Small-diameter (ca. 0.7 nm) single-wall carbon nanotubes are predicted to display enhanced reactivity relative to larger-diameter nanotubes due to increased curvature strain. The derivatization of ...these small-diameter nanotubes via electrochemical reduction of a variety of aryl diazonium salts is described. The estimated degree of functionalization is as high as one out of every 20 carbons in the nanotubes bearing a functionalized moiety. The functionalizing moieties can be removed by heating in an argon atmosphere. Nanotubes derivatized with a 4-tert-butylbenzene moiety were found to possess significantly improved solubility in organic solvents. Functionalization of the nanotubes with a molecular system that has exhibited switching and memory behavior is shown. This represents the marriage of wire-like nanotubes with molecular electronic devices.
We tracked over time the conductance switching of single and bundled phenylene ethynylene oligomers isolated in matrices of alkanethiolate monolayers. The persistence times for isolated and bundled ...molecules in either the ON or OFF switch state range from seconds to tens of hours. When the surrounding matrix is well ordered, the rate at which the inserted molecules switch is low. Conversely, when the surrounding matrix is poorly ordered, the inserted molecules switch more often. We conclude that the switching is a result of conformational changes in the molecules or bundles, rather than electrostatic effects of charge transfer.
Molecular electronics involves the use of single or small packets of molecules as the fundamental units for computing. While initial targets are the substitution of solid-state wires and devices with ...molecules, long-range goals involve the development of novel addressable electronic properties from molecules. A comparison of traditional solid-state devices to molecular systems is described. Issues of cost and ease of manufacture are outlined, along with the syntheses and testing of molecular wires and devices.
In single-molecule transistors, we observe inelastic cotunneling features that correspond energetically to vibrational excitations of the molecule, as determined by Raman and infrared spectroscopy. ...This is a form of inelastic electron tunneling spectroscopy of single molecules, with the transistor geometry allowing in situ tuning of the electronic states via a gate electrode. The vibrational features shift and change shape as the electronic levels are tuned near resonance, indicating significant modification of the vibrational states. When the molecule contains an unpaired electron, we also observe vibrational satellite features around the Kondo resonance.
The usefulness of graphene for electronics has been limited because it does not have an energy bandgap. Although graphene nanoribbons have non-zero bandgaps, lithographic fabrication methods ...introduce defects that decouple the bandgap from electronic properties, compromising performance. Here we report direct measurements of a large intrinsic energy bandgap of approximately 50 meV in nanoribbons (width, approximately 100 nm) fabricated by high-temperature hydrogen-annealing of unzipped carbon nanotubes. The thermal energy required to promote a charge to the conduction band (the activation energy) is measured to be seven times greater than in lithographically defined nanoribbons, and is close to the width of the voltage range over which differential conductance is zero (the transport gap). This similarity suggests that the activation energy is in fact the intrinsic energy bandgap. High-resolution transmission electron and Raman microscopy, in combination with an absence of hopping conductance and stochastic charging effects, suggest a low defect density.
A molecule containing a nitroamine redox center (2′-amino-4-ethynylphenyl-4′-ethynylphenyl-5′-nitro-1-benzenethiol) was used in the active self-assembled monolayer in an electronic device. ...Current-voltage measurements of the device exhibited negative differential resistance and an on-off peak-to-valley ratio in excess of 1000:1.
Conductance of a Molecular Junction Reed, M. A.; Zhou, C.; Muller, C. J. ...
Science (American Association for the Advancement of Science),
10/1997, Letnik:
278, Številka:
5336
Journal Article
Recenzirano
Molecules of benzene-1,4-dithiol were self-assembled onto the two facing gold electrodes of a mechanically controllable break junction to form a statically stable gold-sulfur-aryl-sulfur-gold system, ...allowing for direct observation of charge transport through the molecules. Current-voltage measurements at room temperature demonstrated a highly reproducible apparent gap at about 0.7 volt, and the conductance-voltage curve showed two steps in both bias directions. This study provides a quantative measure of the conductance of a junction containing a single molecule, which is a fundamental step in the emerging area of molecular-scale electronics.
Two types of graphene nanoribbons: (a) potassium-split graphene nanoribbons (GNRs), and (b) oxidative unzipped and chemically converted graphene nanoribbons (CCGNRs) were investigated for their ...magnetic properties using the combination of static magnetization and electron spin resonance measurements. The two types of ribbons possess remarkably different magnetic properties. While a low-temperature ferromagnet-like feature is observed in both types of ribbons, such room-temperature feature persists only in potassium-split ribbons. The GNRs show negative exchange bias, but the CCGNRs exhibit a “positive exchange bias”. Electron spin resonance measurements suggest that the carbon-related defects may be responsible for the observed magnetic behavior in both types of ribbons. Furthermore, information on the proton hyperfine coupling strength has been obtained from hyperfine sublevel correlation experiments performed on the GNRs. Electron spin resonance finds no evidence for the presence of potassium (cluster) related signals, pointing to the intrinsic magnetic nature of the ribbons. Our combined experimental results may indicate the coexistence of ferromagnetic clusters with antiferromagnetic regions leading to disordered magnetic phase. We discuss the possible origin of the observed contrast in the magnetic behaviors of the two types of ribbons studied.
We have studied charge injection across the metal/organic semiconductor interface in bottom-contact poly(3-hexylthiophene) (P3HT) field-effect transistors, with Au source and drain electrodes ...modified by self-assembled monolayers (SAMs) prior to active polymer deposition. By using the SAM to engineer the effective Au work function, we markedly affect the charge injection process. We systematically examine the contact resistivity and intrinsic channel mobility and show that chemically increasing the injecting electrode work function significantly improves hole injection relative to untreated Au electrodes.