E-viri
Recenzirano
Odprti dostop
-
Uheida, E. H.; Oosthuizen, G. A.; Dimitrov, D. M.; Bezuidenhout, M. B.; Hugo, P. A.
International journal of advanced manufacturing technology, 06/2018, Letnik: 96, Številka: 9-12Journal Article
The effects of tool rotation direction during single point incremental forming of pure titanium were experimentally studied. Axisymmetric components with a varying wall angle were formed using a round-tipped tool of 10 mm diameter and following a 3D spiral tool path. Test runs were executed by changing one factor at a time. Spindle rotation was tested in both the climb and the conventional directions. Tool step depth between runs was increased by a fixed interval over the range of 0.35 mm up to the plate thickness of 0.8 mm. The experimental results obtained by a comparison between the two forming strategies and their impact on the characteristics of formability are discussed in this paper. The achieved level of the forming angle (75 ° ), and the reduction in geometric deviations from the conventional strategy, presents interesting findings. Considerable variations in the trends of forces and temperature between the two forming strategies are presented and discussed.
Vnos na polico
Trajna povezava
- URL:
Faktor vpliva
Dostop do baze podatkov JCR je dovoljen samo uporabnikom iz Slovenije. Vaš trenutni IP-naslov ni na seznamu dovoljenih za dostop, zato je potrebna avtentikacija z ustreznim računom AAI.
Leto | Faktor vpliva | Izdaja | Kategorija | Razvrstitev | ||||
---|---|---|---|---|---|---|---|---|
JCR | SNIP | JCR | SNIP | JCR | SNIP | JCR | SNIP |
Baze podatkov, v katerih je revija indeksirana
Ime baze podatkov | Področje | Leto |
---|
Povezave do osebnih bibliografij avtorjev | Povezave do podatkov o raziskovalcih v sistemu SICRIS |
---|
Vir: Osebne bibliografije
in: SICRIS
To gradivo vam je dostopno v celotnem besedilu. Če kljub temu želite naročiti gradivo, kliknite gumb Nadaljuj.