Nematic order is the breaking of rotational symmetry in the presence of translational invariance. While originally defined in the context of liquid crystals, the concept of nematic order has arisen ...in crystalline matter with discrete rotational symmetry, most prominently in the tetragonal Fe-based superconductors where the parent state is four-fold symmetric. In this case the nematic director takes on only two directions, and the order parameter in such ‘Ising-nematic’ systems is a simple scalar. Here, using a spatially resolved optical polarimetry technique, we show that a qualitatively distinct nematic state arises in the triangular lattice antiferromagnet Fe1/3NbS2. The crucial difference is that the nematic order on the triangular lattice is a Z3 or three-state Potts-nematic order parameter. As a consequence, the anisotropy axes of response functions such as the resistivity tensor can be continuously reoriented by external perturbations. This discovery lays the groundwork for devices that exploit analogies with nematic liquid crystals.A spatially resolved optical polarimetry technique is used to identify a three-state Potts-nematic order parameter in a triangular lattice antiferromagnetic material.
Soft and conformable wearable electronics require stretchable semiconductors, but existing ones typically sacrifice charge transport mobility to achieve stretchability. We explore a concept based on ...the nanoconfinement of polymers to substantially improve the stretchability of polymer semiconductors, without affecting charge transport mobility. The increased polymer chain dynamics under nanoconfinement significantly reduces the modulus of the conjugated polymer and largely delays the onset of crack formation under strain. As a result, our fabricated semiconducting film can be stretched up to 100% strain without affecting mobility, retaining values comparable to that of amorphous silicon. The fully stretchable transistors exhibit high biaxial stretchability with minimal change in on current even when poked with a sharp object. We demonstrate a skinlike finger-wearable driver for a light-emitting diode.
Organic transistors with elastic conductors and dielectrics can be stretched up to 250% strain while maintaining the transistor characteristics. Strain‐independent properties can be achieved after an ...initial “programming” cycle that causes the formation of microcracks in the semiconductor. The change in mobility with strain follows the same trend in different stretching directions.
Carbon capture and sequestration from point sources is an important component in the CO2 emission mitigation portfolio. In particular, sorbents with both high capacity and selectivity are required ...for reducing the cost of carbon capture. Although physisorbents have the advantage of low energy consumption for regeneration, it remains a challenge to obtain both high capacity and sufficient CO2/N2 selectivity at the same time. Here, we report the controlled synthesis of a novel N-doped hierarchical carbon that exhibits record-high Henry’s law CO2/N2 selectivity among physisorptive carbons while having a high CO2 adsorption capacity. Specifically, our synthesis involves the rational design of a modified pyrrole molecule that can co-assemble with the soft Pluronic template via hydrogen bonding and electrostatic interactions to give rise to mesopores followed by carbonization. The low-temperature carbonization and activation processes allow for the development of ultrasmall pores (d < 0.5 nm) and preservation of nitrogen moieties, essential for enhanced CO2 affinity. Furthermore, our described work provides a strategy to initiate developments of rationally designed porous conjugated polymer structures and carbon-based materials for various potential applications.
The alignment of organic semiconductors (OSCs) in the active layers of electronic devices can confer desirable properties, such as enhanced charge transport properties due to better ordering, charge ...transport anisotropy for reduced device cross-talk, and polarized light emission or absorption. The solution-based deposition of highly aligned small molecule OSCs has been widely demonstrated, but the alignment of polymeric OSCs in thin films deposited directly from solution has typically required surface templating or complex pre- or postdeposition processing. Therefore, single-step solution processing and the charge transport enhancement afforded by alignment continue to be attractive. We report here the use of solution shearing to tune the degree of alignment in poly(diketopyrrolopyrrole-terthiophene) thin films by controlling the coating speed. A maximum dichroic ratio of ∼7 was achieved on unpatterned substrates without any additional pre- or postdeposition processing. The degree of polymer alignment was found to be a competition between the shear alignment of polymer chains in solution and the complex thin film drying process. Contrary to previous reports, no charge transport anisotropy was observed because of the small crystallite size relative to the channel length, a meshlike morphology, and the likelihood of increased grain boundaries in the direction transverse to coating. In fact, the lack of aligned morphological structures, coupled with observed anisotropy in X-ray diffraction data, suggests the alignment of polymer molecules in both the crystalline and the amorphous regions of the films. The shear speed at which maximum dichroism is achieved can be controlled by altering deposition parameters such as temperature and substrate treatment. Modest changes in molecular weight showed negligible effects on alignment, while longer polymer alkyl side chains were found to reduce the degree of alignment. This work demonstrates that solution shearing can be used to tune polymer alignment in a one-step deposition process not requiring substrate patterning or any postdeposition treatment.
Reiner et al provide a biochemical analysis of single nanopore-based sensors and their role in disease detection and management. Solid-state nanopore-based sensors could potentially be used in ...biomimicry.
Stretchable form factors enable electronic devices to conform to irregular 3D structures, including soft and moving entities. Intrinsically stretchable devices have potential advantages of high ...surface coverage of active devices, improved durability, and reduced processing costs. This work describes intrinsically stretchable transistors composed of single-walled carbon nanotube (SWNT) electrodes and semiconductors and a dielectric that consists of a nonpolar elastomer. The use of a nonpolar elastomer dielectric enabled hysteresis-free device characteristics. Compared to devices on SiO2 dielectrics, stretchable devices with nonpolar dielectrics showed lower mobility in ambient conditions because of the absence of doping from water. The effect of a SWNT band gap on device characteristics was investigated by using different SWNT sources as the semiconductor. Large-band-gap SWNTs exhibited trap-limited behavior caused by the low capacitance of the dielectric. In contrast, high-current devices based on SWNTs with smaller band gaps were more limited by contact resistance. Of the tested SWNT sources, SWNTs with a maximum diameter of 1.5 nm performed the best, with a mobility of 15.4 cm2/Vs and an on/off ratio >103 for stretchable transistors. Large-band-gap devices showed increased sensitivity to strain because of a pronounced dependence on the dielectric thickness, whereas contact-limited devices showed substantially less strain dependence.
Aim
Exposure to road traffic and air pollution may be a trigger of acute myocardial infarction, but the individual pollutants responsible for this effect have not been established. We assess the role ...of combustion-derived-nanoparticles in mediating the adverse cardiovascular effects of air pollution.
Methods and results
To determine the in vivo effects of inhalation of diesel exhaust components, 16 healthy volunteers were exposed to (i) dilute diesel exhaust, (ii) pure carbon nanoparticulate, (iii) filtered diesel exhaust, or (iv) filtered air, in a randomized double blind cross-over study. Following each exposure, forearm blood flow was measured during intra-brachial bradykinin, acetylcholine, sodium nitroprusside, and verapamil infusions. Compared with filtered air, inhalation of diesel exhaust increased systolic blood pressure (145 ± 4 vs. 133 ± 3 mmHg, P< 0.05) and attenuated vasodilatation to bradykinin (P= 0.005), acetylcholine (P= 0.008), and sodium nitroprusside (P< 0.001). Exposure to pure carbon nanoparticulate or filtered exhaust had no effect on endothelium-dependent or -independent vasodilatation. To determine the direct vascular effects of nanoparticulate, isolated rat aortic rings (n= 6-9 per group) were assessed in vitro by wire myography and exposed to diesel exhaust particulate, pure carbon nanoparticulate and vehicle. Compared with vehicle, diesel exhaust particulate (but not pure carbon nanoparticulate) attenuated both acetylcholine (P< 0.001) and sodium-nitroprusside (P= 0.019)-induced vasorelaxation. These effects were partially attributable to both soluble and insoluble components of the particulate.
Conclusion
Combustion-derived nanoparticulate appears to predominately mediate the adverse vascular effects of diesel exhaust inhalation. This provides a rationale for testing environmental health interventions targeted at reducing traffic-derived particulate emissions.
Selective extraction of semiconducting carbon nanotubes is a key step in the production of high-performance, solution-processed electronics. Here, we describe the ability of a supramolecular sorting ...polymer to selectively disperse semiconducting carbon nanotubes from five commercial sources with diameters ranging from 0.7 to 2.2 nm. The sorting purity of the largest-diameter nanotubes (1.4 to 2.2 nm; from Tuball) was confirmed by short channel measurements to be 97.5%. Removing the sorting polymer by acid-induced disassembly increased the transistor mobility by 94 and 24% for medium-diameter and large-diameter carbon nanotubes, respectively. Among the tested single-walled nanotube sources, the highest transistor performance of 61 cm2/V·s and on/off ratio >104 were realized with arc discharge carbon nanotubes with a diameter range from 1.2 to 1.7 nm. The length and quality of nanotubes sorted from different sources is compared using measurements from atomic force microscopy and Raman spectroscopy. The transistor mobility is found to correlate with the G/D ratio extracted from the Raman spectra.
Hydrogen peroxide (H2O2), an important industrial chemical, is currently produced through an energy-intensive anthraquinone process that is limited to large-scale facilities. Small-scale ...decentralized electrochemical production of H2O2 via a two-electron oxygen reduction reaction (ORR) offers unique opportunities for sanitization applications and the purification of drinking water. The development of inexpensive, efficient, and selective catalysts for this reaction remains a challenge. Herein, we examine two different porous carbon-based electrocatalysts and show that they exhibit high selectivity for H2O2 under alkaline conditions. By rationally varying synthetic methods, we explore the effect of pore size on electrocatalytic performance. Furthermore, by means of density functional calculations, we point out the critical role of carbon defects. Our theory results show that the majority of defects in graphene are naturally selective for the two-electron reduction of O2 to H2O2, and we identify the types of defects with high activity.
PDF
