E-viri
Recenzirano
Odprti dostop
-
HABRMAN, MARTIN; CHVAL, ZDENEK; RAZ, KAREL; STREIT, PHILIPP; STUEMPFL, DOMINIK
MM Science Journal, 10/2022, Letnik: 2022, Številka: 3Journal Article
This article deals with the injection moulding into the plastic mould. This is an unconventional approach to injection moulding, especially because the 3D printing is used to produce the mould. The mould with the same shape was made of a conventional material (aluminium) for comparison. The properties of the plastic mould were then compared to the aluminium mould. The flash was seen as the main shortcoming. The modifications of the mould were suggested in two variants, one of them was implemented. The advantage of the flash solution was described. Finally, other solution options were summarized based on the performed testing.
Vnos na polico
Trajna povezava
- URL:
Faktor vpliva
Dostop do baze podatkov JCR je dovoljen samo uporabnikom iz Slovenije. Vaš trenutni IP-naslov ni na seznamu dovoljenih za dostop, zato je potrebna avtentikacija z ustreznim računom AAI.
Leto | Faktor vpliva | Izdaja | Kategorija | Razvrstitev | ||||
---|---|---|---|---|---|---|---|---|
JCR | SNIP | JCR | SNIP | JCR | SNIP | JCR | SNIP |
Baze podatkov, v katerih je revija indeksirana
Ime baze podatkov | Področje | Leto |
---|
Povezave do osebnih bibliografij avtorjev | Povezave do podatkov o raziskovalcih v sistemu SICRIS |
---|
Vir: Osebne bibliografije
in: SICRIS
To gradivo vam je dostopno v celotnem besedilu. Če kljub temu želite naročiti gradivo, kliknite gumb Nadaljuj.