ALL libraries (COBIB.SI union bibliographic/catalogue database)
13.
Analysis of high-speed milling dynamics: chatter vs. chatter-free cutting
Grabec, Igor ...
Dynamics of high-speed full-immersion milling are investigated on the basis of recorded time series of tool displacements. Using axial cutting depth as the control parameter, dynamically different ...milling regimes are achieved. In the article, the regimes corresponding to chatter-free milling and chatter are analyzed and compared. It is shown that the tool motion is periodic during chatter-free milling, and approximately periodic or quasi-periodic during chatter. Based on the stroboscope sections of phase portraits of the tool motion, two methods for chatter detection are proposed.
It was not necessary to add the material to the shelf.
Bibliographic material was successfully added on shelf.
Adding bibliographical material on shelf was not successful.
Material is already on the shelf.
Permalink
URL:
Impact factor
Access to the JCR database is permitted only to users from Slovenia. Your current IP address is not on the list of IP addresses with access permission, and authentication with the relevant AAI accout is required.
Year
Impact factor
Edition
Category
Classification
JCR
SNIP
JCR
SNIP
JCR
SNIP
JCR
SNIP
Select the library membership card:
DRS,
in which the journal is indexed
Database name
Field
Year
Links to authors' personal bibliographies
Links to information on researchers in the SICRIS system
Subject headings in COBISS General List of Subject Headings
Select pickup location
The material from the parent unit is free. If the material is delivered to the pickup location from another unit, the library may charge you for this service.
