E-viri
Recenzirano
Odprti dostop
-
Zhang, Lulu; Wang, Fangying; Liang, Yating; Zhao, Ou
Engineering structures, 12/2019, Letnik: 201Journal Article
•Material responses and compression capacities of press-braked S690 angle and channel section stub columns were studied.•Thirty-six tensile flat and corner coupon tests on press-braked S690 angle and channel sections were conducted.•A total of twenty-four press-braked S690 angle and channel section stub columns were tested.•Numerical models were developed and validated against test results, and then used to perform parametric studies.•Current design codes and direct strength method were assessed against test and numerical results. This paper reports an experimental and numerical investigation into the cross-section behaviour and compression resistances of press-braked S690 high strength steel angle and channel section stub columns. The experimental study was carried out on four equal-leg angle sections and eight plain channel sections with a range of cross-section sizes (covering both non-slender and slender sections), and included thirty-six material tensile flat and corner coupon tests, initial local geometric imperfection measurements and twenty-four concentrically loaded stub column tests. The experimental study was then supplemented by a numerical modelling programme, where numerical models were firstly developed to simulate the test structural responses and subsequently adopted to derive further numerical data. The experimentally and numerically derived results were utilised to assess the applicability of the Eurocode Class 3 slenderness limits for hot-rolled and welded sections to their cold-formed (press-braked) counterparts. The results of the assessment generally revealed that the Eurocode Class 3 slenderness limits for hot-rolled and welded sections can be safely adopted for the classification of press-braked (cold-formed) S690 high strength steel angle and channel sections subjected to compression. The accuracy of the codified design provisions established in Europe, North America and Australia/New Zealand as well as the direct strength method (DSM) to the design of press-braked S690 high strength steel angle and channel section stub columns was also assessed, based on the test data and numerical results. The North American, Australian and New Zealand standards were found to result in accurate and consistent compression capacity predictions for press-braked S690 high strength steel channel section and non-slender angle section stub columns, but greatly underestimate the compression capacities for those slender angle section stub columns, while the European code and DSM were shown to yield overall precise and consistent design compression capacities.
![loading ... loading ...](themes/default/img/ajax-loading.gif)
Vnos na polico
Trajna povezava
- URL:
Faktor vpliva
Dostop do baze podatkov JCR je dovoljen samo uporabnikom iz Slovenije. Vaš trenutni IP-naslov ni na seznamu dovoljenih za dostop, zato je potrebna avtentikacija z ustreznim računom AAI.
Leto | Faktor vpliva | Izdaja | Kategorija | Razvrstitev | ||||
---|---|---|---|---|---|---|---|---|
JCR | SNIP | JCR | SNIP | JCR | SNIP | JCR | SNIP |
Baze podatkov, v katerih je revija indeksirana
Ime baze podatkov | Področje | Leto |
---|
Povezave do osebnih bibliografij avtorjev | Povezave do podatkov o raziskovalcih v sistemu SICRIS |
---|
Vir: Osebne bibliografije
in: SICRIS
To gradivo vam je dostopno v celotnem besedilu. Če kljub temu želite naročiti gradivo, kliknite gumb Nadaljuj.