF
