Erbium: Yttrium‐aluminum‐garnet laser (Er: YAG) treatment has been used in resurfacing the acne scars for a long time; however, we could not find any study reporting the recovery rates after each ...session of the treatment. In this study, we aimed to report the improvement rates after each session. We retrospectively analyzed the data of 35 patients with acne scars treated with fractional ablative Er: YAG laser. The patients received one to four sessions of treatment with 4‐week intervals and improvement rates were recorded after each session. Data are available on request from the authors. The improvement rate of the lesions varied between 1% and 25% in 34 patients at the end of the first session, while in one patient, the improvement rate was detected as 26% to 50%. At the end of the fourth session, the rate of improvement was 26% to 50% in 14 out of 24 patients and 51% to 75% in 10 patients. None of the patients showed a 76% to 100% improvement at the end of the fourth session, whereas 48.6% of the patients were satisfied with the treatment. In patients with a high expectation of an excellent improvement, a higher number of sessions of the laser treatment and/or combination treatments with different treatment methods should be planned.
Macular amyloidosis (MA) is one of the most common types of primary localized cutaneous amyloidosis (PLCA), distributed predominantly over the trunk and extremities. Due to the vast therapeutic ...options, this study aims to compare the effectiveness of Q-switched Nd: YAG laser 1064 nm and Er: YAG laser 2940 nm in treating MA. This clinical trial was performed in 2020–2021 on 33 women with MA. In each patient, the lesion was randomly divided into two areas, A and B. Area A underwent four treatment sessions with 4-week intervals of Q-switched Nd: YAG laser 1064 nm. Area B underwent four treatment sessions with an Er: YAG laser 2940 nm at 4-week intervals. Degree of basal pigmentation and degree of pigmentation after treatment, pruritus intensity, before and after the treatment, and patient and physicians’ satisfaction were measured and compared. The pruritus in patients improved significantly after the study (
P
< 0.001), but no significant differences could be observed between the two groups regarding the improvements (
P
> 0.05). We also found no significant differences between the two groups of patients regarding patient and physicians’ satisfaction rates (
P
> 0.05). The use of both Q-switched Nd: YAG laser and Er: YAG laser resulted in improvements in terms of pruritus, patient and physicians’ satisfaction, and total improvement in pigmentation of the lesions.
Melasma is a chronic hyperpigmentation disorder. Although several treatment methods are used for patients, it remains a challenging problem for physicians. Erbium-YAG laser is one of the laser ...treatment methods that proved its efficacy in melasma treatment. We aimed to compare the efficacy of combining the fractional Er: YAG laser and Kligman’s formula with Kligman’s formula alone in the treatment of melasma. Twenty female patients with bilateral melasma were randomly treated in a split-face controlled manner with a fractional Er: YAG laser followed by Kligman’s formula on one side and Kligman’s formula on the other side. All patients received three laser sessions with four-week intervals. The efficacy of treatments was determined through photographs, Visioface, and Melasma Area Severity Index (MASI) score, all performed at baseline and three months after the end of laser sessions. Fractional Er: YAG laser and Kligman’s formula showed a significant decrease in MASI score than Kligman’s formula alone (
P
= 0.005). There was a significant decrease in cheek Visioface score on Er: YAG laser and Kligman’s formula vs Kligman’s formula (
P
= 0.02). However, the Patient Global Assessment Scale of both sides was not statistically significant (
P
= 0.23). The combination of Fractional Er: YAG laser with Kligman’s formula is an effective treatment method for melasma.
The erbium-doped yttrium aluminum garnet (Er: YAG) laser has been successfully applied in caries removal; however, little is known about proper parameters of Er: YAG laser on different conditions of ...caries removal, especially the influence of Er: YAG irradiation on human dental pulp cells (hDPCs). Here, we tested the effects of Er: YAG laser at different output energy levels (100, 200, 300, 400, and 500 mJ) on biobehaviors of hDPCs. To simulate clinical deep caries conditions, hDPCs were cultured on the pulpal side of 500-μm-thick dentin disks in an in vitro pulp chamber model. Temperature change, structural change, and ablation depth of dentin disk were also recorded. The findings suggested that the biological behaviors of hDPCs are strongly correlated with the energy output of the Er: YAG laser. Er: YAG laser irradiation at 100 mJ may be proper and safe for deep caries removal since it would not cause any adverse effect on hDPCs biobehaviors.
Background: Recently, the defects of the tooth surface in the cervical region are often restored using composite filling materials. It should meet the needs of the patients regarding esthetics and ...material stability. The aim of the study was to analyze the tooth root surface at the cervical region after the removal of the composite filling material by means of the Erbium-doped Yttrium Aluminium Garnet (Er: YAG) laser or drill using the scanning electron microscopy (SEM) and fluorescence microscopy. Materials and Methods: For the purposes of this study, 14 premolar teeth (n = 14) were removed due to orthodontic reasons. The rectangular shape cavities with 3 mm in width and 1.5 mm in height were prepared with a 0.8 mm bur on high-speed contra-angle in the tooth surface just below cemento-enamel junction (CEJ) and filled with the composite material. The composite material was removed with the Er: YAG laser at a power of 3.4 W, energy 170 mJ, frequency 20 Hz, pulse duration 300 μs, tip diameter 0.8 mm, air/fluid cooling 3 mL/s, and time of irradiation: 6 sec, at a distance from teeth of 2 mm (G1 group, n = 7) or a high-speed contra-angle bur (G2 group, n = 7). After the removal of composite material, the surfaces of teeth were examined using the scanning electron microscopy (SEM) and fluorescence microscopy. Results: The Er: YAG irradiation allowed to remove completely the composite material from the tooth cavity. The study confirmed, that the ends of collagen fibers were only partially denatured after the Er: YAG laser application. Conclusion: It has been proved that using the Er: YAG laser is an effective and safe method of composite removal for the dentin surface.
The aim of this study is to evaluate changes in vaginal pH and epithelium maturation after erbium-doped yttrium aluminum garnet (Er-YAG) laser treatment, and to assess its safety and efficacy on the ...symptoms of genitourinary syndrome of menopause (GSM). This was a retrospective study conducted between November 2019 and April 2022 and included 32 women diagnosed with GSM who had not benefitted from lubrication treatment and could not or would not use estrogen. Patients received three sessions of Er- YAG laser. All patient data before and after treatment were obtained from computer records. Vaginal maturation index (VMI), maturation value (MV) and vaginal pH values of the patients before and after laser treatment were compared. We also evaluated post-procedural complications and symptoms. Mean age was 59.72 ± 5.66 years. After laser therapy, there was a significant decrease in vaginal pH (
p
< 0.001) and the proportion of parabasal cells in VMI (
p
< 0.001), while there was a significant increase in MV (
p
< 0.001) and the proportion of superficial cells in VMI (
p
< 0.001). In 84.4% of the patients, GSM-related symptoms regressed completely or decreased to a tolerable level. Patients in which symptoms disappeared completely had significantly lower mean age (p = 0.002) and duration of menopause (p = 0.009). The laser procedure resulted in complications including mucosal injury in 5 (15.6%) patients (all recovered spontaneously) and vaginal burning sensation in 2 (6.3%) patients. Vaginal Er-YAG laser treatment may be a safe and effective alternative treatment method in a population of women with GSM who do not want to or cannot use estrogen therapy.
All-ceramic restorations are widely used in oral restoration because of their beauty and high strength. Glass ceramics and zirconia all-ceramic materials are the two most widely used all-ceramic ...materials in the clinic. However, when all-ceramic restorations need to be removed due to marginal microleakage and secondary caries, its high strength and high bonding strength greatly increase the difficulty of removal. In recent years, clinicians have tried to use Er: YAG lasers to remove all-ceramic restorations. The Er: YAG laser can be safely and efficiently applied to the removal of glass restorations, and it can also play a role in thinner zirconia restorations. Various factors, such as the material and thickness of the all-ceramic restoration, the type of cement, and the laser power, can affect the speed of removal of the Er: YAG laser. However, the current research is limited to case reports and in vitro studies, lacking systematic clinical research. The specific mechanism of Er: YAG laser removal of all-cer
To examine the micro tensile bond strength (μTBS) and the resin-dentin interface on a laser-irradiated dentin surface using two different irradiation methods, with or without additional low-energy ...irradiation.
The flat bovine dentin surface was divided into three groups: i). control group (C group, no irradiation), ii) 80 mJ/pulse Er: YAG laser group (80 group), iii) 80 + 30 mJ/pulse Er: YAG laser group (80 + 30 group, with an additional 30 mJ/pulse). After the roughness of the dentin surface was recorded, Clearfil SE Bond 2 or Clearfil Universal Bond Quick (Kuraray Noritake Dental Inc., Tokyo, Japan) was applied. After the μTBS testing, the failure mode was observed. The bonded interface was assessed using Rhodamine-dye incorporated adhesives and observed by optical coherence tomography.
The dentin surface showed opened dentinal tubules without a smear layer after irradiation. For both adhesives, the μTBS was significantly higher in 80 + 30 group than in the 80 group (p < 0.05). In the 80 group, the thickness of the adhesive layer was not uniform, and the dentin surface was occasionally in direct contact with the composite resin. The failure mode images showed that most of the fractures in the 80 group were at the sub-surface of irradiated dentin. The adhesive layers of the 80 + 30 groups were homogeneous.
The dentin surface was rough and irregular by 80 mJ irradiation, which might result in an inadequate resin-dentin interface and the weak μTBS. The bonded integrity was mitigated by additional irradiation.
•The 80 mJ Er:YAG laser treatment decreases the resin-dentin bond strength.•Additional irradiation with a low-power Er:YAG laser of 30 mJ improves the resin-dentin bond strength.•Additional low-power laser irradiation improves the bond strength regardless of 2-step or 1-step self-etching adhesives.
PDF
