Fakulteta za strojništvo, Ljubljana (FSLJ)
  • Detection of the eroding surface in the EDM process based on the current signal in the gap
    Valentinčič, Joško ; Junkar, Mihael
    To achieve high removal rate and low electrode wear in sinking electrical discharge machining process (EDM), rough machining parameters have to be selected according to the size of the eroding ... surface. In general, the size ofthe eroding surface varies according to the depth of the machining. Thus, ithas to be determined on-line. This paper shows that the electric current signal in the gap depends on the size of the eroding surface. The significanceof the process attributes of the electric current signal is established by inductive machine learning and the general decision rules are derived. The size of the eroding surface can be detected on-line by monitoring and evaluating the electric current signal in the gap.
    Vir: International journal of advanced manufacturing technology. - ISSN 0268-3768 (Letn. 26, št. 3/4, 2006, str. 294-301)
    Vrsta gradiva - članek, sestavni del
    Leto - 2006
    Jezik - angleški
    COBISS.SI-ID - 8967963

    Povezava(-e):

    http://dx.doi.org/10.1007/s00170-004-2356-4

    Prosto dostopno samo za člane



Vnos na polico