Microstructures of the Al-Fe-Cu-X alloys prepared at various solidification rates = Mikrostruktura zlitin Al-Fe-Cu-X po različnih hitrostih strjevanja
Voděrová, Milena ...
Aluminium alloys are usually prepared with conventional casting, but rapid-solidification methods lead to the alloys with better mechanical properties or thermal stability. When an improved thermal ...stability is required, aluminium is alloyed with one or more of the elements from the group of transition metals (TM), for example, Ni, Fe, Cr or Ti. These elements are characterized by a low diffusivity and solubility in aluminium even at elevated temperatures, while Cu in an alloy forms a CuAl2 phase that enables precipitation hardening. In this work, the microstructures of the Al-7Fe-4Cu, Al-4Fe-4Cu-3Ni and Al-7Fe-4Cu-3Cr (mass fraction, w/%) alloys prepared with various solidification processes were investigated. The aim of this work was to determine the changes in the microstructure caused by the increasing solidification rate and to determine the influence of the copper present in each alloy. All the samples were prepared with single-roll melt spinning, water quenching of the melt and conventional casting. The microstructures of the alloys were studied with light and scanning electron microscopy (SEM). The phase composition was determined with X- ray diffraction (XRD). Vickers hardness (HV 5) and microhardness (HV 0.005) were measured to compare the mechanical properties of the alloys. The microstructure and the hardness of the alloys strongly depended on the solidification rate. The fine microstructure and high microhardness values obtained with melt spinning are promising for the use of these alloys in special applications at elevated temperatures.
Bibliografsko gradivo je bilo uspešno dodano na polico.
Dodajanje bibliografskega gradiva na polico ni uspelo.
Gradivo je že na polici.
Trajna povezava
URL:
Faktor vpliva
Dostop do baze podatkov JCR je dovoljen samo uporabnikom iz Slovenije. Vaš trenutni IP-naslov ni na seznamu dovoljenih za dostop, zato je potrebna avtentikacija z ustreznim računom AAI.
Leto
Faktor vpliva
Izdaja
Kategorija
Razvrstitev
JCR
SNIP
JCR
SNIP
JCR
SNIP
JCR
SNIP
Izberite knjižnično izkaznico:
Baze podatkov,
v katerih je revija indeksirana
Ime baze podatkov
Področje
Leto
Povezave do osebnih bibliografij avtorjev
Povezave do podatkov o raziskovalcih v sistemu SICRIS
Storitev za pridobivanje naslova trenutno ni dostopna, prosimo, poskusite še enkrat.
S klikom na gumb "V redu" boste potrdili zgoraj izbrano prevzemno mesto in dokončali postopek rezervacije.
S klikom na gumb "V redu" boste potrdili zgoraj izbrano prevzemno mesto in naslov za dostavo ter dokončali postopek rezervacije.
S klikom na gumb "V redu" boste potrdili zgoraj izbrani naslov za dostavo in dokončali postopek rezervacije.
Obvestilo
Trenutno je storitev za avtomatsko prijavo in rezervacijo nedostopna. Gradivo lahko rezervirate sami na portalu Biblos ali ponovno poskusite tukaj kasneje.
Citiranje
Funkcionalnost trenutno ni na voljo. Prosimo, poskusite kasneje.
Naročanje gradiva za izposojo v čitalnice
Naročanje kopij člankov
Urnik dostave gradiva z oznako DS v signaturi